Ford

Have Ford questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Ford Questions
Ron, Miguel here.....I have a 2006 Ford F250 that the A/C
Hello Ron, Miguel here.....I have a 2006 Ford F250 that the A/C resistor and cable is burnt out. However, i cannot locate the part number for this. Can you help me with this.… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
27,281 satisfied customers
Mornin Ron: Do you know of any outside source to buy VW
Mornin Ron: Do you know of any outside source to buy VW parts besides the dealership? I have a 2009 VW Tiguan with a 2.0 turbo and am looking for a timing chain kit or set.… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
27,281 satisfied customers
On ford 6.4 powerstrokes, block was checked for straightness
Second opinion] On ford 6.4 powerstrokes, block was checked for straightness at machine shop and heads were shaved. ARP studs used. Had a couple of them that 6 months later customers are complaining t… read more
Scott
Scott
Diesel, Automatic trans, full line tech
Associate Degree
3,947 satisfied customers
Gasket leak or evap leak. 2000 ford explorer XLS 4.0L V6 OHV
yes I am fixing it myself/ so far I break it down to lower intake manifold, replaced those gaskets sealed it, replaced ect sensor and temp sensor and replaced valve cover gaskets and resealed those and finally the upper which I am having some trouble with because I am not sure how to reattached the gaskets to the fuel rail and whether one gasket goes above the fuel rail between the plastic plenum, I am not sure … read more
Tyler Henry
Tyler Henry
Technician
Automotive service technology
3,065 satisfied customers
I have a 1997 Ford F150 truck with 4.2 litre V6 engine.
I have a 1997 Ford F150 truck with 4.2 litre V6 engine. Check engine light went on after passing state emissions test and driving next day, no more than 5 miles after the test. Since the engine compar… read more
davehop
davehop
Diagnostic Technician
Senior Master Ford Tech. Hyundai Master Technician
1,870 satisfied customers
I have a 1998 Ranger 3.0L 2wd 5 speed. The truck is idling
I have a 1998 Ranger 3.0L 2wd 5 speed. The truck is idling very high at 2000 rpm and running rough. During driving and when I depress the clutch to shift it idles at 3000 rpm until I come to a complet… read more
EricFromCT
EricFromCT
Auto Technician
6,411 satisfied customers
f150: hello Ron got another question about this truck 98 f150..
hello Ron got another question about this truck 98 f150.. i know i should put a new rear main seal in it..should i use a OEM or get a fel-pro- PTFE seal..also do i need to remove the rear seal plate o… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
27,281 satisfied customers
f150: good day i am doing an engine swap on a 98 f150 with
good day i am doing an engine swap on a 98 f150 with a 4.6.. my question is can i reuse the oem exhaust manifold gaskets or should i get new ones..or can i use the fel-pro set..thanks… read more
Kenny Z.
Kenny Z.
Ford Senior Master Technician
High School or GED
7,051 satisfied customers
Sable 3.8 70K: Good day. Im replacing the head gaskets
Good day. I'm replacing the head gaskets on a Sable 1992 3.8L with 70K original miles. Developed a leak coolant to cylinder. Also resurfacing the heads, new head bolts, and replacing other parts (Wate… read more
Dieseljunky2
Dieseljunky2
Locomotive Mechanic
Ford Certified Technician
3,612 satisfied customers
95 Sable: plastic..compression stops for the vavle cover gaskets..leak
my 95 Sable with 3.0 engine must be the only one of it,s kind. Everyone I have seen in the junkyards have plastic vavle covers on them, mine has medal ones. The problem im having is i can not get the … read more
AlvinC
AlvinC
Ford Dealership Technician
Vocational, Technical or Trade Scho
1,238 satisfied customers
95 ford explorer limited: synchroizer assembly..intake manifold gasket
how much does it cost for a 95 ford explorer limited edition sensor/synchroizer assembly and the intake manifold gasket set? If the price ranges, what about the part makes it more or less?… read more
Eric
Eric
Retired
N/A
48,490 satisfied customers
1999 f250: powerstroke..pulley..air conditioning unit..vibrates
I have a 1999 F250 7.3l Powerstroke. I believe the two belt pulley's under the air conditioning unit are bad. It is making a loud noise and the belt vibrates. What needs to be fixed?… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
27,281 satisfied customers
1987 F250: a steering wheel..pickup..steering column..glow plugs
We are looking for a steering wheel for our son's 1987 F250. His buddies took his pickup, wreaked it and some how bent the actual steering wheel, they also broke a pin in the steering column but we th… read more
Rudolph Diesel
Rudolph Diesel
Service manager/ Master mechanic
Vocational, Technical or Trade Scho
1,918 satisfied customers
96 windstar: coolant..engine light came..code P0302 (misfire cyl 2)
Same vehicle - 96 windstar, 3.8 motor, 96K miles. having problems with coolant loss and, this week, check engine light came on with code P0302 (misfire cyl 2). Found external leaks. The metal coolant … read more
EMRSR
EMRSR
High School or GED
3,002 satisfied customers
2007 f350: l..power stroke..auto transmission..this type of vehicle
I am thinking of buying a used 2007 f350 6.0 l power stroke 4 w/d auto transmission. What kind of problems has this type of vehicle had?… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
27,281 satisfied customers
Thunderbird: heater..that was leaking.., replacing lower gaskets..seal
1997 4.6 Thunderbird. I replaced the heater tube that was leaking under the intake manifold. I removed the intake plenum and lower intake manifold to do this, replacing lower gaskets and I am having t… read more
Chris (aka- Moose)
Chris (aka- Moose)
Ford Technician
Vocational, Technical or Trade School
34,605 satisfied customers
89 F-250: 4x4 w/auto trans..oil pan..intake manifold..oil pump
I have a 89 F-250 351 4x4 w/auto trans and fuel injected, I am trying to replace the oil pan gskt. The upper intake manifold is removed and the engine is blocked up to the fire wall but the pan will n… read more
Steve
Steve
expert plus
500 satisfied customers
88 Ford: I get a seal saver or crank saver..flywheel..rear main
Where might I get a "seal saver" or "crank saver" for an 88 Ford 9.4L straight 6? It must be for the back/ flywheel side of the engine - rear main.… read more
TechManSteve
TechManSteve
Associate Degree
74 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

27,281 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Ford Technician

34,605 satisfied customers

24 years of experience diagnosing & repairing

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

12 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Mike V.

Mike V.

Auto Service Technician

2,651 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,558 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x