Ford

Have Ford questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Ford Questions
I have an 04 Mustang and 5th gear will grind really bad when
HI! I have an 04 Mustang and 5th gear will grind really bad when i shift at anything higher than 2000rpm. also, there a noticable burning smell after i drive. its not the brakes or anything else, im f… read more
William Cole
William Cole
service oof heavy equipment
107 satisfied customers
With my clutch pedal released I hear an somewhat quiet
with my clutch pedal released I hear an somewhat quiet knocking sound that stops when I press the clutch pedal. It doesn't sound consistent either. its more of - - - - --- --- - - - ---- as opposed to… read more
Mechanic01
Mechanic01
ASE Certified Technician
9,085 satisfied customers
Just bought an 01 mustang and before i started tearing
Just bought an 01 mustang and before i started tearing things apart wanted to double check so The clutch is to the floor but the car still starts but isnt driveable should i look into a full clutch ki… read more
Edward
Edward
Professional at Justanswer.com
Associate Degree
4,160 satisfied customers
I have a 2007 ford mustang with a 5 speed im having truble
i have a 2007 ford mustang with a 5 speed im having truble puting it into any gear but when it cools down it shifts just fine … read more
HDGENE
HDGENE
8,087 satisfied customers
Ford Mustang: I have an 89 Mustang, 5 liter. Recently I observed
I have an 89 Mustang, 5 liter. Recently I observed that I could get into first gear only if I pushed the clutch pedal all the way to the floor. On a drive yesterday I found that it was becoming more d… read more
Virtual Wrench
Virtual Wrench
Owner of LJ Auto Repair 37 years
Associate Degree
14,420 satisfied customers
Ford Mustang GT: What might cause the clutch throwout bearing
What might cause the clutch throwout bearing on a 2004 Ford Mustang GT to go bad repeatedly? I just replace it and the clutch a year and a half ago and it is going bad again. Thanks… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
32,621 satisfied customers
Ford Mustang GT: 2012 Ford Mustang GT 5.0 When shifting gears
2012 Ford Mustang GT 5.0 When shifting gears I have to almost push the clutch pedal to the floor. I tried lifting clutch pedal with foot for readjustment but it won't lift up at all.… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
32,621 satisfied customers
pilot: new clutch..When I got brand new, it used to engage/disengage
Just got a new clutch, throwout bearing, pilot bearing, rear main seal replaced. Pedal now goes all the way the floor and feels like I don't even have a clutch.... When I got brand new, it used to eng… read more
AlvinC
AlvinC
Ford Dealership Technician
Vocational, Technical or Trade Scho
1,238 satisfied customers
1988 mustang: adjusting..new clutch..clutch kit..T O bearing
haveing trouble adjusting clutch ,new 5.0 new clutch kit new cable @ quadrant from dealer . i have to adj. T O bearing into PP quite a bit before it releases so you can get it in gear 1988 mustang HEL… read more
Pavlin Koev
Pavlin Koev
Diagnostic Technician
High School or GED
3,485 satisfied customers
Ford Mustang LX 1993 Ford Mustang LX 2.3 liter with 5 speed
1993 Ford Mustang LX 2.3 liter with 5 speed manual transmission has intermittent trouble with clutch. Sometimes normal, sometimes the clutch pedal has reduced range of motion, associated with difficul… read more
Anthony
Anthony
Master Automobile Technician
Vocational, Technical or Trade Scho
11,778 satisfied customers
2003 Ford Mustang GT: 4.6L sohc engine..000 miles..new clutch..bearing
I have a 2003 Ford Mustang GT Premium Coupe 4.6L SOHC engine with a 5 speed manual transmission. The vehicle has 51,000 miles on it. I recently, last week, had a new clutch kit installed due to a fail… read more
freddie at 23
freddie at 23
AUTOMOTIVE TECHNICIAN
Associate Degree
68 satisfied customers
1999 f160 v6 five speed standard.Is it possible..clutch..pedal..Shifts
1999 f160 v6 five speed standard. Is it possible to adjust the clutch. To much free pedal . Shifts near the floor.… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
26,544 satisfied customers
2000 Ford F 550: drove..it in gear by depressing pedal to floor boards
I have a 2000 Ford F 550 6 speed. Just bought in N.C. and drove to N.J. You can only get it in gear by depressing pedal to floor boards. Almost impossible in reverse and low. There is no slippage and … read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
32,621 satisfied customers
brakes at the same time, after that my clutch pedal went..new clutch
i was driving in traffic, traffic came to a quick stop i pushed in the clutch and hit the brakes at the same time, after that my clutch pedal went soft and would not shift into gear...think i need a n… read more
A. Penland
A. Penland
Ford Senior Master Technician
Vocational, Technical or Trade School
7,917 satisfied customers
91 & 93 MUSTANG 5.0 STOCK..CLUTCH PEDALS ARE HARD TO DEPRESS..NEW
91 & 93 MUSTANG 5.0 STOCK..CLUTCH PEDALS ARE HARD TO DEPRESS..NEW ADJ CLUTCH CABLES. BOTH CHANGED FROM AUTO TRANS. A FEW YEARS AGO. OUGH IN TRAFFIC. ETC. ANY WAY TO EASE UP THE FORCE MY SORE LEG HAS T… read more
A. Penland
A. Penland
Ford Senior Master Technician
Vocational, Technical or Trade School
7,917 satisfied customers
2000 Ford Ranger: manual transmission..clutch..2wd..43,000 miles on it
What is the life expectancy of a manual transmission clutch? I have a 2000 Ford Ranger (2wd) with 43,000 miles on it. most of my driving is in town. I am having to push the pedal nearly to the floor t… read more
Tim
Tim
Associate Degree
3,579 satisfied customers
97 ford mustang cobra: clutch goes..engine runs fine in neutral.
My 97 ford mustang cobra, suddenly the clutch goes straight to the floor it put it gear. The engine runs fine in neutral.… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
32,621 satisfied customers
1989 mustang GT: clutch pedal..I really have to push the gear shift
I have to push the clutch pedal all the way to the floor (almost through the floor) to get the gear shift to go into gear. Even then it is still hard to get in gear and I really have to push the gear … read more
Sam C
Sam C
Service Manager
Almost a liberal arts!
792 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

26,544 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Technician

32,621 satisfied customers

16 years experience

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

12 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Mike V.

Mike V.

Auto Service Technician

2,204 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,547 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x