Hi and welcome to Just answer.
Initially, The plus hoop is a multi positional hoop that allows you you to embroider designs up to 4″ x 6″. It is essential for monogramming and lettering using your Rose. The Rose hooping system is the same as the 1+, the Scandinavia 300 and 400. The designs you use must be formatted for the plus hoop. That is, the design has already been divided into two or three elements. Each element is an individual design. For instance, say the design is a long stemmed rose. It would probably be divided something like this: design
1: the flower and the top part of the stem, design
2: The middle part of the stem and the leaves, design
3: the bottom part of the stem.You would hoop up your fabric to be embroidered, attach the hoop to the machine, set the hoop to position 1, select design 1, stitch out design 1, set the hoop to position 2, select design 2, stitch out design 2, set the hoop to position 3, select design 3, stitch out design 3. You should have a complete design when you’re done and everything should match up perfectly!The hoop is divided up into three squares, 4″ x 4″. Position 1 square overlaps position 2 square and position 2 square overlaps position 3 square. This overlapping allows the designs to stitch out more smoothly.
Hope this information will be helpful.
IMPORTANT: RATING IS REQUIRED!! If you are satisfied to my answer please don't forget to rate,,EXCELLENT OR GOOD rating and BONUS are greatly appreciated...