Ford

Have Ford questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Ford Questions
I have a 1991 Ford Bronco 5.0 302. Problem is the truck runs
I have a 1991 Ford Bronco 5.0 302. Problem is the truck runs for 15 seconds and loses spark. I have replaced the ignition module, pick up coil, ignition coil, distributor cap, rotor, plugs n wires, co… read more
Vladimir Grodskiy
Vladimir Grodskiy
Automotive Electrician
Vocational, Technical or Trade Scho
2,765 satisfied customers
I have an 87 ford bronco 302 EEC IV EFI after starting up
I have an 87 ford bronco 302 EEC IV EFI after starting up shift into drive and the motor dies, coolant temperature reaches160°F motor wont restart. … read more
davehop
davehop
Diagnostic Technician
Ford Master Technician. Hyundai Master Technician
1,543 satisfied customers
Bronco 302: , I'm hooking up a used mustang 302 wiring harness
Hi, I'm hooking up a used mustang 302 wiring harness to a 70 Bronco 302 to install efi on the bronco. I'm pretty far along (I think) but am stuck on how to hook up the coil. The coil plug is obviously… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
26,041 satisfied customers
mustang: just replaced a 289 for a 302 ,i know idle should
just replaced a 289 for a 302 ,i know idle should be(NNN) NNN-NNNNrpm for the 289 . have a comp cam with 512 lift ,a stroker 331 ,gt40 heads . im guessing should be about the same .msd dist,and a msd … read more
Auto Psychic
Auto Psychic
owner
Bachelor's Degree
76 satisfied customers
91 ford bronco: stalls..the cap ,rotor..automatic transmission
My 91 ford bronco will start and run when you put in gear and give it gas it stalls.I have changed the cap ,rotor, plugs and wires,and it still stalls it's has a 302 with fuel injection and an automat… read more
Bob
Bob
Vocational, Technical or Trade Scho
205 satisfied customers
Bronco: efi..run fine..rough (like its not getting fuel) then die
I have a 1987 Full sized bronco 302 efi. When I go off-roading, the truck will run fine for a while then start to run rough (like its not getting fuel) then die. If I wait for a little while, it will … read more
Dodge expert
Dodge expert
ASE MASTER TECH, REPAIR FACILITY OWNER
High School or GED
3,636 satisfied customers
Ford F-150: Engine running very erratic...miss..cylinders for a second
Ford F-150 1987 302 with EFI. Engine running very erratic. Will run 2 or 3 seconds, miss on all cylinders for a second, then run on all for several seconds. Will run normal on cold start for 10 minute… read more
Anthony
Anthony
Master Automobile Technician
Vocational, Technical or Trade Scho
11,778 satisfied customers
bronco: XLT..stock 5.0 efi engine and eod trans aslo stock..new motor
i have a 87 full size bronco XLT w/stock 5.0 EFI engine and eod trans aslo stock.i want to put a 302 or a stroked 302(331) in place of the stock engine.the new motor (s) are much higher horespower.i h… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
26,041 satisfied customers
2001 Ford escape: spark plugs..EGR valve, Check for vacum leaks..Ron
I have 2001 Ford escape V6 , It want idle properly any time of the year but it is much worse in the winter. I have replaced the spark plugs , EGR valve, Check for vacum leaks . Do you have any ideas I… read more
Pawel
Pawel
Auto Technician
Vocational, Technical or Trade Scho
107 satisfied customers
1983 mustang: GT...msd Blaster coil, msd Distributor cap and rotor
I have a 1983 Mustang GT. Replaced the motor with a stock 302 with Holley 750,dual feed, vac. secondaries, MSD Blaster coil, MSD Distributor cap and rotor. Still has the stock electronic ignition. Mot… read more
A. Penland
A. Penland
Ford Senior Master Technician
Vocational, Technical or Trade School
7,590 satisfied customers
77 Ford Bronco: the ignition coil off the engine block..mount..fender
I have a '77 Ford Bronco with a 302. Can I move the ignition coil off the engine block and mount it someplace else, like the inner fender well? If so, will this make it easier to start after the engin… read more
Anthony
Anthony
Master Automobile Technician
Vocational, Technical or Trade Scho
11,778 satisfied customers
I have an 1993 X3Z EEC-IV with spark to new MSD dizzy..EFI..module
I have an 1993 X3Z EEC-IV with spark to new MSD dizzy but no spark out to plugs. This dizzy has a black rather than gray "push start" EFI module. Would this cause the no spark to plugs?… read more
rpmdiag
rpmdiag
High school
8,742 satisfied customers
1978 Ford F250 pickup: vacuum diagram..new electronic ignition..msd
I have a 1978 Ford F250 pickup with a 1987 460 motor. I need a vacuum diagram and also a suggestion for a new electronic ignition, i.e., Mallory, MSD, or ???… read more
ase_master327
ase_master327
Owner & Student
High School or GED
3,214 satisfied customers
ford bronco: distributor..msd..top dead center and set timing? thanks
how to install a new billet distributor and msd 6a multispark box in a ford bronco with a 302ci engine. how to find top dead center and set timing? thanks!… read more
Vincent
Vincent
Automotive Technician
High School or GED
808 satisfied customers
bronco: getting fuel..spark plug wires..ignition coil..about 11 volts
my bronco will not start, the starter turns over the engine and its getting fuel. i''ve replaced the distributer cap and rotor, spark plug wires, spark plugs, and ignition coil. i know the distributer… read more
ase_master327
ase_master327
Owner & Student
High School or GED
3,214 satisfied customers
1992 Ford Bronco: full size..V8..able to start my truck..few minutes
I have a 1992 Ford Bronco fullsize with a 302 V8 5.0 . I am able to start my truck and it will Idle for a few minutes then it will die. I am able to start it back up but it dies again. I have to depre… read more
Mo
Mo
Vocational, Technical or Trade Scho
Bronco: full size..having problems starting..both fuel pumps and you
I have a 1989 fullsize bronco with a 302 engine. I'm having problems starting it. I replaced both fuel pumps and you can here then running. It cranks over and it won't start but the exaust smells like… read more
Sparkybuoy
Sparkybuoy
Vocational, Technical or Trade Scho
192 satisfied customers
79 bronco: I just swapped in a used 400..Part Number..ran great..miss
I have a 79 bronco I just swapped in a used 400 and put my comp cam Part Number 32-221-3 along with valve springs I also added a msd billet distributer and ignition 6a . It ran great for about 2 hours… read more
ase_master327
ase_master327
Owner & Student
High School or GED
3,214 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

26,041 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Technician

31,374 satisfied customers

16 years experience

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

10 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Mike V.

Mike V.

Auto Service Technician

1,937 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,535 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x