Ford

Have Ford questions? Ask a mechanic for answers ASAP

Ask an Expert,
Get an Answer ASAP!

Related Ford Questions
I have a leaking power steering reservoir hose to the pump.
I have a leaking power steering reservoir hose to the pump. on my car... can I use a rubber hose the same size that perhaps advanced auto has .… read more
cardoctor71
cardoctor71
Owner
High school graduate
51 satisfied customers
Ford Escape Limited, 3.0cyl, 4wd: 2008 Ford Escape ABS Control
2008 Ford Escape ABS Control module assembly is bad, according to Ford dealership. My ABS, Brake and Traction lights are all on. I believe the issue was caused by an attempt to charge the battery and … read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
29,223 satisfied customers
2002 ranger: wheel drive..gears while driving..clutch master..slave
2002 ranger 4 cylXXXXX grinds a little going into gears while driving. clutch master cyl. full and has good travel at slave cyl. (approx 3/8"). this morning got stuck in nuetral while driving and tryi… read more
John Mc
John Mc
Ford Technician
Vocational Trade School
5,495 satisfied customers
1997 Ford explorer: 2 dr. 5 speed manual 162,000 miles..clutch
1997 Ford explorer 2 dr. 5 speed manual 162,000 miles. New clutch at 100,000. Now very hard to shift/get in gear. Replaced clutch, still hard to shift. WHERE TO GO FROM HERE? More bleeding?… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
25,022 satisfied customers
2003 FORD: THE PART NUMBER FOR THE FUEL LINE RUNNING FROM..BOLT..TURBO
2003 FORD E350 CARGO VAN 7.3 DIESEL . NEED TO IDENTIFY THE PART NUMBER FOR THE FUEL LINE RUNNING FROM THE INSIDE REAR OF THE RIGHT SIDE HEAD THAT HAS A BOLT SECURING IT AS IT RUNS UNDER THE TURBO… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
29,223 satisfied customers
1999 Ford F250 super duty: diesel..The clutch pedal is sticking
I have a 1999 Ford F250 super duty diesel. It is a five speed manual transmission. The clutch pedal is sticking to the floor and will not disengaged the clutch. What is the problem and what are the pr… read more
HDGENE
HDGENE
Master Technician/Lead Technician
Associate Degree
2,835 satisfied customers
Ford ranger: no clutch at all,I bleed the master cylinder
Ford ranger 98XXXXXand 4 cylinder . I have no clutch at all,I bleed the master cylinder but I did not see a decent amount of fluid,I follow the instruction by the book but no result. What else can be … read more
Steve W
Steve W
Line Technician
Vocational, Technical or Trade Scho
1,968 satisfied customers
1996 Ford F150: 2nd gear..they bled the clutch master cyl..slave
I have a 1996 Ford F150, 5-speed, 5.0, 302. Last week it started shifting hard into low gear, by the end of the day it wouldn't go into 1st or 2nd gear at all and the clutch was very soft. I took it i… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
25,022 satisfied customers
2007 ford focus: that came with power steering whining..leaks
We have a 2007 ford focus that came with power steering whining. I could not find any leaks or other problems so i assumed that the vane's were causing a cavatation so we replaced the pump now everyti… read more
eauto
eauto
self employed
High School or GED
74 satisfied customers
1997 ford aerostar: van..cyl engine..windshied wipers..back down
I have a 1997 ford aerostar, X-postal van It has a4 cyl engine and AWD. The windshied wipers do not work Got them to move up but will ,not move back down. Has tilt wheel that moves feels loose will pu… read more
Dieseljunky2
Dieseljunky2
Locomotive Mechanic
Ford Certified Technician
310 satisfied customers
1997 f150: blew..cylinders..i replaced the fron calipers..peddle
I have a 1997 f150 4.6 i blew a brake line so i replaced all the rear brake lines and rear brake cylinders. Sience i was doing that i replaced the fron calipers. I cant get the peddle to stay hard. I … read more
HDGENE
HDGENE
Master Technician/Lead Technician
Associate Degree
2,835 satisfied customers
97 ford f-150: cab..v..the trans fluid and screen,new fuel filter
i have a 97 ford f-150 club cab lariet with the small v-8. i changed the trans fluid and screen,new fuel filter . tk has 117258 miles. ran great then i got a ck engin light and took it to auto zone. t… read more
Expert-Repair
Expert-Repair
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
11 satisfied customers
03 Focus: wagon..a new (clutch) master cyclinder unit..pedal
Mine is an '03 Focus wagon. I just purchased and installed a new (clutch) master cyclinder unit, bleeding it of all air in the line the conventional way. However, the unit will not pressurize when the… read more
Don
Don
Shop Forman, lead tech
Vocational, Technical or Trade Scho
869 satisfied customers
Ford: trans..pedal..it still will not engage in gear, the clutch is
I have a Ford truck and I replace the slave cylinder because it would not shift when I remove the trans I notice that the cylinder was jam now that i installed the new one I can not bleed it right I h… read more
APenland
APenland
Ford Senior Master Technician
Associate in Industrial Management
3,186 satisfied customers
Ranger: Ive heard..clutch was recently replaced so I
Help!!! Cant get clutch to work in a 93' Ranger. Ive heard this can be diffcult. Replaced transmission - clutch was recently replaced so I did not replace it. I broke the line between the clutch maste… read more
Don
Don
Shop Forman, lead tech
Vocational, Technical or Trade Scho
869 satisfied customers
1999 Ford Ranger: hydrolic..clutch barring bleed the brakes put trans
1999 Ford Ranger i need to get pressure into my hydrolic clutch i dropped trans put a clutch barring bleed the brakes put trans back cant get the clutch to have pressure… read more
Tim
Tim
Associate Degree
3,172 satisfied customers
Ford F150: ..recently my slave cyl was..clutch..bleeder
I have a 02 Ford F150 4wh..recently my slave cyl was empty, i filled it up and now a day later, my clutch goes to the floor and will not me shift....is there a bleeder or an adjuster?… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
29,223 satisfied customers
1999 ford ranger slave cyl bleeding procedure,clutch will ...
1999 ford ranger slave cyl bleeding procedure,clutch will not release till pedal is on the floor. I bled cyl per manual and also pryed back and forth on release bearing per tech line, still pedal is n… read more
stefano
stefano
Auto Technician
Vocational, Technical or Trade Scho
236 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

25,022 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Technician

29,223 satisfied customers

16 years experience

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

10 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Mike V.

Mike V.

Auto Service Technician

1,591 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,524 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x