Connect one-on-one with a Ford mechanic who will answer your question
Expert avatar
Ron, ASE Certified Technician
25,256 satisfied customers
23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs
Pearl avatarPearl Wilson, Assistant
4 Ford Mechanics are Online Now

Ford repair questions?

Verified Ford mechanics are online around the clock and ready to answer your question online or by phone. 
Related Ford questions
2008 ford f250 ac not cooling. Installed freon and checked
2008 ford f250 ac not cooling. Installed freon and checked gauges low side was between 30 and 35. But the high side just keeps climbing i shut of the car at 450. I dont see any aux fans for the ac so … read more
Richard Greer
Richard Greer
Vocational, Technical or Trade School
239 satisfied customers
Oil press. Fell to zero on manuel gauge. 100000 no On
Oil press. Fell to zero on manuel gauge. 100000 no On engine. Put a new ford pump on an 49 lbs on starter and 80 lbs cold running. Is it ok? … read more
HDGENE
HDGENE
Master Technician/Lead Technician
Associate Degree
2,835 satisfied customers
1998 Ford Expedition, 4 x 4, 5.4 engine. The windshield
1998 Ford Expedition, 4 x 4, 5.4 engine. The windshield wipers and washer comes on when the car is started. Turn the car off and restart it and they stay off. The ignition switch, windshield wiper mot… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
29,401 satisfied customers
I have a 2000 ford expedition. I have an error code P0171 &
I have a 2000 ford expedition. I have an error code P0171 & P0174 for lean mixture. I spotted an oddly placed port on the top of the fuel rail. I'm looking for a diagram to see if there's a vaccuum li… read more
A. Penland
A. Penland
Ford Senior Master Technician
Associate in Industrial Management
3,186 satisfied customers
A friend changed the crank shaft sensor. And now the car
a friend changed the crank shaft sensor. And now the car sounds like it's running hard a lot of smoke was coming out of the muffler and it starts runs for a little bit then dies out. Idk I'm stuck … read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
29,401 satisfied customers
7.3 99 e350 not starting had new processor installed in
7.3 99 e350 not starting had new processor installed in computer he said now good dim was good also no wait to start light when turn key starter won't turn over … read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
29,401 satisfied customers
I have changed o2 sensor, pressure regulator, mass air, can,
I have changed o2 sensor , pressure regulator, mass air, can, crank, fuel pump and it still stalls like its trying to run on water … read more
eric remington
eric remington
FORMER SHOP OWNER/TECHNICIAN/INSPECTOR
associates degree
1,010 satisfied customers
I went to get in my Ford last night and it started but all
I went to get in my Ford last night and it started but all my lights came on the dashboard and I could not shift my gears as well as the fuel dial stayed down instead of going up since I have a full t… read more
Pete
Pete
Independent Auto Technician
Vocational, Technical or Trade Scho
138 satisfied customers
How do I remove the right side glove box pin on 2015 ford
How do I remove the right side glove box pin on 2015 ford explorer limited? I replaced the cabin air-filter and the right side of the glove box somehow came off the pin and now I can't remove the pin … read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
25,256 satisfied customers
98 Ranger 3.0 fuel regulator needs replacement, but nothing
98 Ranger 3.0 fuel regulator needs replacement, but nothing seems available. Parts I've ordered do not fit. … read more
eric remington
eric remington
FORMER SHOP OWNER/TECHNICIAN/INSPECTOR
associates degree
1,010 satisfied customers
Where is port located to add refridgerent. My gas gauage is
where is port located to add refridgerent JA: Okay, I'll connect you to the mechanic to go over that information regarding your Ford. Before I do, is there anything else you want him to know? Customer… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
29,401 satisfied customers
My advancetrac and abs sensor is on and I have a really hard
Good morning Chris my advancetrac and abs sensor is on and I have a really hard time steering can u help me fix it … read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
29,401 satisfied customers
I just purchased a factory air relay and for the love of God
I just purchased a factory air relay and for the love of God I can't find where it is located on my 2010 f150 … read more
HDGENE
HDGENE
Master Technician/Lead Technician
Associate Degree
2,835 satisfied customers
2011 Ford Fusion, 3.0L V6 160K miles, whining noise while
2011 Ford Fusion, 3.0L V6 160K miles, whining noise while accelerating in lower gears matches engine RPM. Took it to a trans shop that I trust, he said it wasnt the trans and replaced the alternator, … read more
A. Penland
A. Penland
Ford Senior Master Technician
Associate in Industrial Management
3,186 satisfied customers
I have had my Ford Explorer in Port Richey Florida since May
I have had my Ford Explorer in Port Richey Florida since May 2018 . They stated that the Module was out and needed to be replaced. They have received three rebuilt modules from Detroit and none were r… read more
EricFromCT
EricFromCT
Auto Technician
589 satisfied customers
I have a 1990 Ranger XLT 4X4, 4.0L OHV engine. It had a
I have a 1990 Ranger XLT 4X4, 4.0L OHV engine. It had a cracked head between the valves on #3 cylinder. I decided to replace the heads. When I tore the engine down, I discovered that all 12 pushrods &… read more
roy
roy
shop foreman
Associate Degree
3 satisfied customers
Cant turn off the rearview mirror lights. Rearview mirror
Pushing right and left buttons to the up and down posititions … read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
29,401 satisfied customers
1992 Ford Bronco passenger window doesn't work.I had changed
1992 Ford Bronco passenger window doesn't work.I had changed the motor and it worked for a few days, then stopped working again. The passenger switch worked, then stopped working. I was able to close … read more
Mechanic01
Mechanic01
3,624 satisfied customers

Common Ford questions resolved on JustAnswer


Other Ford problem questions include:


  • Where is the transfer case control module located in my 2002 Ford Explorer truck?
  • Why isn’t the power door lock on the passenger side of my 2004 Taurus station wagon no longer working?
  • What’s causing the thumping sound from the front suspension of my 2010 Ford Flex?
  • Why does the Low Oil Pressure signal beep constantly in my 2013 Ford Edge?
  • Is it worth paying $150 to diagnose why my 2006 Mustang panic alarm keeps going off?

The Ford experts at JustAnswer are ready at any time, day or night, to answer questions, and they have helped both owners and other mechanics.


When you want to consult with an Expert at JustAnswer about your Ford, it will make the session go more smoothly if you have the following information ready:


  • Year and model
  • Specific description of symptoms, and whether they’re getting worse
  • What you’ve tried so far

Ford Experts on JustAnswer are available any time, day or night, no matter where you are.