GM

GM repair problems? Ask a GM repair expert now.

Connect one-on-one with {0} who will answer your question

Related GM Questions
Heelo. I have a 2004 YUKON DENALI, which we owned since
Hello, I have a 2004 YUKON DENALI, which we owned since brand new. It has been an excellent truck, but now the transmission goes to 1st gear and then to the 3rd. We don't have 2nd or the 4th (OD). The reverse gear works ok, but it takes a few seconds longer than normal to get into the gear. However, we always had the reverse issue and after 50,000 Miles and it has been almost the same. Therefore, I don't think they slipping has much to do with the reverse issu. So, we have 163,000 Mike's on the vehicle. Could this be a fuse or relay problem or do we need to possibly re build the transmission? Thank you for your consideration to answer my question. … read more
kalamykid
kalamykid
Pactor automotive
Vocational, Technical or Trade Scho
6,156 satisfied customers
2003 yukon transmission worked perfectly befor sitting 3
2003 yukon transmission worked perfectly befor sitting 3 months put a new battery in and topped off the fluids and now my transmission slips after 2nd gear rpms rev high if i let off the gas and allow… read more
Tim\u0027s Auto Repair
Tim\u0027s Auto Repair
Mechanic
High School or GED
15,933 satisfied customers
1988 Suburban automatic transmission shift 1st and 2nd fine,
1988 Suburban automatic transmission shift 1st and 2nd fine, will not shift into 3rd or overdrive.… read more
Gary
Gary
GMC Technician
Vocational, Technical or Trade Scho
18,052 satisfied customers
GM Chevrolet 20: I have a 1992 Chevy 20 Conversion Van with
I have a 1992 Chevy 20 Conversion Van with 350 engine. The Trans while shifting into 2nd to 3rd( my guess) reved kind of high and did not shift immediately. Then seemed ok for a few days. I was pullin… read more
Randy
Randy
619 satisfied customers
GM H2 Hummer: Hello GM expert, Just bought a used Hummer
Hello GM expert, Just bought a used Hummer H2 2003 Automatic Transmission ... Engines revs when gas applied and shifts slowly and accelerates slowly unless I let off the gas and accelerate SLOWLY ... … read more
Gary
Gary
GMC Technician
Vocational, Technical or Trade Scho
18,052 satisfied customers
2002 GMC Yukon XL. 3rd gear and Drive stopped working. When
2002 GMC Yukon XL. 3rd gear and Drive stopped working. When engaged in Drive, would stop pulling once the SUV got to 20mph. 1st and 2nd gear work fine and there is no noise coming from the transmissio… read more
Gary
Gary
GMC Technician
Vocational, Technical or Trade Scho
18,052 satisfied customers
1999 GMC Envoy, shifts fine for about a half hour then gets
1999 GMC Envoy, shifts fine for about a half hour then gets stuck in 3rd gear?????????? Or I can drive it 50 minutes highway and a few back rds to buddies house, shut it off for a few minutes, then st… read more
Gary
Gary
GMC Technician
Vocational, Technical or Trade Scho
18,052 satisfied customers
GM 1500 4wdsurban surban: have 1997 gm surban 4wheel dr shifts
have 1997 gm surban 4wheel dr shifts 1 and 2 but not to 3 and odrive happend all of a suden always watch tac when driving never ever notice any varyation when in over drive on cruse control… read more
Gary
Gary
GMC Technician
Vocational, Technical or Trade Scho
18,052 satisfied customers
i just replaced the engine in a 1999 gmc yukon denalie it has
i just replaced the engine in a 1999 gmc yukon denalie it has a rebuilt transmission with less han 500 miles on it , after installing the new engine i have no 3rd or 4th gear i checked for broken wire… read more
Gary
Gary
GMC Technician
Vocational, Technical or Trade Scho
18,052 satisfied customers
GM trailblazer ext ls: i have a 2003 chevy trailblazer 4.2
i have a 2003 chevy trailblazer 4.2 v6 4x4 im having problems shifting from 3rd to 4th i can manualy shift 1st -2nd- and it revs rpms for 3rd let off gas and it seems to shift but cant get into fourth… read more
mechanic110
mechanic110
Auto Technician
Vocational, Technical or Trade Scho
135 satisfied customers
GM: Hi, Im having shifting problem on a 2004 Chevrolet Suburban
Hi, I'm having shifting problem on a 2004 Chevrolet Suburban K1500 3GNFK16Z44G143607 . The check engine came up with a code p0752 related to the solenoid A. Since the solenoid is not that expensive I … read more
Gary
Gary
GMC Technician
Vocational, Technical or Trade Scho
18,052 satisfied customers
GM Z71 (1500 Serria): I have a 2002 GMC serria Z71 4x4 with
I have a 2002 GMC serria Z71 4x4 with an automatice transmisson. Problem: When shifting from 2nd to 3rd and higher the RPM will surge up to 4000 rmps and i have to let my foot of the gas to get the tr… read more
Gary
Gary
GMC Technician
Vocational, Technical or Trade Scho
18,052 satisfied customers
my 2005 yukon xl will not advance when in drive or 3rd gear...
my 2005 yukon xl will not advance when in drive or 3rd gear... but will in 2nd and 1st and reverse. automatic transmission.… read more
Gary
Gary
GMC Technician
Vocational, Technical or Trade Scho
18,052 satisfied customers
1995 gmc: pu with a automatic trans..3rd or 4th gear..shifts fine
i have a 1995 gmc 1500 pu with a automatic trans it won,t shift into 3rd or 4th gear, 1st and 2nd shifts fine… read more
Joe  Barfield
Joe Barfield
Retired-Disabled
Master Aamco
1,312 satisfied customers
2004 Chevy Suburban 1500 LT: 2wd..park, reverse, neutral and 1st gear
I have a 2004 Chevy Suburban 1500 LT 2wd. This morning going to work, the engine icon lights up and then the transmission will only work in park, reverse, neutral and 1st gear. The manual says that th… read more
Joel
Joel
GM Journeyman technician
Associate Degree
1,603 satisfied customers
2004 2500 series: gear ratio for 1st 2nd 3rd 4th and 5th gear
what is the gear ratio for 1st 2nd 3rd 4th and 5th gear for a 2004 2500 series gm pickup with duramax engine and what is the gear ratio for 1st 2nd 3rd 4th 5th and 6th gear for a 2008 2500 series gm p… read more
goodwrench9124
goodwrench9124
Lead Tech/ Shop Leader
Vocational, Technical or Trade Scho
3,392 satisfied customers
96 suburban: hesitation..3rd gear..automatic transmission..rpms
96 suburban--hesitation in shift from 2nd to 3rd gear in automatic transmission--transmission rebuilt in 2/09--when driving get about to 20 mph then rpms elevate to around 4000-5000 with no increase i… read more
Joe  Barfield
Joe Barfield
Retired-Disabled
Master Aamco
1,312 satisfied customers
2001 Chevy: reverse..trouble starting..tight..park to start
2001 Chevy Silverado P/U....won't go into/operate in reverse...will go into/operate in drive. Is it the transmission? Recently had some trouble starting and seemed the shifter was problematic...had to… read more
GM Tech (Cam)
GM Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
5,987 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was having a terrible problem with the wheel bearings on my 98 Chevy Cavalier and I suspect that using this website saved me plenty of time and money.

Todd LRochester NY

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

GM Tech (Cam)

GM Tech (Cam)

GMC Mechanic

5,987 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Gary

Gary

GMC Technician

18,052 satisfied customers

15 years gm master tech/15 years ASE master tech

car tech

car tech

ASE Certified Technician

449 satisfied customers

25 year master tech and shop owner

Chris (aka- Moose)

Chris (aka- Moose)

GMC Technician

330 satisfied customers

24 years of experience diagnosing & repairing

Paul M ASE Master

Paul M ASE Master

ASE Master Tech

211 satisfied customers

ASE Master Tech 20+ Years

Amedee

Amedee

GMC Technician

563 satisfied customers

ASE certified tech with advanced level specialist. Wisconsin certified emissions state inspector

Anthony

Anthony

GMC Technician

489 satisfied customers

GM Certified

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x