GM

GM repair problems? Ask a GM repair expert now.

Connect one-on-one with {0} who will answer your question

Related GM Questions
GM 1500: I am working on a 1994 chevy 1500 with 5.7 engine.
I am working on a 1994 chevy 1500 with 5.7 engine. I have code 43. I replaced spark plugs , wires, ignition module cap and rotor. I also tried a reman distributor and a reman ecm. I also replaced ect … read more
Gary
Gary
GMC Technician
Vocational, Technical or Trade Scho
1,563 satisfied customers
I have a 1993 Sierra 2500 with 5.7 TBI engine. I developed a spark knock. Not the typical
I have a 1993 Sierra 2500 with 5.7 TBI engine. I developed a spark knock. Not the typical rattle but a slow ping, ping ping, like it's maybe only in one cylinder. Icode reads 4-3. I've replaced the kn… read more
mechanic110
mechanic110
Auto Technician
Vocational, Technical or Trade Scho
135 satisfied customers
GM C1500: We have a 1994 Chevy C1500, 5.7 TBI. Truck was submerged
We have a 1994 Chevy C1500, 5.7 TBI. Truck was submerged a few hours, at least the engine was. We've got everything going again, had to change all the sensors, ingnition control module, ignition coil,… read more
Gary
Gary
GMC Technician
Vocational, Technical or Trade Scho
1,563 satisfied customers
1987 gmc: warmed..highway speeds..the check engine light comes on
I have a 1987 gmc v1500 with 305 fuel injection. My current problem seems to occur after the vehicle is warmed up and going at highway speeds. It will run and drive fine then all of a sudden the check… read more
ASEMaster35yrs
ASEMaster35yrs
Vocational, Technical or Trade Scho
2,061 satisfied customers
1989 gmc: keep going..fuel injected..knock sensor, egr, esm..electric
what would make a knock code keep going off on a 1989 GMC sirrea 2500 350 fuel injected. I have replaced the knock sensor, egr, Esm, electric part to the EGR. I have checked the plugs and regaped them… read more
ASEMaster35yrs
ASEMaster35yrs
Vocational, Technical or Trade Scho
2,061 satisfied customers
1993 suburban: TROUBLE CODE..KNOCK SENSOR .I CANT FIND IT..SHIFTING
I HAVE A 1993 SUBURBAN 4WB 5.7 LITER.I KEEP GETTING THE TROUBLE CODE 43. IT SAYS THE KNOCK SENSOR .I CANT FIND IT IN THE MANUAL .AND ONCE I FIND IT HOW DO I TEST IT.CAN THAT AFFECT SHIFTING IN THE TRA… read more
Mike S.
Mike S.
Vocational, Technical or Trade Scho
8,427 satisfied customers
1989 GMC Suburban: original owner..5.7 liter..4 wheel drive..ecm B
I am the original owner of a 1989 GMC Suburban, 5.7 liter (350 CID),XXXXX which shows current drain from ECM B, service #1227747. Would this part require programming and where would I get the instruct… read more
Pete
Pete
Automotive Diagnostic Specialist
General auto certifications
33,404 satisfied customers
1993 gmc: 4l80e..the ESC is on a bracket buy the throtle body but I
I have a 1993 gmc 3500 with 7.4 and the 4l80e Everyone says that the ESC is on a bracket buy the throtle body but I can not find it. the sticker on the door says 1992 but truck was sold in 93 where is… read more
Eric
Eric
Retired
N/A
37,686 satisfied customers
1993 gmc: vin w no start..intermitant..distributer..recently replaced
1993 gmc s 15 blazer 4.3 liter cpfi. vin w no start sometimes intermitant. distributer has been replaced timing is good computer recently replaced. when not starting it cranks over well and has spark … read more
Ironmike
Ironmike
ASE Master ,Ford Certified Master Tech
Vocational, Technical or Trade Scho
3,475 satisfied customers
1995 GMC: wheel drive..000 miles..a bad spark knock under load
I have a 1995 GMC SIERRA SLE 4-wheel drive P/U with a 5.7 Litre engine. It has ovder 215,000 miles and was running fine until it developed a bad spark knock under load. Got the codes from the data lin… read more
Mike S.
Mike S.
Vocational, Technical or Trade Scho
8,427 satisfied customers
1991 gmc: van..ecm code 43,changed dist,coil,wires,plugs..module
1991 gmc 3500 van shows ecm code 43,changed dist,coil,wires,plugs,cap&wires,module code still comes back, next step???… read more
Jerry
Jerry
Service consultant
Vocational, Technical or Trade Scho
13,108 satisfied customers
1988 GMC: pickup..the truck ran fine untill it warmed..flow
Hi, I have a 1988 GMC 1500 350 5.7 fuel injected pickup. A couple months ago the truck ran fine untill it warmed up then something started to confuse the computer as to the gas flow. The truck would s… read more
JHoop
JHoop
Owner,Technician
High School or GED
5,425 satisfied customers
1995 GMC: wires,plugs,distributor and module..injectors..trans
1995 GMC 2500 4x4 Suburban 454 engine, throttle body fuel injection,190,000miles Problem: Detonation and loss of power. Detonates at shift change with no power. Things replaced: wires,plugs,distributo… read more
John
John
MASTER AUTOMOTIVE TECHNICIAN
2 YEARS COLLEGE
9,106 satisfied customers
Crankshaft sensor,EGR,fuel pressure regulator,ECM..spark plugs..gasket
What else can I check HELP???? I've installed MAF sensor,crankshaft sensor,EGR,fuel pressure regulator,ECM and also the PROM (HYPERTECH chip).Replaced spark plugs due to being fouled out.Replaced Igni… read more
JHoop
JHoop
Owner,Technician
High School or GED
5,425 satisfied customers
1992 GMC Sierra 1500: 350 engine..garage..my truck..road and noone
I have a 1992 GMC Sierra 1500 5 speed. It had a 4.3 engine in it but we just took that out and put a 350 engine in it...we need a computer that will fit it....we talked to Chevy garage and they told u… read more
Arench
Arench
President
CT State GED w/ Honors
1,484 satisfied customers
1500 sierra: only getting 5.5 volts to the knock sensor..timing off.It
I am only getting 5.5 volts to the knock sensor on a 1993 gmc 1500 sierra so this throws the timing off.It is not the computer or distribitor .Would the prom be bad?… read more
Anthony
Anthony
GMC Technician
Vocational, Technical or Trade Scho
489 satisfied customers
1988 GMC: 000 miles on it..Coolant leaked into #7 cyl,parked truck
I have a 1988 GMC K1500 5.7 Truck has 320,000 miles on it. Coolant leaked into #7 cyl,parked truck for a year and a half or maybe more,but more than two years. Just installed a GM long block crate eng… read more
John
John
MASTER AUTOMOTIVE TECHNICIAN
2 YEARS COLLEGE
9,106 satisfied customers
1988 gmc suburban: 4x4..the o2 sencer the knock..control module
hi i have a 1988 gmc suburban 4x4 with a 350 i keep on getting a code 43 i hahe reolaced the o2 sencer the knock senser the electronic spark control module and the ignition module but the code still a… read more
Jerry
Jerry
Service consultant
Vocational, Technical or Trade Scho
13,108 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was having a terrible problem with the wheel bearings on my 98 Chevy Cavalier and I suspect that using this website saved me plenty of time and money.

Todd LRochester NY

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

GM Tech (Cam)

GM Tech (Cam)

GMC Mechanic

5,872 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Gary

Gary

GMC Technician

1,563 satisfied customers

15 years gm master tech/15 years ASE master tech

car tech

car tech

ASE Certified Technician

449 satisfied customers

25 year master tech and shop owner

Chris (aka- Moose)

Chris (aka- Moose)

GMC Technician

279 satisfied customers

16 years of experience

Paul M ASE Master

Paul M ASE Master

ASE Master Tech

187 satisfied customers

ASE Master Tech 20+ Years

Amedee

Amedee

GMC Technician

504 satisfied customers

ASE certified tech with advanced level specialist. Wisconsin certified emissions state inspector

Anthony

Anthony

GMC Technician

489 satisfied customers

GM Certified

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x