How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask chester298 Your Own Question
chester298
chester298,
Category: General
Satisfied Customers: 792
69243481
Type Your Question Here...
chester298 is online now
A new question is answered every 9 seconds

We have the Qult Espression 2046 machine and when the stitch

Customer Question

We have the Qult Espression 2046 machine and when the stitch length is increaed above 2.5 mm, there is a rapping sound from the rear at the needle plate, The machine works fine at a stitch length of 2.5mm. What could the problem be???
Submitted: 2 years ago.
Category: General
Expert:  chester298 replied 2 years ago.
Hi and welcome to Just answer.

Initially, try to reduce the tension then increase your stitch length. If still, try to clean your feed dog. Use old needle to remove the lint/dust in between your feed dog teeth (edge).

Just reply if you still have problem.

Hope this information will be helpful.


IMPORTANT:
RATING IS REQUIRED!! If you are satisfied to my answer please don't forget to rate,,EXCELLENT OR GOOD rating and BONUS are greatly appreciated...
Customer: replied 2 years ago.

Already tried that and the machine is still not functioning properly.

Expert:  chester298 replied 2 years ago.
Can you try to remove the presser foot and look at the mvoment of feed dog? try to increase your stitch length and see if there is still a noise and your feed dog moves freely.

Please let me know.

Chester
Customer: replied 2 years ago.

Also tried that feed dogs move freely. Still same problem

Related General Questions