GM

GM repair problems? Ask a GM repair expert now.

Ask an Expert,
Get an Answer ASAP!

Related GM Questions
1994 gmc 1500 stalls when put in reverse have change out iac
1994 gmc 1500 stalls when put in reverse have change out iac tps map get valve and still stalls out when put into reverse … read more
kalamykid
kalamykid
Pactor automotive
Vocational, Technical or Trade Scho
97 satisfied customers
I have a WEIRD problem that my backyard mechanic simply is
I have a WEIRD problem that my backyard mechanic simply is stumped by. My car starts FINE when it is cold, but when I do a warm start, though it starts right up, it then stalls immediately. IF I hit t… read more
BOBBYSS
BOBBYSS
TECHNICIAN/ADVISOR
Associate Degree
8,343 satisfied customers
2003 gmc sierra started in am warming up ran approx. 2
2003 gmc sierra started in am warming up ran approx. 2 minutes stalled started up would idle for a moment loose power stall replace fuse under hood start up idle try to give throttle stall out replace… read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
25 satisfied customers
GM s-15 jimmy: My 1994 s-15 jimmy revs and idles perfect in
My 1994 s-15 jimmy revs and idles perfect in park, but as soon as you start driving down the road, it lurches when you give it gas. I've changed fuel filter,tps and checked cap &rotor. I've put in gea… read more
supermechanic
supermechanic
Service consultant
Vocational, Technical or Trade Scho
10 satisfied customers
1994 GMC: litre..wheel drive..Cranks..Bang fuel tank with hammer
1994 GMC Jimmy 4.3 litre six cylinderXXXXX Cranks over; will not start. Bang fuel tank with hammer; starts straight up. I thought fuel pumps just quit or do some slowly go south. Is it clogged ventlin… read more
jazzmaster
jazzmaster
LEAD AUTO TECH
Vocational, Technical or Trade Scho
1,124 satisfied customers
4x4..cool or rainy days everything works fine until the RPMs..drops
I have a 98 Jimmy 4.3 4x4. For some time now, here is my first problem. On cool or rainy days everything works fine until the RPMs reach about 2k then drops to idle, it then goes back to 2k and falls … read more
VirtualWrench (L J)
VirtualWrench (L J)
Owner of LJ Auto Repair 37 years
Associate Degree
38 satisfied customers
1994 GMC: Idles rough and occassional stalls when shifting..reverse
1994 GMC Jimmy 4.3L with CPI. Idles rough and occassional stalls when shifting into or out of reverse. Very strong fuel smell at idle. Runs well off idle. MPG down slightly.… read more
Amedee
Amedee
GMC Technician
Vocational, Technical or Trade Scho
470 satisfied customers
1995 GMC: wheel drive..acceleration..gas pedal..new electronic egr
1995 GMC Jimmy SLT Vortac V 6,XXXXX Start up runs fine for first 5 minutes, then bucks and tack bouncing around, between 2 to 4 RPM, no pegging, acceleration up hill fine decell no problem cruise on s… read more
Dodge expert
Dodge expert
ASE MASTER TECH, REPAIR FACILITY OWNER
High School or GED
3,636 satisfied customers
1998 jimmy 4,3 slt ac on engine stalls...runs ok..slow down..50 mph
1998 jimmy 4,3 slt ac on engine stalls. ac off runs ok untill slow down at turns. some times stall at 40 to 50 mph. other times foot off throttle go 40 to 50 mph. what is wrong?… read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
25 satisfied customers
1993 gmc: dies..cranks..injectors..starter spin a fuel psi at rail
i have a 1993 gmc jimmy s15 2wheel drive w vortec engine always been good for many years and little repairs by me been having issue with truck running then just quite or start bucking when driving the… read more
Ironmike
Ironmike
ASE Master L1 performance ,Ford tech
Vocational, Technical or Trade Scho
1,773 satisfied customers
1996 gmc: stalling problem..run fine..57 lbs of pressure on fuel line.
I have a stalling problem on 1996 gmc jimmy 4 door 4.3 engine. Engine will run fine then cutoff for no reason. I have 57 lbs of pressure on fuel line.… read more
zzdaryl
zzdaryl
Lead Auto Tech
Some college and advanced training
4 satisfied customers
We have a 1998 Jimmy, V6, auto trany 4X4..cap..neutral
We have a 1998 Jimmy, V6, auto trany 4X4,. Have a remanufactored computer, new fuel pump, newer distribtor/cap. Start fine, when taken out of park or neutral, engine dies. No codes come up. Help.… read more
john
john
MASTER AUTOMOTIVE TECHNICIAN
2 YEARS COLLEGE
10 satisfied customers
..got in wont start...checkd fuel pres..it fires..tps..crank trigger
HeLp..got a 93 jimmy"w" code vortec..have read many forums and havent seen any answers that are convincing. similar but not that have answer'd completely anyones Questions; came out ..got in wont star… read more
jim
jim
Vocational, Technical or Trade Scho
702 satisfied customers
hesitates and practicaly stalls fuel presure, egr..ignition coil..tps
I Have A 95 Jimmy And on acceleration it stumbles hesitates and practicaly stalls fuel presure, egr, map,ignition coil are all goodas well as the tps if accelerator is pressed lightly it will go if pr… read more
Eric
Eric
GM service dept Shop Foreman/Lead Tech
High School or GED
615 satisfied customers
1993 GMC: oil change place..stalling and jumping..cigarette lighter
Hi, An oil change place just changed the battery in our 1993 GMC Jimmy, and now it is stalling and jumping around like a jack rabbit. Is this because they failed to put the power supply in the cigaret… read more
Roadside Jerry
Roadside Jerry
Auto Expert on Just Answer
Vocational, Technical or Trade Scho
2,659 satisfied customers
1989 gmc: jerks..35 and 45 mph with the cruise on..it warms..engaged
I have a 1989 gmc that bucks and jerks between 35 and 45 mph with the cruise on. I does it worse when cold. After it warms up a little it stops bucking but still studders a little bit with light throt… read more
GM expert tech
GM expert tech
Auto Technician
High School or GED
92 satisfied customers
1998 olds aurora: leaking..iac and the tps and took the throttle body
I have a 1998 Olds aroura. I have replaced the fuel pressure regulator, because it was leaking gas through the vaccum port. I also replaced the IAC and the TPS and took the throttle body off and clean… read more
Jay
Jay
Auto Mechanic
Vocational, Technical or Trade Scho
412 satisfied customers
stop running..fuel pump, pressure is good, and injectors ok..10 mins
I have a 98 jimmy, and about 2-3 times a week it will start and immediately stop running, and the security light will be flashing. I know problem is not in fuel pump, pressure is good, and injectors o… read more
Carhelp4u
Carhelp4u
GM Service Training
2,560 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was having a terrible problem with the wheel bearings on my 98 Chevy Cavalier and I suspect that using this website saved me plenty of time and money.

Todd LRochester NY

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

GM Tech (Cam)

GM Tech (Cam)

GMC Mechanic

5,844 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Gary

Gary

GMC Technician

1,561 satisfied customers

15 years gm master tech/15 years ASE master tech

car tech

car tech

ASE Certified Technician

449 satisfied customers

25 year master tech and shop owner

Chris (aka- Moose)

Chris (aka- Moose)

GMC Technician

234 satisfied customers

16 years of experience

Paul M ASE Master

Paul M ASE Master

ASE Master Tech

187 satisfied customers

ASE Master Tech 20+ Years

Anthony

Anthony

GMC Technician

489 satisfied customers

GM Certified

Amedee

Amedee

GMC Technician

470 satisfied customers

ASE certified tech with advanced level specialist. Wisconsin certified emissions state inspector

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x