GM

GM repair problems? Ask a GM repair expert now.

Ask an Expert,
Get an Answer ASAP!

Related GM Questions
GM Buick LeSabre: 2000 LeSabre - 3.8 - Hot soak rough start
2000 LeSabre - 3.8 - Hot soak rough start idle. I replaced CPS last year for a jumping tach issue. I replaced MAF sensor because it was throwing a code. It ran ok for a month or two. Then when restart… read more
Roy
Roy
shop foreman
Associate Degree
4,477 satisfied customers
GM Silverado 1500: I own a 2002 chevy silverdo 1500 4.3litre
I own a 2002 chevy silverdo 1500 4.3litre vortec engine. it is running horribly bad idling rough, missing then it will idle at a high rpm and eventually it shuts down. I have recently had the fuel pum… read more
Gary
Gary
GMC Technician
Vocational, Technical or Trade Scho
1,561 satisfied customers
GM Yukon: after just turning on the car, my 2001 GMC Yukon
after just turning on the car, my 2001 GMC Yukon idles rough (just below 1 RPM) when the a/c is on. Once RPMs hit 1 or higher, the idle is smooth and a/c runs good and cool. my yukon is also using oil… read more
Vladimir Grodskiy
Vladimir Grodskiy
Automotive Electrician
Vocational, Technical or Trade Scho
2,724 satisfied customers
1999 s10: starts fine..fine no rough idle bogs..few psi..mass air flow
what should fuel pressure be on 1999 s10 4.3 key on idle 2500 rpm starts fine no rough idle bogs down when you acclerate let idle 3 minutes and does not bog down fuel pressure 55psi key on key off hol… read more
jazzmaster
jazzmaster
LEAD AUTO TECH
Vocational, Technical or Trade Scho
2,323 satisfied customers
2002 safari: rebuilt..reverse..gas faster it lurches..control valve
I have a 2002 safari ext van 4.3 V6 Vortec, rebuilt 30 k ago, van has 150k miles when I start it up the past couple of weeks in reverse it kinda fluttered and had a rought idle, now the idle is so so … read more
Gary
Gary
GMC Technician
Vocational, Technical or Trade Scho
1,561 satisfied customers
97 chevy: hesitation 4.3 vortechi i..reg cab..cap..gas pedal
Loss of power and a hesitation 4.3 vortec hi i have a 97 chevy reg cab stepside 4.3 vortec with a 5 speed manual trans. it losses power when i give it gas. let me list the things done to the vehicle o… read more
GM Tech (Cam)
GM Tech (Cam)
GMC Mechanic
Vocational, Technical or Trade Scho
5,844 satisfied customers
2003 Chevy: running rough..truck ran fine..few miles..warning lights
My 2003 Chevy Silverado is running rough at idle. I changed the batteries on it yesterday and the truck ran fine for a few miles and it suddenly started running poorly at idle when I stopped at an int… read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
23,904 satisfied customers
2000 Yukon Denali: V8..tuned..smell gas..flooded and it idles rough
I have a 2000 Yukon Denali with the large V8 -- I think it is 5.6L. It was tuned up at 110K miles. When I start it cold you can smell gas like it was flooded and it idles rough. Once it warms up runs … read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
23,904 satisfied customers
1999 GMC SIERRA 1500: IDLES..NEUTRAL AND REV UP..SPARK PLUGS..INJECTOR
1999 GMC SIERRA 1500 4.3 126,000 MILES , RUNS FINE , INTERMITTENTLY IDLES REAL ROUGH WITH A/C ON IN PARK AND IN DRIVE , STUMBLES RUNS REAL RICH , PUT IN NEUTRAL AND REV UP , BLACK SMOKE COMES OUT OF E… read more
JContin
JContin
Master's Degree
187 satisfied customers
S10: it wont start but if you spray starting..run good..same thing
i have s10 it wont start but if you spray starting fkuid in it it will start an run good until you cut it off an then you have to do the same thing… read more
Gary
Gary
GMC Technician
Vocational, Technical or Trade Scho
1,561 satisfied customers
GMC: 15 Jimmy 4wd 4.3 V-6..it ran fine for about 1 minute..rough
Owner of a GMC S-15 Jimmy 4WD 4.3 V-6. Started vehicle and it ran fine for about 1 minute while I was putting something in the back. Suddenly the idle got so rough it cut off. When restarted you have … read more
car tech
car tech
ASE Certified Technician
High School or GED
449 satisfied customers
MY 97 vortec 4.3 IS RUNNING LEAN..BANK ONE BUT MY CONVERTER
MY 97 VORTEC 4.3 IS RUNNING LEAN ON BANK ONE BUT MY CONVERTER IS GLOWIN RED ON PASENGER SIDE WHAT WOULD CAUSE IT… read more
BOBBYSS
BOBBYSS
Automotive Repair/Damage Investigator
Associate Degree
14,564 satisfied customers
chevy: idle goes to about 1500 rpm then drops to 500..die..it smooths
I have a 02 chevy 1500 hd it just started recently on a cold morning it starts up idle goes to about 1500 rpm then drops to 500 almost like it's going to die, it does this for approx. 2 min then it sm… read more
Michael Moore
Michael Moore
Team leader, bumper to bumper tech.
Associate Degree
2,870 satisfied customers
2002 Yukon denali: It runs fine but it will idle..500 rpm
I have a 2002 Yukon denali. Engine size is the 6.0 . It runs fine but it will idle at a little over 500 rpm. When i work the throttle in short thrusts of the pedal it will drop below 500 rpm and then … read more
Dave Nova
Dave Nova
Auto Dealership Owner
Associate Degree
17,291 satisfied customers
2001 gmc sonoma: fuel flter fuel pressure reg..start without..vortec
i have a 2001 gmc sonoma about 2months ago it got to where i would have to turn it over about 2 or 3 times before it woud start then it would start andrun fine and it has gradually gotten worse now i … read more
Jerry Newton
Jerry Newton
Vocational, Technical or Trade Scho
5,406 satisfied customers
2002 OLDSMOBILE BRAVADA: CYLINDER..VORTEC..MILEAGE..SERVICED
I AM THE OWNER OF AN 2002 OLDSMOBILE BRAVADA WITH A 6 CYLINDER VORTEC 4200 ENGINE. MILEAGE IS BETWEEN 96,000 AND 100,000 MILES. IT HAS BEEN SERVICED REGULARLLY. HOWEVER, I SEE NO RECORED OF AIR CLEANE… read more
Michael Moore
Michael Moore
Team leader, bumper to bumper tech.
Associate Degree
2,870 satisfied customers
1998 GMC: vibration..fuel system..out, egr, tps and iac replaced, etc)
I recently asked FIXITMAN about a vibration at idle (1998 GMC Jimmy 4.3 Vortec) - no obvious problems with various systems (fuel system cleaned and checked out, egr, tps and IAC replaced, etc). He sug… read more
BOBBYSS
BOBBYSS
Automotive Repair/Damage Investigator
Associate Degree
14,564 satisfied customers
fuel system..vacuum..egr and iac motor replaced and on spec, etc..rpms
I have a 4.3 vortec low grade engine vibration which is significant at idle in gear. I have had the fuel system cleaned and checked, the vacuum system is on spec, the plugs etc. are new (engine not mi… read more
BOBBYSS
BOBBYSS
Automotive Repair/Damage Investigator
Associate Degree
14,564 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was having a terrible problem with the wheel bearings on my 98 Chevy Cavalier and I suspect that using this website saved me plenty of time and money.

Todd LRochester NY

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

GM Tech (Cam)

GM Tech (Cam)

GMC Mechanic

5,844 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Gary

Gary

GMC Technician

1,561 satisfied customers

15 years gm master tech/15 years ASE master tech

car tech

car tech

ASE Certified Technician

449 satisfied customers

25 year master tech and shop owner

Chris (aka- Moose)

Chris (aka- Moose)

GMC Technician

234 satisfied customers

16 years of experience

Paul M ASE Master

Paul M ASE Master

ASE Master Tech

187 satisfied customers

ASE Master Tech 20+ Years

Anthony

Anthony

GMC Technician

489 satisfied customers

GM Certified

Amedee

Amedee

GMC Technician

470 satisfied customers

ASE certified tech with advanced level specialist. Wisconsin certified emissions state inspector

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x