Ford

Have Ford questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Ford Questions
06 escape 3.0. Backfires through intake. Sounds like
06 escape 3.0. Backfires through intake. Sounds like popcorn. Initially had codes for coils on cyl D,E,F.. that would be the front of the car,correct? I tested coils with a spark tester they are all g… read more
Tony McCarthy
Tony McCarthy
Owner Technician
711 satisfied customers
2003 Ford Expedition 5.4L I get P0351 and P0356 together
2003 Ford Expedition 5.4LI get P0351 and P0356 together with intermittent misfires (more often under load)I have replaced COPs and spark plugs, but codes return.Occasional P0315 crankshaft code has be… read more
A. Penland
A. Penland
Ford Senior Master Technician
Vocational, Technical or Trade School
7,739 satisfied customers
2004 ford escape 3.0l have fuel pressure, good compression
2004 ford escape 3.0l have fuel pressure, good compression 200 psi. on all. had cyl. missfire on 3,4,5,6, and p0300 . all coils checked ok, checked with ohms meter , read 0v . check a new coil read th… read more
HDGENE
HDGENE
7,811 satisfied customers
2006 ford escape xlt 6 cyl. 4wd lost power big time, shakes,
2006 ford escape xlt 6 cyl. 4wd lost power big time, shakes, feels like its running on 2 cyls insread of 6 … read more
HDGENE
HDGENE
7,811 satisfied customers
C2900, u1900, b1805, p0183 and p0351. Runs bad. Replace all
C2900, u1900, b1805, p0183 and p0351. Runs bad. Replace all 6 spark plugs the three coils under manifold and had computer repaired. Started it up last night and still runs rough. … read more
HDGENE
HDGENE
7,811 satisfied customers
Now fire on cyl 6 and 8 p0356 p0358? i think were codes i
now fire on cyl 6 and 8 p0356 p0358? i think were codes i can pull them again...ive replaced entire wire harness as i have 2 spare replaced ccrm coils plugs hell everything except pcm which i have and… read more
EricFromCT
EricFromCT
Auto Technician
5,219 satisfied customers
I replaced the PCM and the six COPs. A Ford dealer
I replaced the PCM and the six COPs. A Ford dealer reprogrammed the PCM (aftermarket, remanufactured), however the dealer said they had to install the PCM so I couldn't replace the COPs at the same ti… read more
James
James
Bachelors degree automotive technology with minor in diesel
3,584 satisfied customers
ZX2: my daughters ZX2 died. After sitting 15 minutes or so,
my daughters ZX2 died. After sitting 15 minutes or so, started and ran fine. I went and checked it out, ran fine. She left work, 2 miles later, died again. Towed home, ran for 20 seconds now "wants" t… read more
Wayne Crawford
Wayne Crawford
4,037 satisfied customers
Ford Escape Limited: My 2005 Ford Escape 3.0L (137,000 miles)
My 2005 Ford Escape 3.0L (137,000 miles) has a minor misfire when under load with no ECL. I replaced the original spark plugs with OEM platinum iridium plugs and set the gap to .054 thousands. Car mis… read more
EricFromCT
EricFromCT
Auto Technician
5,219 satisfied customers
Escape: Hello, I have a Ford Escape 2001 (3.0 V6) and this
Hello, I have a Ford Escape 2001 (3.0 V6) and this SUV has the P0351 OBD II code. We change 6 ignition coils, spark plugs and we make the wires test of continuity and the problem persists. We sent to … read more
Paul M ASE Master
Paul M ASE Master
Automotive College
4,570 satisfied customers
ford: computer, sparkplugs, changed wires from pcm to coil packs
i have a ford 500 3.0.it keeps seting po 351 and po 355 have changed computer, sparkplugs, changed wires from pcm to coil packs and coil packs.… read more
Marty
Marty
Vocational, Technical or Trade Scho
576 satisfied customers
2005 Ford Escape: 3.0L..OBD codes..Ignition coil..Circut
I have a 2005 Ford Escape v6 3.0L with the following OBD codes, P0351, P0352,P0353, P0354. The view freeze data is: P0354, Ignition coil D Primary /Secondary, Circut Malfuntion. Each of the other OBD … read more
someguy_78
someguy_78
Service Tech
Associate Degree
292 satisfied customers
92 ford ranger: trans. Engine cuts out and intermit stalls..crank
Working on a 92 ford ranger, 2.3, man. trans. Engine cuts out and intermit stalls which then turns into crank no start. Besides the intermit stalling the engine will die if the throttle is fully press… read more
Ford Expert
Ford Expert
Service Technician
Vocational, Technical or Trade Scho
599 satisfied customers
I HAVE A 2003 FORD ESCAPE, IT IS HARD TO START AT TIMES COLD.
I HAVE A 2003 FORD ESCAPE, IT IS HARD TO START AT TIMES COLD. IT HAS A 3.O V6 AUTO TRANS,WITH 55000 MILES.PLEASE HELP.… read more
EMRSR
EMRSR
High School or GED
3,002 satisfied customers
Ford escape: intermittent..i have a V6 3L engine..fuel filter..reverse
hi i have a2004 ford escape that has a intermittent sputtering problem. i have a V6 3L engine and has 102000km. I have changed the fuel filter and plugs, The engine sputters sometimes in idle or while… read more
EMRSR
EMRSR
High School or GED
3,002 satisfied customers
I have a 2005 Ford Escape XLT with the 3.0L Engine. About
I have a 2005 Ford Escape XLT with the 3.0L Engine. About a month ago it started with a misfire on #4. I replaced the plug and COP and the trouble cleared. A couple of weeks later I got the same thing… read more
Kenny Z.
Kenny Z.
Ford Senior Master Tech
High School or GED
6,788 satisfied customers
Ford escape: drove..tail lights, door locks..dash lights..blower motor
i have a ford escape v six engine drove to wal mart shut off and now is dead. I have head lights,tail lights, door locks and that is all. no dash lights,starter, blower motor, radio. have checked fuse… read more
lostrider
lostrider
lead technician/working shop foreman
Vocational, Technical or Trade Scho
3,074 satisfied customers
2001 FORD ESCAPE: 4X4 AND THE BRAKE WARNING LIGHT..DIMMER..NEW.
I HAVE A 2001 FORD ESCAPE 6CYC 4X4 AND THE BRAKE WARNING LIGHT ON THE DASH IS ON VERY DIM. IT GRADUALLY GETS DIMMER OVER TIME AS YOU DRIVE BUT NEVER ACTUALLY GOES OUT. FLUID IF FULL, BRAKES ARE NEARLY… read more
Blue Oval Certified
Blue Oval Certified
Associate Degree
16 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

26,187 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Technician

31,725 satisfied customers

16 years experience

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

10 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Mike V.

Mike V.

Auto Service Technician

1,994 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,535 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x