Ford

Have Ford questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Ford Questions
My 2000 ford explorer rough idle only 1600 rpms .have to
My 2000 ford explorer rough idle only 1600 rpms .have to hold to floor to start has no power. Reads no codes or check engine . loading up with gas. It has rough idle. 200000 miles one owner. 4.0v6 soc… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
24,176 satisfied customers
1997 f250 hd 7.3 turbo- brake pedal is hard vacuum at the
1997 f250 hd 7.3 turbo- brake pedal is hard vacuum at the booster is 5 at idle 14 max revved up . 15 at pump 30 revved up booster holds vacuum when i pumped it . held at 10 … read more
J Hall
J Hall
retired
none
1,694 satisfied customers
Bank 2 timing marks are off, intake at 9 and exhaust at 1.
Bank 2 timing marks are off, intake at 9 and exhaust at 1. Would this cause a lean fuel trim condition?m … read more
A. Penland
A. Penland
Ford Senior Master Technician
Vocational, Technical or Trade School
8,978 satisfied customers
I havereplaved the vacuum pump and vacuum brake booster and
I havereplaved the vacuum pump and vacuum brake booster and still have hard brakes.i think I got a bad vacuum pump. While the truck is running it has 14 lbs vacuum. This is a 1995 F350 with 7.3l engin… read more
HDGENE
HDGENE
10,684 satisfied customers
Brake pedal is hard to push. If you hold constant pressure
Brake pedal is hard to push. If you hold constant pressure on the pedal you can feel the vacuum assist gradually work. The pump creates about 10 inches of vacuum, and the line holds vacuum after after… read more
camerontech
camerontech
20 year experience diagnostic technician
class a
1,923 satisfied customers
my 6.0 sound like at vacuum cleaner seems to me..air through..intake
why does my 6.0 sound like at vacuum cleaner seems to me that it is sucking too much air through the intake… read more
Repair1014U
Repair1014U
Recently Retired
Vocational, Technical or Trade Scho
707 satisfied customers
2002 taurus: run fine..600 rpms in neutral and surges when it idles
I replace the motor on my 2002 taurus with a vulcan gasoline engine. The motor I put in seemed to run fine for about 10-15 minutes but now it is running super rich (leaves a black spot on the road). I… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
24,176 satisfied customers
2004 f150: the throttle body reset the pcm it runs fine going..idling
I have a 2004 f150 that dies at low rmp like at a stoplight or backing into a parking spot i have replaced the throttle body reset the pcm it runs fine going down the road its only when idling checked… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
24,176 satisfied customers
I have a 2003 ford ranger with the following codes PO316-P2195-PO171-
I have a 2003 ford ranger with the following codes PO316-P2195-PO171- PO301-PO705-PO300. I have changed coil,wires and plugs fixed trans range sensor bvut still not running right lots of stumbling and… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
24,176 satisfied customers
99 ford taurus: the power steering pump and gear i bleed the air
99 ford taurus i have replaced the power steering pump and gear i bleed the air out of the fluid and about four days later i have air in the fluid again.… read more
Tim West
Tim West
Service Manager
Computer/ Automotive certifications
16 satisfied customers
I have a 2004 Ford F150 Heritage Edition with a 4.2 L V6 and
I have a 2004 Ford F150 Heritage Edition with a 4.2 L V6 and manual transmission. Recently the clutch became limp and eventually degraded to the point where I can't shift at all. Where should I start … read more
Chris (aka- Moose)
Chris (aka- Moose)
Ford Technician
35,835 satisfied customers
I want to put a spin on oil filter adapter from a 2004 2.3
I want to put a spin on oil filter adapter from a 2004 2.3 4cyl on a 2008 2.3 4cyl with the cannister with filter element.… read more
A. Penland
A. Penland
Ford Senior Master Technician
Vocational, Technical or Trade School
8,978 satisfied customers
2008 ford f-250: diesel truck..Oil was changed 4500miles
Just purchesed 2008 ford f-250 6.4 diesel truck. Has 50000 miles on it. Oil was changed 4500miles ago but not sure what else was done. What would you recommend doing.THANKS DOUG… read more
EMRSR
EMRSR
High School or GED
3,002 satisfied customers
1986 Ford F250: the specs..master cylinder..brake booster..faulty
What is the specs for a vacum pump on a 1986 Ford F250 6.9 L. Trying to test vacum pump after replacing several units including the master cylinder and vacum brake booster to remedy a faulty brake con… read more
ZZDaryl
ZZDaryl
Lead Auto Tech
Some college and advanced training
11,490 satisfied customers
F 350: surges..better after new power stearing gear box..right back
power stearing on a f 350 has little bind then surges both left and right . seemed better after new power stearing gear box but only for one day and then right back to surging left and right almost li… read more
Brad B
Brad B
Mechanic
Vocational, Technical or Trade School
1,091 satisfied customers
Ford: rough..the fuel sensor replaced and the intake manifold
We recently had our work truck into a Ford dealer. It's been running a bit rough, and consuming a lot of gas. We've had the fuel sensor replaced and the intake manifold, but they don't know what is wr… read more
Dennis
Dennis
Senior Master A Technician/Shop Foreman
Vocational, Technical or Trade Scho
758 satisfied customers
Mercury: a dusted motor on the compression test in inches
I would like to know what Ford consisders a dusted motor on the compression test in inches of mercury, I was told my motor measured between 7 and 8, and typically what would you normally see with a du… read more
Vincent
Vincent
Automotive Technician
High School or GED
808 satisfied customers
1999 Ford Taurus: Sedan..- 3.0 l dohc V6 engine..power steering pump
I have a 1999 Ford Taurus Sedan -- 3.0 L DOHC V6 engine. When on level ground and engine off, the power steering fluid level is at the max line. When the engine is started, the level immediately drops… read more
Marc
Marc
fleet supervisor
Vocational, Technical or Trade Scho
1,140 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

27,510 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Ford Technician

35,835 satisfied customers

24 years of experience diagnosing & repairing

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Mike V.

Mike V.

Auto Service Technician

2,909 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,558 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

Cam

Cam

Journeyman Automotive Technician

12 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x