GM

GM repair problems? Ask a GM repair expert now.

Ask an Expert,
Get an Answer ASAP!

Related GM Questions
I have chevy Silverado 2003 with 6.0 engine 2500hd the two
I have chevy Silverado 2003 with 6.0 engine 2500hd the two lines that go to the master cylinder from abs block rusted out changed the two line three of the four bleeders on the calipers were busted of… read more
Eric
Eric
Automotive Repair Shop Manager
N/A
35,419 satisfied customers
2000 gmc yukon denali 5.7 liter. when start up engine pedal
2000 gmc yukon denali 5.7 liter. when start up engine pedal goes to floor. can see bubbles in rear reservoir when pumping brakes with engine running. turn engine off and pump pedal couple times bubble… read more
chevygeorge
chevygeorge
ASE Certified Master Technician
49 satisfied customers
GM montana: I am bleeding the brakes on my montana and the
I am bleeding the brakes on my montana and the ports are having problems. One is rusty and stripped,the other one is somewhat damaged and doesn't seal well - the wrench hardly turns it tightly enough … read more
Jerry Newton
Jerry Newton
Vocational, Technical or Trade Scho
2,066 satisfied customers
i changed my rotors and the passenger rear caliper and now
i changed my rotors and the passenger rear caliper and now the breaks go to the floor and nothing is leaking… read more
jazzmaster
jazzmaster
LEAD AUTO TECH
Vocational, Technical or Trade Scho
1,124 satisfied customers
GM K3500: I am having trouble getting brake fluid pressure
I am having trouble getting brake fluid pressure to the rear wheels. 1998 Chev K3500 Dually. The vehicle came in with a seized front wheel and found that the L front caliper was seized. I replace both… read more
Gary
Gary
GMC Technician
Vocational, Technical or Trade Scho
1,561 satisfied customers
GM impala: i have a 2003 chevy impala with a 3.4 v6 i just
i have a 2003 chevy impala with a 3.4 v6 i just replaced the front rotors and pads and now the brakes dont work you can pump pedal many many times and it never builds up not even the rear brakes are w… read more
Gary
Gary
GMC Technician
Vocational, Technical or Trade Scho
1,561 satisfied customers
Vehicle: 2005 Chevy Tahoe, 5.3L, 2 WD, ABS. Problem: No
Vehicle: 2005 Chevy Tahoe, 5.3L, 2 WD, ABS. Problem: No brake pedal pressure. I replaced the front brake pads & rotors. After digging in, I noticed a slight leak in one of the two caliper pistons on t… read more
Gary
Gary
GMC Technician
Vocational, Technical or Trade Scho
1,561 satisfied customers
96 Safari van: runs fine..a strange problem with the brakes..mech
I have a 96 Safari van with 107,467 miles on it. It runs fine excerpt for a strange problem with the brakes. I had a qualified mech. install new rotors, calipers, pads, and at the same time replaceded… read more
Gary
Gary
GMC Technician
Vocational, Technical or Trade Scho
1,561 satisfied customers
2004 GMC: new brake pads..drivers side..passenger side..front end
2004 GMC 2500HD Duramax just finished rebuilding the independant front suspension also had the rotors turned and went to put new brake pads on on the drivers side the pads and everything fit fine on t… read more
Mark
Mark
Line Technician
Associate Degree
339 satisfied customers
GM: my truck..new brake calipers, pads..brake lines..master cylinder
I recently took my truck to a GM Goodwrench shop to have new brake calipers, pads and rotors replaced. The tech could not bleed the brake lines so they told me they needed to replace the master cylind… read more
KBB
KBB
SERVICE TECHNICIAN
Associate Degree
156 satisfied customers
2002 GMC sonoma 4x4: the right rear ABS brake is not grabbing..fronts
I have a 2002 GMC sonoma 4x4 ,the right rear ABS brake is not grabbing, stressing the other rear , fronts are working… read more
Pete
Pete
Independent Auto Technician
Vocational, Technical or Trade Scho
138 satisfied customers
1998 Gmc Sierra 1500: rotors, calipers pads and bearings..has abs)
I just replaced the rotors, calipers pads and bearings on my 1998 Gmc Sierra 1500 (has ABS) and the right front caliper bled fine. I can't get any fluid to the right front, through the brake hose or i… read more
Steve7654
Steve7654
Service Manager/ Technician
4 satisfied customers
1999 GMC: Wheel Drive..driver side..New Rotors and pads in front
i have a 1999 GMC 3500XXXXXI changed the driver side caliper because the slide sleeves were frozen. I can't get the air out of the system. Do I have to do something different because it has anti lock … read more
Jettadan1
Jettadan1
Lead mech
Some college
1,421 satisfied customers
2005 gmc envoy: master..right rotor/ caliper and front brake shoes
i have a 2005 gmc envoy that dealer told me it needed power brake booster and master cyclinder. they both were repaced. i also replaced right rotor/ caliper and front brake shoes. also had to replace … read more
Dave Nova
Dave Nova
Auto Dealership Owner
Associate Degree
34 satisfied customers
2000 oldsmobile bravada: calipers..pads..rotors..200 cars
2000 oldsmobile bravada I changed the rear calipers, pads and rotors system seems like it went dry and needs bled is there a special way of doing this I am using the old school method I have probably … read more
Triston
Triston
High School or GED
1,134 satisfied customers
yukon: changed the front brake pads..my 04..break pedal..brake light
I just changed the front brake pads on my 04 yukon, now the break pedal just goes to the floor and service brake light is on, any suggestions?… read more
Eric
Eric
Automotive Repair Shop Manager
N/A
35,419 satisfied customers
2006 GMC: front brake on the passenger side locks up/seizes..hub
I have a 2006 GMC 3500. recently the front brake on the passenger side locks up/seizes. We took off the wheel and were able to spin the hub freely but it was very hot. Could this be an ABS malfunction… read more
GM Tech (Cam)
GM Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
5,844 satisfied customers
2003 gmc yukon denali: awd..rotors..disconnected..the calipers or any
I have a 2003 gmc yukon denali awd. I just changed the front brake pads and rotors. no lines were disconnected from the calipers or any where else. i did however open the abs bleeder valve slightly to… read more
Roadside Jerry
Roadside Jerry
Auto Expert on Just Answer
Vocational, Technical or Trade Scho
2,659 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was having a terrible problem with the wheel bearings on my 98 Chevy Cavalier and I suspect that using this website saved me plenty of time and money.

Todd LRochester NY

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

GM Tech (Cam)

GM Tech (Cam)

GMC Mechanic

5,844 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Gary

Gary

GMC Technician

1,561 satisfied customers

15 years gm master tech/15 years ASE master tech

car tech

car tech

ASE Certified Technician

449 satisfied customers

25 year master tech and shop owner

Chris (aka- Moose)

Chris (aka- Moose)

GMC Technician

234 satisfied customers

16 years of experience

Paul M ASE Master

Paul M ASE Master

ASE Master Tech

187 satisfied customers

ASE Master Tech 20+ Years

Anthony

Anthony

GMC Technician

489 satisfied customers

GM Certified

Amedee

Amedee

GMC Technician

470 satisfied customers

ASE certified tech with advanced level specialist. Wisconsin certified emissions state inspector

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x