How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Chris (aka- Moose) Your Own Question
Chris (aka- Moose)
Chris (aka- Moose), Technician
Category: Ford
Satisfied Customers: 48625
Experience:  16 years experience
Type Your Ford Question Here...
Chris (aka- Moose) is online now
A new question is answered every 9 seconds

I'm having a problem with the OD flashing on my 2000 Ford

Customer Question

I'm having a problem with the OD flashing on my 2000 Ford 250 I changed out the VSS sensor the connection sensors on the transmission as well and I keep getting the same code P0500 anything else you think I need to check Thank you
JA: Do you have a scan tool to read the codes?
Customer: Yes
JA: What is the model of your '00 Ford?
Customer: 250 Laret
JA: Are you hoping to fix this yourself? What have you tried so far?
Customer: I check every sensor by replacing it and the connections
JA: Anything else you think the mechanic should know?
Customer: All the wires leading to the sensors look good
JA: OK. Got it. I'm sending you to a secure page on JustAnswer so you can place the $5 fully-refundable deposit now. While you're filling out that form, I'll tell the Ford Mechanic about your situation and then connect you two.
Submitted: 1 year ago.
Category: Ford
Expert:  Chris (aka- Moose) replied 1 year ago.

Welcome, I'm Chris (aka Moose).

Is the speedometer reading accurate while driving?

Is the ABS light on?

Customer: replied 1 year ago.
The speedometer jumps but no the abs light is not on
Expert:  Chris (aka- Moose) replied 1 year ago.

You replaced the rear axle speed sensor correct?

Did you ohm test those wires?

Customer: replied 1 year ago.
replaced the rear axle speed sensor and conection
Expert:  Chris (aka- Moose) replied 1 year ago.

Does your scan tool do more than just code reading alone?

Can it read inputs and outputs from and to modules like the ABS?

Expert:  Chris (aka- Moose) replied 1 year ago.

Hello again Chris here,

I am contacting you because the post has not been closed or rated. We have 7 days to get a post rated before it times out. When a post times out, that means its no longer on my active list (if you reply I never know it.) You have already paid the fees to get this question answered, but it appears you're not pleased, or need more help.

Let me help some more. Is there anything else you feel I could offer so you would be pleased with my help. I have the option to call you if that would be better.

Thanks Chris