Ford

Have Ford questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Ford Questions
Cannot get my 1996 Ford Explorer Eddie Bauer edition out of
Cannot get my 1996 Ford Explorer Eddie Bauer edition out of 4wd low. I've got the lite to go off so it shows its in 2wd and I can go forward in drive but when I put it in reverse it grinds really loud… read more
Chad Farhat
Chad Farhat
Owner
Associate Degree
6,162 satisfied customers
Ford Escape I have a 2001 ford escape manual transmission
I have a 2001 ford escape manual transmission with 245,000 miles on it. My father just replaced the lower ball joint and axle, and now we are having problems with 1st and 2nd gear. They dont actually … read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
29,223 satisfied customers
97 ford explore sport: highway i..gas pedal it stoped..wheel drive
i have a 97 ford explore sport the other night when i was on the highway i took my foot off the gas and heard a winding noise when i put my foot back on the gas pedal it stoped and now i cant get myXX… read more
Scottdagoalie
Scottdagoalie
Vocational, Technical or Trade Scho
1,939 satisfied customers
2003 Ford Expedition XLT: just put itself into 4WD Low and wont come
My 2003 Ford Expedition XLT just put itself into 4WD Low and won't come back out, no matter what I do. Any ideas???? It is an emergancy, i am leaving on vacation tomorrow.… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
29,223 satisfied customers
2008 F 350: skid..fuel tank..two existing trans bolts and replace
I have purcased ford skid plates AND mounting hardware for my 2008 F 350 ( transmission and fuel tank)...after 18 &&^%%$ trips under the vechicle it is still not clear where they go....transmission fr… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
29,223 satisfied customers
99 f-250: v10..mounting bolts..cant remove the ac compressor what
i am having trouble getting my ac compressor out of my 99 f-250 v10 one of the mounting bolts comes in contact with the crossmember before it is unthreaded so i cant remove the ac compressor what is t… read more
RJ
RJ
Ford Tech
High School or GED
1,573 satisfied customers
99 explorer: the 4wd was switched on when it..light stays
I have a 99 explorer and the 4wd was switched on when it shouldnt have been. It will not get out of 4wd. I switched it back to auto but the light stays on. what can i do?… read more
Scottdagoalie
Scottdagoalie
Vocational, Technical or Trade Scho
1,939 satisfied customers
1995 ford explorer: v6..tranny..rebuilt..the bolts and wiggle it
I have a clunking noise comming from under my 1995 ford explorer v6 4.0 ltr manuanl tranny. what transfer case do i need ( part n umber) can they be rebuilt and I do my own work but I am no mechanic c… read more
Ed
Ed
Vocational, Technical or Trade Scho
114 satisfied customers
1998 ford explorer 4x4: control arm..drivers side..front cam bolt came
we are replacing the upper control arm on the drivers side of a 1998 ford explorer 4x4. the front cam bolt came out easy but the rear one does not come out far enough. It seems as its hitting the fram… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
29,223 satisfied customers
I have a 1995 Ford Explorer 4WD Automatic. What do I have ...
I have a 1995 Ford Explorer 4WD Automatic. What do I have to do to get the starter out? Other than removing the 2 bolts and the wiring.… read more
Richard
Richard
ASE Certified Technician
Vocational, Technical or Trade Scho
1,524 satisfied customers
97 explorer xlt: 4.0 6cyl, auto transmission..transfer case..dash
Hello, i have a 97 explorer xlt 4.0 6cyl, auto transmission. The transfer case is bad. It has the auto 4wd, hi ,and low,4wd switch on the dash. The numbers are F77A-7A195-GA. (7GA), it has the six hol… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
29,223 satisfied customers
I have a 1997 Ford F150 4x4 AT 4.2Lt. Im removing the bad motor.
I have a 1997 Ford F150 4x4 AT 4.2Lt. I'm removing the bad motor. I am to the point were I have to remove the engine to trans bolts but don't have the clearance to get my hand and tools in to remove t… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
29,223 satisfied customers
1994 Ford Ranger 3.0 l. Replacing clutch, can you show step by step.
1994 Ford Ranger 3.0 l. Replacing clutch, can you show step by step. having getting upper bolts, for bell housing out. not much room any ideas?… read more
Fordster
Fordster
Mastertech
Vocational, Technical or Trade Scho
2,650 satisfied customers
94 Ford Explorer: able to be towed 4 wheels down behind an RV.
Is a 94 Ford Explorer auto able to be towed 4 wheels down behind an RV. What modifications if any are required.… read more
ford dr
ford dr
senior master technician
Vocational, Technical or Trade Scho
184 satisfied customers
1996 FORD: HUBS..DRIVE SHAFT..THE TRANSFER CASE TURNS..WHEEL DRIVE
I HAVE A 1996 FORD 350 DIESEL 4X4 PICKUP WITH MANUAL HUBS. WHEN YOU TURN THE HUBS TO THE LOCK POSITION AND PUT IT INTO 4H, THE DRIVE SHAFT FROM THE TRANSFER CASE TURNS BUTXXXXXDOES NOT WORK. ALSO THE … read more
ford dr
ford dr
senior master technician
Vocational, Technical or Trade Scho
184 satisfied customers
91 ford ranger XLT: stop working..fuel tank..haynes repair manual
I have a 91 ford ranger XLT, the fuel indicate stop working. It sound like something can loose in the fuel tank. I have the Haynes repair manual and try to remove the tank. The tank hit the rear axel … read more
Virtual Wrench
Virtual Wrench
Owner of LJ Auto Repair 37 years
Associate Degree
14,398 satisfied customers
1998 ford f150: step directions to replace my transfer case motor
Where can i get step by step directions to replace my transfer case motor for a 1998 ford f150 4x4?… read more
ase_master327
ase_master327
Owner & Student
High School or GED
3,214 satisfied customers
1996 Explorer: a way to loosen the nuts on the top of the shocks
I am trying to replace the shocks on my 1996 Explorer. The front ones came off and went on fine. My problem was when I went to replace the back ones I can't seem to find a way to loosen the nuts on th… read more
Brian
Brian
Automotive Service Consultant/Technician
Bachelor Degree
780 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

25,182 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Technician

29,223 satisfied customers

16 years experience

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

10 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Mike V.

Mike V.

Auto Service Technician

1,591 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,524 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x