Ford

Have Ford questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Ford Questions
My truck is a 1994 F150 with a 302. I am fixing the Ford
I am fixing the Ford myself. For a few months previous, in closed loop, it would surge, but once warm, it ran fine. … read more
ENES
ENES
5,928 satisfied customers
Ranger: Getting ping on the freeway. KOER test code 25. Replaced
Getting ping on the freeway. KOER test code 25. Replaced knock sensor after running voltage check @ knock sensor connector, then following flow chart replaced the ECM. I'm still getting code 25.… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
31,725 satisfied customers
90 ford mustang: ecU. Check engine light..test connecter
Hi troubleshooting a 90 ford mustang ECU. Check engine light is on and throwing codes 35, 22, 51, 54, 53, and 67. I can't get the codes to pull jumpering STI to STG on the test connecter only by gound… read more
Kenny Z.
Kenny Z.
Ford Senior Master Technician
High School or GED
6,725 satisfied customers
working on this 6.0 we put a new hpop and ipr sensor..scanned
I am still working on this 6.0 we put a new hpop and IPR sensor on it and it cranking and running but when you cut it off it will not crank back up. you can let it sit for for a minute and it will cra… read more
Mat
Mat
Ford Senior Master Technician
Associate Degree
956 satisfied customers
Ford F150: 4.6L V8..Overdrive is flashing...fail safe
Hi, I have a Ford F150 2003 4.6L V8. Overdrive is flashing. Scandiagnostic shows faultcode P1747 ( transmission fail safe ). I've disconnected the transmission harnass connector and inspected all wire… read more
Jon Pell
Jon Pell
Bachelors
153 satisfied customers
93 ford f350: pumping..throttle..map sensor code w/eng off
93 ford f350 w/460 cid. engine will only run while pumping throttle. no codes while running, map sensor code w/eng off. Checked tp sensor and map sensor ok. help… read more
ASEMaster35yrs
ASEMaster35yrs
Vocational, Technical or Trade Scho
2,061 satisfied customers
Ford F-550 I have a 2003 Ford f-550 with a 6.0 liter diesel
I have a 2003 Ford f-550 with a 6.0 liter diesel which has a code po237,low voltage to circuit A on the turbo. Whats up and can I get a wiring diagram?… read more
John Crouch
John Crouch
lead senior master tech
Vocational, Technical or Trade Scho
1,840 satisfied customers
2002 ford: Diesel..experiencing the truck dying for no reason.
I have a 2002 Ford 7.3.liter Diesel Excursion. I am experiencing the truck dying for no reason. I get a code of P0236 (Turbo/super Ackt Range). What does this mean?… read more
Steve
Steve
Ford tech Specializing in electronics
Vocational, Technical or Trade School
6,755 satisfied customers
2005 F-350: 000 miles..Wrench and engine light..rev..maf was unplugged
2005 F-350 6.0, 85,000 miles. Wrench and engine light would ocassionally come on, would idel but not rev, if the MAF was unplugged and plugged back up the problem went away. Problem is permanent now, … read more
Ron W.
Ron W.
Master Certified Technician
Vocational, Technical or Trade Scho
252 satisfied customers
I have a 1994 Bronco 5.8L EFI, the engine will crank but will
I have a 1994 Bronco 5.8L EFI, the engine will crank but will not start. There is no pressure at the fuel charging manifold, the fuel pump has been replaced, I have grounded the FP diagnostic lead on … read more
Tim
Tim
Associate Degree
3,579 satisfied customers
2005 E350: powerstroke..Turbo boost..circuit low..the map sensor
Hi, I have a 2005 E350 6.0 powerstroke with codes P0069 Map- Baro pressure and P0237 Turbo boost sensor A circuit low. I was planning on replacing the map sensor and seeing if that takes care of it. A… read more
Ray M.
Ray M.
Diesel Technician
Vocational, Technical or Trade School
3,089 satisfied customers
2002 F350: I am getting a fault code of P0237..7.3L
I am getting a fault code of P0237 on my 2002 F350 diesel (7.3L). What causes this fault and how do I fix it?… read more
Tim West
Tim West
Service Manager
Computer/ Automotive certifications
16 satisfied customers
What does Ford EEC-IV fault code 15 mean. Please answer!
I have an 89 ford mustang gt with issues. I have pulled the fault codes and they are as follows. 15 51 22 53 54 67. These are the ON DEMAND codes, key on engine off. The code reader says I have to fix… read more
Brian
Brian
Automotive Service Consultant/Technician
Bachelor Degree
780 satisfied customers
I have a 03 f-250, 6.0L with an OBD code p132b. I have read
I have a 03 f-250, 6.0L with an OBD code: p132b. I have read that it might be the turbo and I have also read it could be one or more injectors. I am running a banks chip, could this be the problem or … read more
Bamaman39
Bamaman39
Ford master diesel Tech.Ford certified
High School or GED
2,287 satisfied customers
2000 7.3 excursion....throwing a po237 code. changed map sensor
2000 7.3 excursion....throwing a po237 code. changed map sensor with no luck shutting off code. turbo is quieter than normal, not as loud of a spool up.… read more
Ssholar
Ssholar
Team Leader Shop Foreman
High School or GED
6 satisfied customers
99 explorer: coils when cranking 1.5 V (KO)..PCM..fuel pump relay
99 explorer 5.0 NO spark there is a battery voltage (KO) to coils NO trigger signal to coils when cranking 1.5 V (KO) on both 21 and 22 cables from 2 wire CrPS (should it be on one only ?) ONLY 0.1 se… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
26,187 satisfied customers
94 bronco with 351 auto check engine light on idles fast and
94 bronco with 351 auto check engine light on idles fast and erratic . transmission shifts hard. has code 126 and 998. replaced map sensor and reset by dissconecting battery for 5 minutes problem stil… read more
Brian
Brian
Automotive Service Consultant/Technician
Bachelor Degree
780 satisfied customers
1988 ford ranger: v6..wont start every time..fuel pressure..ecm
i have 1988 ford ranger 2.9 v6 manuel tranny it has a starting problem cranks but wont start every time you shut it off in order to get it started you have to just bump ignition switch over several ti… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
26,187 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

26,187 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Technician

31,725 satisfied customers

16 years experience

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

10 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Mike V.

Mike V.

Auto Service Technician

1,994 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,535 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x