How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask chester298 Your Own Question
chester298
chester298,
Category: General
Satisfied Customers: 792
69243481
Type Your Question Here...
chester298 is online now
A new question is answered every 9 seconds

I just cleaned my machine underneath the needle plate and

Customer Question

I just cleaned my machine underneath the needle plate and bobbin area now my machine is asking me to change my needle plate will not allow me to change stitching off a straight stitch?? It's a baby lock crescendo
Submitted: 1 year ago.
Category: General
Expert:  chester298 replied 1 year ago.

Hi and welcome to Just answer.

Initially, turn off your machine, remove your needle plate and clean it using dry cloth, on your bobbin area use compressed air or compressor and blow that area. There is possible lint/debris that block the sensor.

Let me know if still persist.

Hope this information will be helpful.

IMPORTANT: RATING IS REQUIRED!! If you are satisfied to my answer please don't forget to rate,,EXCELLENT OR GOOD rating and BONUS are greatly appreciated...

Customer: replied 1 year ago.
This did not help. Any other suggestions?
Expert:  chester298 replied 1 year ago.

Hi

I'm just following up with you to see how everything is going.

Let me know,
Chester