Ford

Have Ford questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Ford Questions
2004 f250 6.0 powerstroke crank but want start. I'm not get
2004 f250 6.0 powerstroke crank but want start. I'm not get 5 volts to the icp, egr , throttle position sensor , ebp. Instead of 5 volts I get a ground. … read more
6Bucs
6Bucs
Senior Master Tech
Associate Degree
1,350 satisfied customers
I went yesterday to pickup the truck and dump trailer. The
I went yesterday to pickup the truck and dump trailer. The truck would not start at first, slow crank/low battery so I hooked my F450 up, set the idle up and let it set for a while and it started. It … read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
62,291 satisfied customers
It's a 06 6.0 ford cranks over but won't start. I took top
Yes I took top off fuel filter on engine it's getting fuel icp reg is opening 85% it's building 633 psi hi volume oil pump pressure ficm has 47.33volts its reading rpm during cranking … read more
Andrew
Andrew
Master Diagnostic Technician
Associate of Occupational in Automotive Technology
451 satisfied customers
Have a 2005 f250 6.0 no start situation. Only code thrown
Hi...have a 2005 f250 6.0 no start situation. Only code thrown was the 2614. I changed the wire/plug to the cam (on the driver side). Changes the IPR today, still no start. BUT....I did notice that th… read more
HDGENE
HDGENE
8,075 satisfied customers
I replaced the heads, HPOP, Fuel pump, Glow plug module, new
I replaced the heads, HPOP, Fuel pump, Glow plug module, new wiring harnesses (Excluding main engine harness) I am getting the proper pressures ie. Oil and fuel. Proper voltage even with the FICM. Tru… read more
Ray M.
Ray M.
Diesel Technician
Vocational, Technical or Trade School
3,089 satisfied customers
Last week truck was running rough. Came home drove in
Last week truck was running rough. Came home drove in garage. Changed oil, oil filter and fuel filters. It started but rough, then stopped.First got code changed it erased alarm now I got u0306,p1000 … read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
62,291 satisfied customers
05 f250 6.0 have replaced stand tubes, IPR, during air leak
05 f250 6.0 have replaced stand tubes, IPR, during air leak test hearing air from crankcase, reading on scan tool is .25 volts, goes up when cranking to 45, 85%, and still only getting only to 120 psi… read more
James
James
Bachelors degree automotive technology with minor in diesel
3,584 satisfied customers
f 250: 2005 ford f250 super duty 6.0 will only start with either.
2005 ford f250 super duty 6.0 will only start with either. at koeo good fuel flow to fuel filter housing. oil level is good and good oil. have ficm sync, rpm @ crank is 175. icp @ crank 395??(should b… read more
James
James
Bachelors degree automotive technology with minor in diesel
3,584 satisfied customers
ford f250: 04 ford f250 6.0 died and wont start. had several
04 ford f250 6.0 died and wont start. had several codes including low icp pressure, crank sensor circuit range/performance, internal control module kam malfunction, injector circuit low cyl. 8.… read more
James
James
Bachelors degree automotive technology with minor in diesel
3,584 satisfied customers
f350: Just did an egr delete on a 04 6.0 now truck starts and
Just did an egr delete on a 04 6.0 now truck starts and dies. My ITR is reading at 85 percent during start. Ficm is reading 48 v and icp is reading at . 25v… read more
James
James
Bachelors degree automotive technology with minor in diesel
3,584 satisfied customers
F350 powerstroke: 2007 F350 6.0 POWERSTROKE HPOP installation.
2007 F350 6.0 POWERSTROKE HPOP installation. Air testing hpop, branch tube and oil rails before installing hpop cover and turbocharger. Leaks air at relief port on HPOP under injection pressure regula… read more
James
James
Bachelors degree automotive technology with minor in diesel
3,584 satisfied customers
i have a 06 ford f-350 with a 6.0 diesel will not start the
i have a 06 ford f-350 with a 6.0 diesel will not start the icp pressure is 575 when cranking over shut the truck off and it won't start… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
62,291 satisfied customers
2006 F-350: anybody tell..censor..sensors..the truck cranks that
2006 F-350 6.0 Can anybody tell me how to check the ipc censor to make sure it is working. It is not throwing a code but I've had many sensors go out and not throw a code. Someone told me if you unplu… read more
Ray M.
Ray M.
Diesel Technician
Vocational, Technical or Trade School
3,089 satisfied customers
2007 Ford: power stroke..it blows black smoke and chuggs..glow plugs
I have a 2007 Ford 250 with the 6.0liter power stroke, I'm not sure if it just bad diesel or something else but I fueled up about 4 days ago and ever since the truck doesn't want to start and if it do… read more
snapontech
snapontech
Associate Degree
195 satisfied customers
f250: 6.0l..good fuel and oil press...voltage..it runs good but most
have a 03 f250 6.0l new ipr,hpop,latest ficm reflash cal. good fuel and oil press. starts good has good ficm voltage very little power at any or wide open throttle sometimes desired icp will go to 365… read more
NicksSticks
NicksSticks
Vocational, Technical or Trade Scho
1,430 satisfied customers
I have a 2003 Ford F250 with a 6.0 Diesel will not start.
I have a 2003 Ford F250 with a 6.0 Diesel will not start. I have change the Alt (was bad) 2 new batteries went through the wire, fuses & relays can't find a problems, looking for more to check… read more
lestert46
lestert46
4 satisfied customers
A 03 6.0 that will crank and try to start but will not..scanner..rpm
Hi i am working on a 03 6.0 that will crank and try to start but will not. with scanner attached when it tries to start i get no more then 300-400 rpm. and ICP says it wants around 1500 and i have onl… read more
RJ
RJ
Ford Tech
High School or GED
1,573 satisfied customers
f250: icp bad..i pluged in the block heater last nite and no miss
Misses in the morning for 3-4 seconds, no other time. f250 2003 6.0...fault code is P2285...Is the ICP bad, and if so, where is it located?...I pluged in the block heater last nite and no miss...What … read more
Shawn E
Shawn E
Ford Senior Master Dealership Technician
Associate Degree
144 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

26,187 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Technician

62,291 satisfied customers

16 years experience

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

10 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Mike V.

Mike V.

Auto Service Technician

1,994 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,535 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x