Ford

Have Ford questions? Ask a mechanic for answers ASAP

Ask an Expert,
Get an Answer ASAP!

Related Ford Questions
The electrical connection/slide for the rod that attaches to
The electrical connection/slide for the rod that attaches to the clutch pedal -slave cylinder is not coming off when I try to remove it. It is on a 95 Ranger. … read more
Jaybird61
Jaybird61
Master Automotive Mechanic
2,460 satisfied customers
My 1996 ranger manual clutch was just replaced, but it
my 1996 ranger manual clutch was just replaced, but it doesn't engage until the pedal is almost touching the firewall. That seems wrong to me. … read more
Steve Jensen
Steve Jensen
Service Manger/ Lead Technician
High School or GED
422 satisfied customers
2001 ford ranger edge v6 two wheel drive 5 speed manual
2001 ford ranger edge v6 two wheel drive 5 speed manual transmission. Wont move forward or back. swapped out transmission clutch and pressure plate and clutch master and slave cylinder. same problem … read more
Eric Hammond
Eric Hammond
Ford Senior Master Technician
Associate of Science
44 satisfied customers
I have a 91 ranger 4.0 v6 manual transmission 4x4. When it
I have a 91 ranger 4.0 v6 manual transmission 4x4. When it is warmed up it pings under load. No codes, I put 180 degree thermostat in, flushed cooling system, 104 octane boost. Have replaced AIT senso… read more
Jaybird61
Jaybird61
Master Automotive Mechanic
2,460 satisfied customers
I have a 2004 Ford Ranger with a 3.0L engine 8th VIN#U. I
I have a 2004 Ford Ranger with a 3.0L engine 8th VIN#U. I switched the engine in the truck with a 2001 ford Taurus FFV 3.0L engine and truck will not run. What can I do to get the truck to run? Do I n… read more
John Vieira
John Vieira
Heavy Duty Diesel Mechanic
63 satisfied customers
1991 Ford Ranger 4x4 with manual trans, 110K miles, has
1991 Ford Ranger 4x4 with manual trans, 110K miles, has front end noise (spinning whirling scraping sound) when powering up or slowing down with clutch engaged. The truck has recently had a new clutch… read more
kalamykid
kalamykid
Pactor automotive
Vocational, Technical or Trade Scho
5,398 satisfied customers
Not much free pedal on the clutch. 99 ranger xlt. Look for
look for adjustment under the dash and by the bell housing … read more
A. Penland
A. Penland
Ford Senior Master Technician
Vocational, Technical or Trade School
7,105 satisfied customers
87 ford ranger 2.9L code 18. 018 & yes it has been erased
018 & yes it has been erased several times but keeps coming back during koeo test … read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
25,022 satisfied customers
My 87 ford f250 pu with 460 motor has a fatique problem with
my 87 ford f250 pu with 460 motor has a fatique problem with the firewall which effects the clutch … read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
25,022 satisfied customers
I have 2004 ford ranger edge 3.0 v6, it was jerking when
I have 2004 ford ranger edge 3.0 v6, it was jerking when shifting and then couple hours later i turned it on and it would go on gear but i had to accelerate really high to get it to move. Well i left … read more
JOHN aka Eauto
JOHN aka Eauto
self employed
High School or GED
10,838 satisfied customers
Is there a secret to pulling the bottom part of clutch
Is there a secret to pulling the bottom part of clutch safety switch out of a 2004 Ford Ranger? I was able to pop the to part off of the clutch pedal, but the bottom part that goes into the firewall (… read more
A. Penland
A. Penland
Ford Senior Master Technician
Vocational, Technical or Trade School
7,105 satisfied customers
Ford Ranger: he added that, and it still doesnt work..clutch pedal
The clutch on my son's Ford Ranger pickup is not working. He discovered that the clutch fluid was out, so he added that, and it still doesn't work. He depresses the clutch pedal, and there's no pressu… read more
Canadafix
Canadafix
Auto shop owner
Vocational, Technical or Trade Scho
1,507 satisfied customers
98 ford ranger: liter engine needing a new pressure damper
I have a '98 ford ranger 3 liter engine needing a new pressure damper. I'm told it is "obsolete"? They make parts for autos much older than this! I put the part # XXXXX right off the part to the manuf… read more
A. Penland
A. Penland
Ford Senior Master Technician
Vocational, Technical or Trade School
7,105 satisfied customers
I cannot find the egr valve on my 2003 ford ranger. It is apparently
I cannot find the egr valve on my 2003 ford ranger. It is apparently stuck open and the truck won't run. (Similar to my former problem with my iac valve). Is there a quick fix for closing this valve a… read more
A. Penland
A. Penland
Ford Senior Master Technician
Vocational, Technical or Trade School
7,105 satisfied customers
Fuel pump..Ignition switch, Clutch, Master Cylinder Starter
My mechanic says I need a new fuel pump. Cost $791.37. In the last 14 months; since going to him, I have had to replace Motor mounts, Ignition switch, Clutch, Master Cylinder Starter, Radiator hose an… read more
A. Penland
A. Penland
Ford Senior Master Technician
Vocational, Technical or Trade School
7,105 satisfied customers
1997 f-250: powerstroke..plastic grommet that wears..standstill..worn
I have a 1997 f-250 Powerstroke that shifts with difficulty, so replaced the plastic grommet that wears out. It shifts much better but still is difficult from a standstill to shift into first or secon… read more
Tech Xpert
Tech Xpert
National Technical Consultant
Associate Degree
161 satisfied customers
2000 windstar: check engine light came..leak..intake
I have a 2000 windstar with a 3.8, I took it to ford when the check engine light came on and they told me that it was a low air reading on bank 2. and that it would cost me 700.00 to repair. Afterward… read more
Wrenchtech
Wrenchtech
Vocational, Technical or Trade Scho
616 satisfied customers
1999 ford ranger 4x4: V6 4 wheel abs My ranger vibrates..cam..bolts
1999 ford ranger 4x4 3.0L V6 4 wheel abs My ranger vibrates badly. A mechanic told me to replace these parts: --lower ball joints, upper ball joints and cam bolts --upper A arms I'm having trouble fid… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
29,223 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

25,022 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Technician

29,223 satisfied customers

16 years experience

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

10 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Mike V.

Mike V.

Auto Service Technician

1,591 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,524 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x