Ford

Have Ford questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Ford Questions
I have 01 F250 7.3. Passed buzz test have cyl 1 &3 fail
I have 01 F250 7.3. Passed buzz test have cyl 1 &3 fail contribution test. Looked at wiring harness it's ok. Replaced right VC gasket and IDM. What else could it be? It started with occasional miss wi… read more
marcus odell
marcus odell
Mechanic
Associate Degree
269 satisfied customers
IDM wiring failure, codes p0263, p0269, p0275, p0281. Newer
IDM wiring failure, codes p0263, p0269, p0275, p0281. Newer style of VCG that doesn't have the underside plugs just the molded wiring. Tested ohms on passenger side VCG and all were about 3.4 or so. T… read more
Andrew
Andrew
Master Diagnostic Technician
Associate of Occupational in Automotive Technology
330 satisfied customers
2003 F350 7.3 power stroke I replaced 8 injectors both valve
2003 F350 7.3 power stroke I replaced 8 injectors both valve cover gaskets and uvc replaced IDM inspected engine wire harness for chaffing nothing found I also ohm checked harness at IDM 3.6 nominal o… read more
HDGENE
HDGENE
7,735 satisfied customers
Have a 2000 ford 7.3. has intermittent injector codes. did
have a 2000 ford 7.3. has intermittent injector codes. did break out box tests and show that idm is bad. ordered a plug and play idm-120. same issue. put a idm-100 off 1997 7.3 runs fine with no codes… read more
James
James
Bachelors degree automotive technology with minor in diesel
3,584 satisfied customers
2002 f250 7.3 dead unplug one injector on that side and the
2002 f250 7.3 dead unplug one injector on that side and the other three start working it does not matter which of the 4 i disconnect the other three fire until i plug the disconnected one back in then… read more
James
James
Bachelors degree automotive technology with minor in diesel
3,584 satisfied customers
Have been having an issue with cold starts. About a month
Have been having an issue with cold starts. About a month ago 3/8 glow plugs and one injector was bad. I had all glow plugs and 1 injector replaced. Everything was great until yesterday. Yesterday her… read more
James
James
Bachelors degree automotive technology with minor in diesel
3,584 satisfied customers
2001 f450, 7.3, sets 1271 and 1278 codes, replaced uvch and
2001 f450, 7.3, sets 1271 and 1278 codes, replaced uvch and gaskets with updated ones, ohm at 3.4 to 3.6 , unplugged idm and ohmed wiring, shows good? I have a new idm, but don't want to replace it if… read more
James
James
Bachelors degree automotive technology with minor in diesel
3,584 satisfied customers
1999 F250 7.3 DIESEL SETTING CODE P1316 , FAILING # ***** ON BUZZ
1999 F250 7.3 DIESEL SETTING CODE P1316 , FAILING # ***** ON BUZZ TEST , REPLACED UVCH & GASKET ON LEFT SIDE , REPLACED 1 ,3 ,7 , 2 & 4 FUEL INJECTORS . ANY IDEAS ?… read more
James
James
Bachelors degree automotive technology with minor in diesel
3,584 satisfied customers
Ford: I have a 96 Ford F350 7.3 Powerstroke. The passenger
I have a 96 Ford F350 7.3 Powerstroke. The passenger side injectors are not working. I have replaced the injector wiring and valve cover gasket on both sides. I have replaced the CPS, I have checked a… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
60,574 satisfied customers
f250: I have a 97 Ford f250 7.3 Powerstroke diesel, it stsarted
I have a 97 Ford f250 7.3 Powerstroke diesel, it stsarted running sluggish cold and better warm, now it barley runs either way, no codes at all, I have good fuel pressure, found truck running on right… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
60,574 satisfied customers
F250: injector control module was blown Replaced it still wont start
2000 7.3 F250 100000 mi. Engine quit at 65 mph Never had a problem before Replaced camshaft sensor Oil is full The 30 amp fuse to the injector control module was blown Replaced it still wont start. No… read more
Thomas
Thomas
Mechanic
High School or GED
1,537 satisfied customers
2000 ford f250: missfire..checked wire harness under valve cover,good
2000 ford f250 7.3. missfire #3. ohmm checked wire harness under valve cover,good. ohmed injector. ohmed engine harrness. all check good. swapped #1 & #3. miss still @ #3. Any suggestions? also notice… read more
SuperBob
SuperBob
Ford dealer senior master technician
Vocational, Technical or Trade Scho
2,603 satisfied customers
1995 Ford F250: 7.3 diesel..stop light..stopped running..restart.
I have a 1995 Ford F250 7.3 diesel and when I pulled up to a stop light yesterday it just stopped running asd if I hard turned the motor off. It would not restart. No check enginge lights. The Voltage… read more
Mat
Mat
Ford Senior Master Technician
Associate Degree
956 satisfied customers
2001 F350: 7.3 Diesel..gpr, new glow plugs, new pcm, only code..Trans
Have a 2001 F350 7.3 Diesel that is hard to start first thing in the morning. Has a new wiring harness with GPR, new glow plugs, new PCM, only code that is set is Trans Range Sensor Code. Oil is in go… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
60,574 satisfied customers
F 450: ok put new injectors..started missing..im lost
ok put new injectors in 02 f 450 7.3, carnked up seemed like it was gonna do fine started missing. all passed buzz test and 1,2,7 failed the contribution test. im lost fooled with it all day still no … read more
Thomas
Thomas
Mechanic
High School or GED
1,537 satisfied customers
2000 ford: powerstroke..160 deg. on a cyl cont..truck runs..runs great
2000 ford powerstroke 7. 3 120.000 miles when operating temp reaches 160 deg. on a cyl cont, test im losing 5 cyls. when cold truck runs great. had this truck at ford dealer and they cant figure it ou… read more
HDGENE
HDGENE
7,735 satisfied customers
95 Ford: starts fine, runs ok, has a heavy smoke..engine oil
Have a 95 Ford E350 7.3 diesel - starts fine, runs ok, has a heavy smoke out tailpipe and heavy fuel smell, it burns your eyes. Scanned engine Codes that came up are: 1. P0195 engine oil temp sensor 2… read more
Dodge expert
Dodge expert
ASE MASTER TECH, REPAIR FACILITY OWNER
High School or GED
3,636 satisfied customers
my 1996..that isnt firing is only pumping less oil to the injectors
only one side of the engine is running on my 1996 7.3 powerstroke i checked the fuel thts is ok the side that isn't firing is only pumping less oil to the injectors than the side that is running.… read more
Ray M.
Ray M.
Diesel Technician
Vocational, Technical or Trade School
3,086 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

26,187 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Technician

60,574 satisfied customers

16 years experience

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

10 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Mike V.

Mike V.

Auto Service Technician

1,994 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,535 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x