Ford

Have Ford questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Ford Questions
I have 6f35, I have a f350 super duty dually with a 6.0
I have a f350 super duty dually with a 6.0 turbo diesel. Right before it quit running it sounded like it was hitting on 2cylinders and then just died and haven't been able to get it to start since. Replaced the FICM, new or, new harness for the IPR and icp, new fuel module, scanner says no codes and proper oil and fuel pressure FICM sync. Even had a Ford dealership tech bring the Ford scanner and took the fuse box down and checked it. Everything is good and everyone that has checked it out says it should start but it doesn't … read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
32,621 satisfied customers
I have a 07 6.0. cranks but wont start. got good FICM, HPOP,
I have a 07 6.0. cranks but wont start. got good FICM, HPOP, FICM SYNC, FLP, and FMP. Unplugged sensor on front right valve cover. NO JOY. … read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
32,621 satisfied customers
2005 f350 6.0 cranks no start: Readings Scan Gauge 2 w/key
2005 f350 6.0 cranks no start : Readings Scan Gauge 2 w/key off & on are IPR=14.91 SYC=0 FMP=47.5 ICP=0 Cranking are IPR=85 SYC=1 FMP=47.5 ICP=130 and when cranking dash oil gauge goes to normal engin… read more
HDGENE
HDGENE
8,139 satisfied customers
I'm original owner of 05 Ford F-250 SD 6.0 diesel, 160,000
I'm original owner of 05 Ford F-250 SD 6.0 diesel, 160,000 miles. Crank no start. Bought a scan gauge 2 programmed it for FICM volts, ficm logic, ficm sync, IPC & IPR FICM 12.4 Ficm logic 48.1 SYNC 1 … read more
Ethan Lankford
Ethan Lankford
Self Employed
Diploma
287 satisfied customers
No ficm sync crank no start. Both batteries new good power.
Both batteries new good power. Turns over but immediately stalls … read more
Andrew
Andrew
Master Diagnostic Technician
Associate of Occupational in Automotive Technology
453 satisfied customers
My 2003 ford f350 6.0 diesel cranks no start.I have no oil
My 2003 ford f350 6.0 diesel cranks no start.I have no oil pressure and oil filter housing is dry. Oil in crankcase is good. Scan gauge shows 14.8 IPR, 48 FMP, 0 SYC, 0.13 ICV with key on. 84.7 IPR, 4… read more
Ethan Lankford
Ethan Lankford
Self Employed
Diploma
287 satisfied customers
I have a2006 f250 6.0 turbo diesel no start ipr sensor read
I have a2006 f250 6.0 turbo diesel no start ipr sensor read 14.8 on my scan gauge no charge wend cranks … read more
Andrew
Andrew
Master Diagnostic Technician
Associate of Occupational in Automotive Technology
453 satisfied customers
On my 03 6.0 f350 how do i test my icp in a crank no start
on my 03 6.0 f350 how do i test my icp in a crank no start condition i have a scanguage2 for pid values… read more
Cesar Jimenez
Cesar Jimenez
Owner/CEO
Vocational, Technical or Trade School
208 satisfied customers
2003 ford f250 6.0 crank no start , started with starter fluid
2003 ford f250 6.0 crank no start , started with starter fluid and will not run with out it. using snap on scan tool , film power 48 v,sync yes,icp pressure no more than 300 psi,ipr at crank 85%key on… read more
Ray M.
Ray M.
Diesel Technician
Vocational, Technical or Trade School
3,091 satisfied customers
ford f250: 04 ford f250 6.0 died and wont start. had several
04 ford f250 6.0 died and wont start. had several codes including low icp pressure, crank sensor circuit range/performance, internal control module kam malfunction, injector circuit low cyl. 8.… read more
James
James
Bachelors degree automotive technology with minor in diesel
3,584 satisfied customers
F-250: 06 f250 6.0 crank no start ficm 48.5 syc 1 ipr 50% icp
06 f250 6.0 crank no start ficm 48.5 syc 1 ipr 50% icp 1538 during crank. No codes. All fluid levels good. No air bubbles in fuel filter base during crank.… read more
James
James
Bachelors degree automotive technology with minor in diesel
3,584 satisfied customers
Ford 350 diesel6.0: Hi i have a 2005 ford 6.0 i replace high
Hi i have a 2005 ford 6.0 i replace high pressure pump and new irp and Icp sensors put every ting back together and it wont start i got 48 v on fmp i have 14.8 on ipr 15 icp 0 syc when i crank i have … read more
James
James
Bachelors degree automotive technology with minor in diesel
3,584 satisfied customers
ford: Hi I have an 03 F350 with 6.0 that has 0 for IPR pressure
Hi I have an 03 F350 with 6.0 that has 0 for IPR pressure I have replaced the high pressure pump a couple of weeks ago go an it just shut off going down road. I have checked fuel pressure an have low … read more
James
James
Bachelors degree automotive technology with minor in diesel
3,584 satisfied customers
ford: Hi I have 03 6.0 with a no start problem, I have fuel
Hi I have 03 6.0 with a no start problem, I have fuel pressure 50 psi, have ficm sync an cam an crank sync, ipr goes to 450psi an icp goes to 85%, I have installed a new high pressure pump an checked … read more
Scott
Scott
Diesel, Automatic trans, full line tech
Associate Degree
3,880 satisfied customers
f350 6.0: ok 2003 ford f350 6.0 still wont start checked icp
ok 2003 ford f350 6.0 still wont start checked icp fuel pressure changed starter batteries fuel filters oil filters checked voltages egr valve ac compressor all the other pulleys im out of ideas… read more
Ray M.
Ray M.
Diesel Technician
Vocational, Technical or Trade School
3,091 satisfied customers
F350: Last week my 2004 6.0 powered..10 minutes..surges..accelerate
Last week my 2004 6.0 powered F350 decided to not start after it had been sitting for a few hrs. After cranking for a while it did start and it would restart immediately after shutdown. after sitting … read more
Pavlin Koev
Pavlin Koev
Diagnostic Technician
High School or GED
3,485 satisfied customers
2004 f250: glow plugs..570 psi cranking ficm..wouldnt start
i have a 2004 f250 6.0 diesel with 125,000 miles it will not start at all,i have tested glow plugs fuel preasure koeo 50psi hpop 570 psi cranking ficm 12volts 10.5 cranking 48volts 47.0 cranking recei… read more
Shawn E
Shawn E
Ford Senior Master Dealership Technician
Associate Degree
144 satisfied customers
F350: im going down the road it acts like it..accelerating..rattle
i have a 03 f350 four door 1st prob engine will just die if im going down the road it acts like it shuts off and right back on 2nd when accelerating from a light or a stop i dont get the diesel rattle… read more
Dodge expert
Dodge expert
ASE MASTER TECH, REPAIR FACILITY OWNER
High School or GED
3,636 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

26,544 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Technician

32,621 satisfied customers

16 years experience

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

12 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Mike V.

Mike V.

Auto Service Technician

2,204 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,547 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x