How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask John Your Own Question
John, GMC Technician
Category: GM
Satisfied Customers: 9176
Experience:  ASE MASTER TECHNICIAN/40 years experience
Type Your GM Question Here...
John is online now
A new question is answered every 9 seconds

2003 gmc yukon: fuel pump relay..gets hot..Swap relays and truck

Resolved Question:

2003 gmc yukon fuel pump relay gets hot and truck will not start. Swap relays and truck will start for a few days and same problem happens again. Replaced fuel pump. Only one connector on the 8657 relay get hot.
Submitted: 7 years ago.
Category: GM
Expert:  John replied 7 years ago.

Hello & Welcome to JA,


Did you replace the fuel sender assembly ?


Did you closely look at the harness connector terminals to the fuel sender assembly ?

Customer: replied 7 years ago.
Yes we replaced the fuel sending assembly and harness
Expert:  John replied 7 years ago.

Ok,somewhere you have a build up of high resistance.

Test the ground circuit from the under hood electrical center to G104 located

In the Engine Harness, Mounted on the rear of the left cylinder head.


Test the ground circuit from the fuel sender assembly to G110 located

In the Chassis Harness, Mounted to the front of the left front body mount.

These circuits must test at .002 ohms or lower,if not repair ground circuit.

John and 4 other GM Specialists are ready to help you