Ford

Have Ford questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Ford Questions
1997 F250 HD 7.5l Starts great runs perfectly for about one
1997 F250 HD 7.5l Starts great runs perfectly for about one minute then runs rough and stops. MAP new, Distributor, new, Coil new … read more
Ethan Lankford
Ethan Lankford
Self Employed
Diploma
287 satisfied customers
How much? How much will this conversation cost? 95 E-150 4.9
95 E-150 4.9 I6 stumbling and stalling. Did this same thing last year, stumbling and stalling, overheated ICM, had to sit on the side for 10 minutes then it would start up and run. Changed Ignition Control Module, good for a bit, then the same. Went to plugs, wires, rotor, cap, new ICM, good for a bit, then the same. Changed distributor - all good. Now, 10 months later, stumbling and stalling (at times) at stop signs etc. Been a Ford Certified Parts, Service Manager for 10 years (10 years ago), but not totally Ford stupid. I will be buried in this van. I have an extra ICM, and may put it in tomorrow, but thought you might have another resolution.… read more
Ethan Lankford
Ethan Lankford
Self Employed
Diploma
287 satisfied customers
Having trouble with 1989 ford e350 charging systyem. New
Having trouble with 1989 ford e350 charging systyem … read more
Chad Farhat
Chad Farhat
Owner
Associate Degree
7,491 satisfied customers
It ran fine. I started it. Left for to while I was gone it
It ran fine. I started it. Left for to while I was gone it was left idle for 45 min. When I came back it wouldn't start and oil an out all on the ground. Tightened it up but still can't get it to run.… read more
Jaybird61
Jaybird61
Master Automotive Mechanic
2,721 satisfied customers
1994 E350/460 motor-No Start -no spark on negative side of
1994 E350/460 motor-No Start -no spark on negative side of coil (wht/pk wire from #3 on ICM) has voltage only when key in start, not in run. Do I have a bad ignition switch ??… read more
ASEMaster35yrs
ASEMaster35yrs
Vocational, Technical or Trade Scho
2,061 satisfied customers
ford: Hi I have removed starter switch wire from starter .1995
Hi I have removed starter switch wire from starter .1995 ford 460 ci Now my motor runs terrible when under a load. How do I get it back to running right?… read more
Mike S.
Mike S.
Vocational, Technical or Trade Scho
8,438 satisfied customers
1989 ford mustang: my battery , i have new grounds..it works fine
i have a 1989 ford mustang that has a 460 engine in it , my question is that my altenator isnt chargeing my battery , i have new grounds on the engine , and the altenator is a 2g for a 93 mustang i bo… read more
AlvinC
AlvinC
Ford Dealership Technician
Vocational, Technical or Trade Scho
1,238 satisfied customers
1995 taurus: 3.0 liter..wont stay running..Weather..20s deg F
1995 taurus with 3.0 liter standard engine-- suddenly won't stay running when cold. Battery is fine. Weather got colder, 20's deg F, which is contributing. Will start with throttle applied and stays r… read more
Anthony
Anthony
Master Automobile Technician
Vocational, Technical or Trade Scho
11,778 satisfied customers
ford f-250: 7.5 liter 460 ci motor..distributor..going bad..dist
I have a ford f-250 with the 7.5 liter 460 CI motor.... In the past three days, I've had to replace the distributor twice (I assume it's the pick up sensor that keeps going bad). What would cause the … read more
Pavlin Koev
Pavlin Koev
Diagnostic Technician
High School or GED
3,485 satisfied customers
1991 F250: TRUCK WAS RUNNING FINE DOWN THE ROAD AND just QUIT.
1991 F250 WITH 351 GAS EFI. TRUCK WAS RUNNING FINE DOWN THE ROAD AND JUST QUIT. WOULD NOT RESTART. THE NEXT MORNING TRUCK STARTED FINE ON FIRST CRANK. RAN FINE FOR A FEW MINUTES AND JUST QUIT AGAIN. W… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
26,187 satisfied customers
Engine turns..ignition control..core to distributor..possible eec
Engine turns over but, will not start. Has change ignition core and ignition control moduler still no spark out of core to distributor. Possible EEC-IV EFI? bad… read more
Ford Expert
Ford Expert
Service Technician
Vocational, Technical or Trade Scho
599 satisfied customers
changed coil.wires rotor cap icm .wont start with starter fluid .
changed coil.wires rotor cap icm .won't start with starter fluid . changed fuel tank selecter swith . will start and run well for 10-20 min. then die again . let sit , after a while will start again .… read more
Anthony
Anthony
Master Automobile Technician
Vocational, Technical or Trade Scho
11,778 satisfied customers
1991 Ford Ranger: running fine..started running..rough..intermittenly
I have a 1991 Ford Ranger 2.3 L. It was running fine and then one day it started running real rough. This happens intermittenly, but getting worse. I have looked at everything. Plugs only have 20,000 … read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
24,553 satisfied customers
1989 Ford Aerostar: 3.0L, V6, EFI, has a distributor and one coil
1989 Ford Aerostar, 3.0L, V6, EFI, has a distributor and one coil. Started just fine. Was backing out of my space, went 15 ft roughly, slowed down, preparing to shift into drive, engine died. Will cra… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
26,187 satisfied customers
My oil..check engine light came on..wiring diagram
My oil gauge stopped working, and the check engine light came on. The oild level is good so I know it's not that. Do you have a wiring diagram for the 7.5 L 460 FI engine? Where is the oil sending uni… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
31,725 satisfied customers
Ford: restart..there is no timing change with rpm change..defective
I have a 1997, Ford 7.5 Engine and a Ford Striped chasis that has an Endeavor Holiday Rambler 38 Ft Motor Built on the Chasis. I'm having trouble with the engine just stoping (as though it were out of… read more
HDGENE
HDGENE
7,808 satisfied customers
How do I diagnose and repair my 1990 Ford Rangers ...
How do I diagnose and repair my 1990 Ford Ranger's engine dying out? The Ford will Loose rpms and the engine will die. The Ford will coast to a stop. The Ford will not start after this. Five hours lat… read more
HDGENE
HDGENE
7,808 satisfied customers
1991 F250: with a 460..road..it tested fine but i..wont charge
i have a 1991 F250 Ford pickup with a 460 in it and well im having a problem with the eltrical i was driving it down the road and it died as if the altnator went out but i had it tested and it tested … read more
HDGENE
HDGENE
7,808 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

26,187 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Technician

31,725 satisfied customers

16 years experience

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

10 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Mike V.

Mike V.

Auto Service Technician

1,994 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,535 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x