Ford

Have Ford questions? Ask a mechanic for answers ASAP

Ask an Expert,
Get an Answer ASAP!

1993 ford explorer crank but want start, the tings I have…

Customer Question
1993 ford explorer crank but...
1993 ford explorer crank but want start, the tings I have tried (replaced Starter solenoid, crankshaft position sensor, ignition switch, fuel pump, fuel filter, fuel pump relay, coolant temperature sensor, Ignition coil pack, new radiator
Submitted: 2 years ago.Category: Ford
Show More
Show Less
Ask Your Own Ford Question
Answered in 40 minutes by:
2/14/2016
Ford Mechanic: Juan Crespo, Tech Trainer replied 2 years ago
Juan Crespo
Juan Crespo, Tech Trainer
Category: Ford
Satisfied Customers: 1,532
Experience: A.S.E. Master Technician, Advanced Level, Emissions - Asian, Domestic, & European
Verified

Welcome, my name is***** am a verified expert automobile technician. I, and all others like me are neither employees nor agents of Just Answer. We are independent service providers using the Site to sell our Expert knowledge to customers. I do my best to provide EXCELLENT 5 STAR service, please let me know what you need from me so you’re satisfied with my efforts and reward me with a Positive Rating.

I understand you have replaced all those parts, but I also understand sometimes we miss checking the simple things, such as making sure any alarm in the vehicle that will prevent the engoine from starting and running is disarmed. If the alarm is not causing the problem, then how about checking the four basic things an engine needs to start and run:

  • Compression should be at least 100 psi with less than 25% variation between cylinders
  • Fuel pressure should be 35-40 psi with key on engine off
  • Injector pulse Noid light plugged in any injector connector should flash brightly and steadily as engine is cranking
  • Spark should be strong at about 8-10 KW as measured with an ignition tester

TIP - if the engine starts and runs momentarily with starting fluid, compression and spark are OK

Can you check and let me know what you find so we can continue?

Ask Your Own Ford Question
Was this answer helpful?
Ask Juan Crespo Your Own Question
Juan Crespo
Juan Crespo
Juan Crespo, Tech Trainer
Category: Ford
Satisfied Customers: 1,532
1,532 Satisfied Customers
Experience: A.S.E. Master Technician, Advanced Level, Emissions - Asian, Domestic, & European

Juan Crespo is online now

A new question is answered every 9 seconds

How JustAnswer works:

  • Ask an ExpertExperts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional AnswerVia email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction GuaranteeRate the answer you receive.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

24,610 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Technician

28,466 satisfied customers

16 years experience

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

10 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Richard

Richard

ASE Certified Technician

1,524 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

Mike V.

Mike V.

Auto Service Technician

1,455 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

< Previous | Next >

Related Ford Questions
Thank you for being nice. i believe my ignition coil and or
thank you for being nice. i believe my ignition coil and or boot needs replacing due to recent misfiring. my question is how many coils do i have on my 5.4 e250 ford … read more
HDGENE
HDGENE
Master Technician/Lead Technician
Associate Degree
2,835 satisfied customers
Got an engine coolant overtemperature code but after car has
got an engine coolant overtemperature code but after car has cool the code has not reset. how can I get it to reset … read more
Eric
Eric
Retired
N/A
14,436 satisfied customers
2002 fi50 coolant leak at rear of engine pudles underneath
2002 fi50 coolant leak at rear of engine pudles underneath vehicle ob passenger side seems to ber running doen trans bellhousing … read more
Mechanic01
Mechanic01
2,596 satisfied customers
Looking for procedure to replace ignition coils on 2004
looking for procedure to replace ignition coils on 2004 Thunderbird … read more
Eric
Eric
Retired
N/A
14,436 satisfied customers
Engine coolant over temperature warning, F150 2.7L, same
Engine coolant over temperature warning, F150 2.7L , same problem 2 weeks ago, dealer said it was rodent damage to the wiring harness, I trying to find the temperature sensor … read more
HDGENE
HDGENE
Master Technician/Lead Technician
Associate Degree
2,835 satisfied customers
Just had spark plugs and ignition coils replaced on 2004
Just had spark plugs and ignition coils replaced on 2004 ford escape. The car was running rough, hesitating. After repair car ran good for 2 days, then check engine light came on again and the car had… read more
HDGENE
HDGENE
Master Technician/Lead Technician
Associate Degree
2,835 satisfied customers
I replaced ignition coil and plug with OE STUFF. Still have
I replaced ignition coil and plug with OE STUFF. Still have bad misfire cylinder two! Late last year had a misfire cylinders one and two dealer said new engine, charges me five grand! Believe they onl… read more
Steve W
Steve W
Line Technician
Vocational, Technical or Trade Scho
1,968 satisfied customers
Replaced the starter on our 99 ford v10 yesterday. Engine
Replaced the starter on our 99 ford v10 yesterday. Engine now starts but now makes a rattle sound. Thinking that the starter is not disengaging. Taking the starter back today to make sure it's the cor… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
24,610 satisfied customers
Starter won't come f150 2005. Nothing starter is bad all
Nothing starter is bad all lose but won't come out … read more
Michael
Michael
Automotive Technician
High School or GED
257 satisfied customers
I've got a engine coolant leaking problem. It also is a
I've got a engine coolant leaking problem. It also is a muddy brown color. … read more
Gunvir Singh
Gunvir Singh
1,949 satisfied customers
Did a tune up plugs, wires, ignition coil tan worse after
Did a tune up plugs, wires, ignition coil tan worse after that. Replace injector, all o2 sensors, egr valve, ecm, idle air control valve, MAF sensor and runner valve. Had top half pressure tested for … read more
kalamykid
kalamykid
Pactor automotive
Vocational, Technical or Trade Scho
97 satisfied customers
2004 ford focus ignition coil burn out.three times in a
2004 ford focus ignition coil burn out.three times in a week.car runs great after replacement then shuts down without warning.burns out ignition coil … read more
Edward Clayton
Edward Clayton
Associate Degree
1,033 satisfied customers
I need injector and ignition Coil wiring colours for a ford
HELLO i need injector and ignition Coil wiring colours for a ford escape 2004 V6 engine and also factory engine coolant temperature Normal conditions… read more
Eric
Eric
Retired
N/A
14,436 satisfied customers
No power to starter solenoid/ starter. Starter & solenoid
No power to starter solenoid/ starter. Starter & solenoid are new. Starter relay switch is good, battery is good. 50 amp starter fuse is good … read more
AMEDEE
AMEDEE
AUTOMOTIVE TECHNICIAN
Vocational, Technical or Trade Scho
9,105 satisfied customers
Week spark at ignition coil on a 1989 ford 250 4.9. Lol,,
Week spark at ignition coil on a 1989 ford 250 4.9 … read more
roy
roy
Associate Degree
3 satisfied customers
94 ranger intake ignition coil not getting power, what could
94 ranger intake ignition coil not getting power, what could be root cause? truck still runs but not good and loss and power.… read more
AMEDEE
AMEDEE
AUTOMOTIVE TECHNICIAN
Vocational, Technical or Trade Scho
9,105 satisfied customers
No power coming from it, changed out ignition coils and
no power coming from it, changed out ignition coils and connectors. wonder what it would mean. and i keep getting P2312:00-64 and P2315:00-64 codes when i scan it. … read more
Kenny Z
Kenny Z
Ford Senior Master Technician
High School or GED
16 satisfied customers
2002 ford windstar, husband replaced ignition coil and not
2002 ford windstar, husband replaced ignition coil and not it will not start … read more
AMEDEE
AMEDEE
AUTOMOTIVE TECHNICIAN
Vocational, Technical or Trade Scho
9,105 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x