How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Ron Your Own Question
Ron, ASE Certified Technician
Category: Ford
Satisfied Customers: 35491
Experience:  23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs
Type Your Ford Question Here...
Ron is online now
A new question is answered every 9 seconds

I have a intermintant stall but when u turn off ignition

Customer Question

i have a intermintant stall but when u turn off ignition switch it fires right back up
JA: Has the car been stalling out?
Customer: yes loses spark and injector pulse
JA: What is the model/year of your Ford?
Customer: 1994 ranger 2.3 auto
JA: Are you hoping to fix this yourself? What have you tried so far?
Customer: ignition module and ran new ground to module
JA: Anything else you think the mechanic should know?
Customer: when it stalls if u dont turn igntionj all the way off it wont start if u do it fires right up runs then stalls after a few minutes
Submitted: 11 months ago.
Category: Ford
Expert:  Ron replied 11 months ago.

Hello, my name is ***** ***** I am a professional here at Just Answer. I have noticed that your question was not getting a response and thought I would see if you still need help with this.I apologize for the delay and I hope I can still assist you with this here. The loss of spark and injector pulse can be caused by any of the following,

  • Crankshaft Position (CKP) Sensor
  • Crankshaft Position (CKP) Sensor Wiring
  • Ignition Module
  • Ignition Module Connector
  • Ignition Module Wiring
  • Powertrain Control Module (PCM)
  • Shorted Sensor
  • Shorted Sensor

    In order to determine the cause you are going to need to do some testing on these things. I have enclosed the steps in the link below.

    Run through these steps and post back if you have more questions and or need more help.