Ford

Have Ford questions? Ask a mechanic for answers ASAP

Ask an Expert,
Get an Answer ASAP!

Related Ford Questions
I have a 1971 mach one mustang! I cant find the tach wire
I have a 1971 mach one mustang! I cant find the tach wire under the hood! I have pulled the tach and it has a red with green stripe and a green with red stripe. I assume I need the green with red to g… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,582 satisfied customers
The engine will not start if i let it set for several hours,
the engine will not start if i let it set for several hours, pulled the DTC 542, tested the relay, has 12 vdc ignition pin 30 and 12 vdc pin 85 i think, the side pin to energize the relay, with a fuel… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
25,182 satisfied customers
Keeps bending pushrods...has sat for ten years, 83 ford
ten years ago...recently 3 days but the bronco has sat for for 10 years years the bronco sat … read more
David Craig
David Craig
OWNER/MECHANIC
Associates
6,681 satisfied customers
Eric, i just had a re-manufactured AX4N trans installed in
Eric, i just had a re-manufactured AX4N trans installed in my 1995 Ford Taurus GL. After a run on the freeway, the car has lost first gear. If the shift lever is put to low, first gear works.… read more
Eric
Eric
Retired
N/A
33,756 satisfied customers
Ford Bronco XLT 5.0L/AOD: 1989 Ford Bronco with 5.0L/AOD 115,000
1989 Ford Bronco with 5.0L/AOD 115,000 miles- I bought a 5.8L from a wrecked 1994 Bronco that was just rebuilt and driven less than 400 miles. The Bronco is non-maf. Motor is complete ready to be drop… read more
kalamykid
kalamykid
Pactor automotive
Vocational, Technical or Trade Scho
5,448 satisfied customers
1985 Ford F-150: Super..Tach..the negative side of the coil
I have a 1985 Ford F-150. I am trying to install the Sunpro Super Tach III. I hooked the black to the negative side of the battery, the red to a spot that was off until I turned the key on, the green … read more
Kenny Z.
Kenny Z.
Ford Senior Master Technician
High School or GED
6,092 satisfied customers
1993 ford bronco: K&N..air intake..real good during test drive
I Have a 1993 ford bronco with 351 mostly stock. I instaled a K&N Performance air intake system. Ran real good during test drive. couple days later not running so good still runs but not good. No tach… read more
Brian
Brian
Ford Senior Master Certified Shop Forema
Vocational, Technical or Trade Scho
1,358 satisfied customers
88 ford bronco: pump relay..coil..crank and run fine and other times
My 88 ford bronco with a 351 won't run right. I've replaced the in tank pump and cleaned out the tank, replaced the filter, pressure regulator, pump relay and eec relay, and the pick up coil in the di… read more
HDGENE
HDGENE
6,647 satisfied customers
351 Windsor: engines..block..? intake manifold numbers..rebuild
i think i have 2 ford 351 Windsor engines...how can i tell for sure? and how do you tell if its a long or short block? ,& What years and models are are these out of? intake manifold numbers D70E-9425-… read more
Chuck
Chuck
ASE Certified Technician
Vocational, Technical or Trade Scho
1,685 satisfied customers
I have an 1993 X3Z EEC-IV with spark to new MSD dizzy..EFI..module
I have an 1993 X3Z EEC-IV with spark to new MSD dizzy but no spark out to plugs. This dizzy has a black rather than gray "push start" EFI module. Would this cause the no spark to plugs?… read more
rpmdiag
rpmdiag
High school
8,130 satisfied customers
1990 f250: / 300 6 cyl it has 200000 miles the coil went..little rough
I have a 1990 f250 w/ 300 6 cyl it has 200000 miles the coil went out last year. but before that it was running a little rough. I could never find the problem until the coil failed. after i replaced i… read more
breakaway500
breakaway500
Auto repair shop owner/operator
High School or GED
502 satisfied customers
1978 f150: Which 5 speed transmission can I replace my 4speed..cyl
Which 5 speed transmission can I replace my 4speed with than will work on my 1978 f150 4x4 300 six cyl (4.9)?… read more
Brian
Brian
Automotive Service Consultant/Technician
Bachelor Degree
780 satisfied customers
88 ford f250: it to convert fuel injection to carburation..block
how hard is it to convert fuel injection to carburation on a 88 ford f250 351 5.8 and block everything else off… read more
Brian
Brian
Automotive Service Consultant/Technician
Bachelor Degree
780 satisfied customers
90 Ford Bronco: wont start..intermittently..module, distributor
90 Ford Bronco 351m auto/air won't start. Loses spark intermittently. Replaced coil, module, distributor.… read more
Larry
Larry
Technical Editor
Bachelor's Degree
718 satisfied customers
351 windsor: swapped..a 1994 and if so, or are there any articles
gentlemen, has any one swapped in a 351 windsor in a 1994 and if so, or are there any articles published on how to do this?… read more
TechManSteve
TechManSteve
Associate Degree
74 satisfied customers
1990 Bronco: Ron..that had a 5.0 in it till the rings went
I am Ron and I have a 1990 Bronco that had a 5.0 in it till the rings went. I put a 5.0 HO in to replace it, and that was a trip. I replaced the distributor an rewired the plugs to a 351w wiring. Put … read more
ford dr
ford dr
senior master technician
Vocational, Technical or Trade Scho
184 satisfied customers
86 Bronco: rough..coil..distributor..the power control module
86 Bronco, 302, Fuel Injection. engine began to start rough and finally will no longer start. turns over but solid 12v @ negative post of coil (not pulsed) changed the distributor w/attached ignition … read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
19,601 satisfied customers
1990 ford f150: with 5.0 to miss and cause the tachometer to jump
what would cause my 1990 ford f150 with 5.0 to miss and cause the tachometer to jump around… read more
Ford Expert
Ford Expert
Service Technician
Vocational, Technical or Trade Scho
599 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

25,182 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Technician

29,223 satisfied customers

16 years experience

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

10 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Mike V.

Mike V.

Auto Service Technician

1,591 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,524 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x