Ford

Have Ford questions? Ask a mechanic for answers ASAP

Ask an Expert,
Get an Answer ASAP!

Related Ford Questions
Early 04 F450 6.0l. No start after fuel filter change.
Early 04 F450 6.0l. No start after fuel filter change. Confirmed fuel fills filter canister during crank. Confirmed HPOP fills filter canister during crank. Unconfirmed oil pressure at ICP I ran a sca… read more
HDGENE
HDGENE
6,602 satisfied customers
2005 F250 w/ 6.0 is throwing the code P1378 FICM Supply
2005 F250 w/ 6.0 is throwing the code P1378 FICM Supply Voltage Circuit Low. I am just now unsure of where to start troubleshooting from there. What could be the source of my problem? … read more
JOHN aka Eauto
JOHN aka Eauto
self employed
High School or GED
10,842 satisfied customers
F-350 Super Duty (DRW): I have a 2004 F-350 Super duty (6.0
I have a 2004 F-350 Super duty (6.0 Powerstroke) that won't start. I am a long haul truck driver. Ran the truck about 250km home from work back around the end of April and it was working perfectly. Tr… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
29,223 satisfied customers
i have 06 ford f250 6.0 diesel that has a ficm problem. It
i have 06 ford f250 6.0 diesel that has a ficm problem. It will not start and i have my scanner hooked up and ficm MP i only have battery voltage 12volts not 45 like idenifix says i should. I have che… read more
Scott W.
Scott W.
Diesel, Automatic trans, full line tech
Associate Degree
3,655 satisfied customers
2005 F350 6.0 Diesel ...truck is pulsing, when warm.When engine
2005 F350 6.0 Diesel ...truck is pulsing, when warm.When engine is hot, drives about one mile before it dies. Engine is pulsing/surging. When it cools off, it starts right up, and the cycle repeats. I… read more
Scott W.
Scott W.
Diesel, Automatic trans, full line tech
Associate Degree
3,655 satisfied customers
2004 F350: Ignition, glow plug light comes on then goes off..cranks
2004 F350 Diesel. When I get in turn on Ignition, glow plug light comes on then goes off. Unit cranks no start. If I plug heater in for about an hour truck will start and start ok for rest of day. I s… read more
John Crouch
John Crouch
lead senior master tech
Vocational, Technical or Trade Scho
1,840 satisfied customers
2005 f-250: My truck..wont start..starts right..accelerator also
My truck is a 2005 f-250 with a 6.0L diesel it some times won't start and when I get it started it runs very low RPMs down around 500 but if I let it sit over night and let the fuel pump cycle 3 times… read more
Scott W.
Scott W.
Diesel, Automatic trans, full line tech
Associate Degree
3,655 satisfied customers
F-350: EGR valve..smooth..i drove it around few blocks..wont start
My F-350 6.0 was running rough(after having all my injectors replaced) so I cleaned my EGR valve. Started it back up and it began running smooth again. So i drove it around few blocks and returned to … read more
DieselTech422
DieselTech422
Technician
High School or GED
123 satisfied customers
f250: 6.0 diesel..8 injector circuit codes..cylinder
Working on a 03 F250 6.0 diesel. I have 8 injector circuit codes P261,264,267,270,273,276,279,282. Also cylinder contribution codes P0275,281 plus 2 ex press codes P0471 & 472 if my memory serves me c… read more
SuperBob
SuperBob
Ford dealer senior master technician
Vocational, Technical or Trade Scho
2,603 satisfied customers
FORD: LOW VOLTAGE INJECTOR CIRCUT..LT..TURBO..COLD START
LOW VOLTAGE INJECTOR CIRCUT FOR FORD 6 LT TURBO DESIL CODE CAME UP AND TRUCK WONT COLD START PLEASE HELP… read more
Scott W.
Scott W.
Diesel, Automatic trans, full line tech
Associate Degree
3,655 satisfied customers
2003 Ford F-250: a 6.0 Diesel,scanner..cam sensors..cranks fine
I am working on a 2003 Ford F-250 with a 6.0 Diesel,scanner showed crank and cam sensors bad replacd both cleared codes and now cranks fine ,no codes but no start.John… read more
John Crouch
John Crouch
lead senior master tech
Vocational, Technical or Trade Scho
1,840 satisfied customers
2003 ford f 250: cranking..very rough idle...now..previous owner
my 2003 ford f 250 6/0 L engine died...changed fuel flter, oil , filter, 10k ago ... replaced the battery's as they were not holding a charge or cranking the truck.... it ran just barely yesterday and… read more
jwhitehouse
jwhitehouse
Sr. Master Diesel & Gasoline Technician
Associate Degree
59 satisfied customers
f250: it acts..noticable..but very noticed cruising at highway speeds.
i have an 05 f250 6.0 and it acts like it is missing. it is not noticable at idle or under acceleration. but very noticed cruising at highway speeds. ran the codes and got PO266 cyl 2 contribution, PO… read more
Scott W.
Scott W.
Diesel, Automatic trans, full line tech
Associate Degree
3,655 satisfied customers
f350: injector..truck started and ran,drove for a few miles fan
working on 06 f350 with 6.0 would not start scaned it received all8 injector codes fuel gage looked low,added 5gal of fuel cleared codes, truck started and ran,drove for a few miles fan just fine,shut… read more
Dieseljunky2
Dieseljunky2
Locomotive Mechanic
Ford Certified Technician
409 satisfied customers
2005 ford: got reading po264,267,282,279..fuel injector connection
2005 ford got reading po264,267,282,279. took the fuel injector connection off blowed air it then reconnnect . reset the truck. Went about 75 miles the light came on again.but now I one more cycl code… read more
Shawn E
Shawn E
Ford Senior Master Dealership Technician
Associate Degree
144 satisfied customers
Vehicle started smoking badly, diagnostics..Injectors
vehicle started smoking badly, diagnostics showed excessive fuel being supplied to two cylinders.. Injectors were checked and two were identified as defective. Replaced both. Upon testing the vehicle,… read more
Shawn E
Shawn E
Ford Senior Master Dealership Technician
Associate Degree
144 satisfied customers
Im having injector circuit..cylinders..glow plug..Crankshaft position
Im having injector circuit low in all 8 cylinders. glow plug #2 circuit failure and my dianostics reading is saying Crankshaft position signal output circopen and crankshaft pos sensor a circuit range… read more
314
314
Associate Degree
108 satisfied customers
Vin..miss..shake..it reaches full running temp, not just warming
I have an 04 Vin # XXXXX It jerky like a miss but fast enough and strong enough that it makes thevibrate and shake. It will do this until it reaches full running temp, not just warming up a bit, but a… read more
lostrider
lostrider
lead technician/working shop foreman
Vocational, Technical or Trade Scho
3,074 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

25,182 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Technician

29,223 satisfied customers

16 years experience

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

10 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Mike V.

Mike V.

Auto Service Technician

1,591 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,524 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x