Ask Experts & Get Answers to Your Questions - ASAP
Hi and welcome to Just answer.
Initially, did you able to turn your hand wheel manually?
yes. i can turn it both ways. my machine is an entrepreneur 650.
This error is appear as soon as you power on your machine?
i load a design and when i push start to stitch the design it comes up then. pushing close does not make it reset.
Did you try to restart your machine?
Thanks for your response.
I will be honest with you, your machine now have complicated problem and that is not for user/DIY fix. There are 3 possible causes its either index sensor, index motor or main PCB and its wiring/connectors. Sensor and motor I mentioned is part of needle case/needle bar mechanism.
Either of this case/problem s not for DIY so you need to call your dealer and send your machine for repair. I am sorry to be a bearer of the bad news.
thank you. i was afraid of this!
I am sorry.
Are we good?
Don't be afraid that is not a main board problem. Very rare on this kind of problem that has main cpu base n my experience its either loose wires and connectors, sensor is most likely.
Hope this information will be helpful.
IMPORTANT: RATING IS REQUIRED!! If you are satisfied to my answer please don't forget to rate,,EXCELLENT OR GOOD rating and BONUS are greatly appreciated...
I'm just following up with you to see how everything is going. Did my answer help?
Let me know,Chester