Ford

Have Ford questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Ford Questions
2012 Ford F150 3.5 Liter Ecoboost Presented with code p0022,
2012 Ford F150 3.5 Liter Ecoboost Presented with code p0022, and had timing chain rattle from driver side when fired up cold Changed Timing chain, found chain had jumped a few teeth, replaced tensione… read more
JOHN aka Eauto
JOHN aka Eauto
self employed
High School or GED
20,092 satisfied customers
When cold, truck starts, runs rough. after warm-up, it quits
when cold, truck starts, runs rough. after warm-up, it quits and won't start … read more
A. Penland
A. Penland
Ford Senior Master Technician
Vocational, Technical or Trade School
7,867 satisfied customers
I replaced both VCTs yesterday and cleared the code. Drove
I replaced both VCTs yesterday and cleared the code. Drove it for +-30 miles and engine light came back on. The truck started to do as before; shaking at idle and bogging down during acceleration. 200… read more
Ironmike
Ironmike
ASE Master ,Ford Certified Master Tech
Vocational, Technical or Trade Scho
3,475 satisfied customers
I have a 2007 F150 5.4 3 valve. Getting 2 codes P0010 and
I have a 2007 F150 5.4 3 valve. Getting 2 codes P0010 and P0016. Is this most likely a timing chain issue and whats the cost typically for that service or how many hours is it projected to take?… read more
JOHN aka Eauto
JOHN aka Eauto
self employed
High School or GED
20,092 satisfied customers
S. I have a 2006 f150 that was running fine one morning and
I have a 2006 f150 that was running fine one morning and went to stop at a red light and motor shut down and engine light came on and said low oil pressure. I struggled to get it to crank to get it out of traffic and when it did it sounded horrible and had no power. I had it towed to my house where I had a friend put a hand held OBD reader on it and it showed a code po345 bank2 so I replaced the cam shaft position sensor. It didn't get any better. I changed the coils and still no better, I unplugged each coil individually and the only one that will kill the engine is number one on bank one, the rest I can unplug with no difference. I had a mechanic part time mechanic down the road look at it and he told me that it had a small knock on bank to and believed my phaser was bad so I had phasers, tensioners, guides, timing chain and oil pump all replaced he showed me where one of the tensioners had broken and we believed that was the cause and after all back together there is still no change. It will crank a lot easier than it did the day it broke down but runs really rough, shakes and has no power at all. … read more
HDGENE
HDGENE
7,992 satisfied customers
I have a 04 f150 bank 2 is not working at all codes said
I have a 04 f150 bank 2 is not working at all codes said misfire 5 misfire 6 7 8 o2 sensor camshaft retarded… read more
HDGENE
HDGENE
7,992 satisfied customers
f 150: I have a ford f150 5.4 2008 that check engine
hello I have a ford f150 5.4 2008 that check engine light is on, the codes are p0012 intake-cam position timing-over-ret- bank 1, p0016 ckp-cmp-corrilation-bank1 sensor 1 and p0303 cyl-3. misfire det,… read more
lightsout22
lightsout22
160 satisfied customers
EXPEDITION: 2005 ford expedition 5.4. running great then went
2005 ford expedition 5.4. running great then went to crap. scanner revealed 9 different codes. po175, po171, po305, p2198, po011, ppo022, po0300, p0307, p0308.… read more
A. Penland
A. Penland
Ford Senior Master Technician
Vocational, Technical or Trade School
7,867 satisfied customers
Ford F-150: I had the timing chain and phasers replaced on
I had the timing chain and phasers replaced on my 2005 f150 5.4l triton before my cross country trip from texas to oregon. I drove it 16 hrs straight the first day and after about 10 hours of driving … read more
A. Penland
A. Penland
Ford Senior Master Technician
Vocational, Technical or Trade School
7,867 satisfied customers
Ford F150 5.4: I've got a problem with my '04 F150, 5.4, 4x4.
I've got a problem with my '04 F150, 5.4, 4x4. 173,000 miles. Truck was purchased new in '04. Have never had any major mechanical problems. Changed plugs at about 100,000. Past month or so have notice… read more
A. Penland
A. Penland
Ford Senior Master Technician
Vocational, Technical or Trade School
7,867 satisfied customers
Ford F-150 FX4: 2003 F150 4x4 5.4L History: P0022 to find
2003 F150 4x4 5.4L History: P0022 to find out #1 rod baring was bad. Replaced engine. After doing so codes P0011 & P0012 came up. how do i fix these codes. Thanks, M & J… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
31,725 satisfied customers
F150 showing vct solenoid symptoms. Rough idle and no power.
I have an 04-f150 5.4 that's showing up code p0012. Very rough idle and NO POWER! yesterday i changed the passenger side VCT solenoid, no luck. Just for giggles i swapped the old passenger solenoid wi… read more
Kenny Z.
Kenny Z.
Ford Senior Master Technician
High School or GED
6,699 satisfied customers
F150 king ranch: the chain tensioners..fail..cam sensors..housing
Hello I have a 2005 5.4 v3 f150 king ranch that keeps giving me the same 2sht codes p0345 and o0349 now I replace ed the chain tensioners on it and it didn't fail as bad before and well my question is… read more
Mat
Mat
Ford Senior Master Technician
Associate Degree
956 satisfied customers
2010 ford f150: eng..rough..shows code po345, bank 2 cam sensor..acts
i have a 2010 ford f150 4.6 eng. it has been repaired from a collision. it runs just fine till it worms up then it runs real rough and looses power, o.b.d. shows code po345, bank 2 cam sensor, i repla… read more
CTFordTech
CTFordTech
Auto Technician
Vocational, Technical or Trade Scho
4,894 satisfied customers
Drives..Jus replaced the vct solenoid on the bank 2 drivers side..cam
i have a p0022 code and it runs and drives bad. Jus replaced the vct solenoid on the bank 2 drivers side and still runs the same way. i was told by another mechanic that the problem is the cam phaser … read more
Dieseljunky2
Dieseljunky2
Locomotive Mechanic
Ford Certified Technician
3,589 satisfied customers
04 f150 5.4l Runs rough. Error codes P0022, P0171, P0175,
04 f150 5.4l Runs rough. Error codes: P0022, P0171, P0175, P2198. Just wondering where I should start. Camshaft Position Sensor?… read more
Chuck
Chuck
ASE Certified Technician
Vocational, Technical or Trade Scho
1,685 satisfied customers
2005 F-150: 5.4L..warms..I have changed the camshaft position sensors
2005 F-150 5.4L Engine will not idle below 1000rpm after it warms up. I have changed the camshaft position sensors. problem still the same. The truck runs fine when it is cold.… read more
A. Penland
A. Penland
Ford Senior Master Technician
Vocational, Technical or Trade School
7,867 satisfied customers
2004 ford f150: lt..5.4l../>cam retard issues chain tensioner
2004 ford f150 lt 5.4l 3 valve. cam retard issues chain tensioner too loose excessive noise from drivetrain what are causes most importantly, what are the solutions?… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
31,725 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

26,187 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Technician

31,725 satisfied customers

16 years experience

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

10 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Mike V.

Mike V.

Auto Service Technician

1,994 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,535 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x