GM

GM repair problems? Ask a GM repair expert now.

Connect one-on-one with {0} who will answer your question

Related GM Questions
GM Sierra 1500: I installed a new PCM in my 2002 GMC Sierra
I installed a new PCM in my 2002 GMC Sierra 1500. It has already been flashed. When I turn the key it begins to start and then stalls out. Do I have to reset something else to allow the new PCM to wor… read more
GM Tech (Cam)
GM Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
5,844 satisfied customers
GM s 10 zr2: 2002 S10 4.3 liter new cam , new distributor,
2002 S10 4.3 liter new cam , new distributor, new rotor and cap , getting code p 300 and p0016… read more
Danny
Danny
Lead mech
Some college
1,094 satisfied customers
2005 GMC Sierra 1500: a 5.3 liter engine..temp gauge..traffic..freeway
I have a 2005 GMC Sierra 1500 with a 5.3 liter engine, my engine temp has been running hot for about three weeks now. Once the truck warms up, the temp gauge has been reading a little under/over 210, … read more
GM Tech (Cam)
GM Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
5,844 satisfied customers
Intake..engine starts and idles around 800-900 rpm untill engine warms
engine will not start when temperture is below 80 degrees, and engine is cold (also below 80 degrees). if warm there is no problems starting. engine will start when cold and below 80 degrees if i inje… read more
Pete
Pete
Automotive Diagnostic Specialist
General auto certifications
30,667 satisfied customers
My 5.3L vortec engine doesnt start immediately up..timing..20 min
For some time now my 5.3L vortec engine doesn't start immediately up. I suspect that its a timing issue becasuse most cold starts takes about three attempts, and warm starts (meaning after being off 0… read more
GM Tech (Cam)
GM Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
5,844 satisfied customers
2000 gmc: dtc p1214..rpm..I replace computer and crank sensor..module
I have 2000 gmc with disel engine 605L and I have dtc P1214 TDC offset more than 2.40 degrees i tryed adjust mechanical the pump don't work and try with scan tool and when i request scan tool said not… read more
GM Tech (Cam)
GM Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
5,844 satisfied customers
1997 gmc: 2500 4x4..warm (driven for 1/2hr or so)..acts..dead battery
I have a 1997 gmc sierra 2500 4x4 with 350 vortec. Recently the truck seems to have hard start after engine is warm (driven for 1/2hr or so). It acts like a dead battery scenerio. When starting cold i… read more
Pete
Pete
Automotive Diagnostic Specialist
General auto certifications
30,667 satisfied customers
1999 GMC Sierra 3500: gets hot..it runs great, but the security light
On my 1999 GMC Sierra 3500 It will start great when the engine is cold, but when the engine gets hot it will not start. it runs great, but the security light is on which makes me think that the proble… read more
Amedee
Amedee
GMC Technician
Vocational, Technical or Trade Scho
470 satisfied customers
2000 Impala: eng..Shuts..Will restart after cool down.
2000 Impala 3.4 L eng. Shuts off when up to operating temp. Will restart after cool down. Have replaced fuel pump, ignition switch . When it runs it it is fine, no missing or stumbling, It either runs… read more
GM Tech (Cam)
GM Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
5,844 satisfied customers
2001 Alero: liter engine..I replaced the fuel pump..town..towed back
I have a 2001 Alero (2.4 liter engine) - in July 2009 I replaced the fuel pump because the car would not start - $600 later I got my car back only to drive into town and have it not start again. This … read more
GM Tech (Cam)
GM Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
5,844 satisfied customers
deisel..485 days and the batteries went dead installed 2 new ones
durmax deisel has been in storage for 485 days and the batteries went dead installed 2 new ones the lights and radio work but it wont fire up any ideas… read more
GM Tech (Cam)
GM Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
5,844 satisfied customers
1999 Cadillac escalade: Service engine soon..cam sensor..base timing
I have a 1999 Cadillac escalade, 5.7 engine. Starts hard when cold. Service engine soon light was on and I retrieved a code indicating crank and cam sensor correlation failure.I replaced the crank and… read more
John
John
MASTER AUTOMOTIVE TECHNICIAN
2 YEARS COLLEGE
8,101 satisfied customers
2000 GMC: 93,000 miles..starts right..first start..cranking
I have a 2000 GMC Jimmy with 93,000 miles. It immediately starts right up on any cold crank -- be it the first start of the day or anytime after it has been sitting for a few hours. However, on repeat… read more
car tech
car tech
ASE Certified Technician
High School or GED
449 satisfied customers
2001 OLDSMOBILE AURORA: IM WORKING..3.5L..STARTS HARD..CRANK SENSOR
I'M WORKING ON A 2001 OLDSMOBILE AURORA WITH A 3.5L ENGINE.IT STARTS HARD SOMETIMES.IT TURNS OVER AND DOES NOT RUN.DOES THIS ENGINE HAVE CRANK SENSOR?… read more
Jim
Jim
Vocational, Technical or Trade Scho
1,491 satisfied customers
2002 gmc envoy: 4.2L..p1345..p0440..the key is still in the start pos
2002 gmc envoi 4.2L codes p1345 po340 p0440 p1514 car will start and than quit while the key is still in the start pos. On occassion if we get it to start it will run.… read more
Wicked Wrench
Wicked Wrench
Automotive Technology Instructor
Associate Degree
458 satisfied customers
2000 GMC: 4x4..Fuel pressure at the rail is 52psi and all cylinders
I have a 2000 GMC Sierra 1/2 ton 4x4, Has been running fine until today. Engine turns over and only runs on 1 or 2 cylinders for 5 seconds or less. Fuel pressure at the rail is 52psi and all cylinders… read more
BOBBYSS
BOBBYSS
Automotive Repair/Damage Investigator
Associate Degree
14,594 satisfied customers
97 gmc sonoma: turn my ignition key..dash lights..locking..sputter
from the time i turn my ignition key on i've noticed that it takes almost 10 seconds for the dash lights and whirl sound of the fuel pump to come on and will not start up until that happenes. my 97 gm… read more
mcgruder73
mcgruder73
Auto Technician
Associate Degree
1990 gmc truck: 350 tbi. it misses a little when cold and cuts..rpm
i have a 1990 gmc truck 350 tbi. it misses a little when cold and cuts out at around 4500 rpm what might be the cause of this? thank you.… read more
Anthony
Anthony
GMC Technician
Vocational, Technical or Trade Scho
489 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was having a terrible problem with the wheel bearings on my 98 Chevy Cavalier and I suspect that using this website saved me plenty of time and money.

Todd LRochester NY

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

GM Tech (Cam)

GM Tech (Cam)

GMC Mechanic

5,844 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Gary

Gary

GMC Technician

1,561 satisfied customers

15 years gm master tech/15 years ASE master tech

car tech

car tech

ASE Certified Technician

449 satisfied customers

25 year master tech and shop owner

Chris (aka- Moose)

Chris (aka- Moose)

GMC Technician

234 satisfied customers

16 years of experience

Paul M ASE Master

Paul M ASE Master

ASE Master Tech

187 satisfied customers

ASE Master Tech 20+ Years

Anthony

Anthony

GMC Technician

489 satisfied customers

GM Certified

Amedee

Amedee

GMC Technician

470 satisfied customers

ASE certified tech with advanced level specialist. Wisconsin certified emissions state inspector

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x