Ford

Have Ford Questions? Ask a Mechanic for Answers ASAP

Ask an Expert,
Get an Answer ASAP!

Ford

2001 FORD E 150 P1406 4.2

Customer Question
2001 FORD E 150 P1406 4.2
Submitted: 1 year ago.Category: Ford
Ask Your Own Ford Question
Answered in 11 minutes by:
1/15/2016
Ford Mechanic: AZTechBrian, ASE Certified Technician replied 1 year ago
AZTechBrian
AZTechBrian, ASE Certified Technician
Category: Ford
Satisfied Customers: 732
Experience: Owner
Verified

Hello. This is a diagram of the DPFE. The downstream pressure hose is shown on the diagram. Please let me know if this helps you.

DOWN STREAM PRESSURE HOSE

Ask Your Own Ford Question
Ford Mechanic: AZTechBrian, ASE Certified Technician replied 1 year ago

If you find the hose to be attached, remove it and make sure the hose is not kinked, or has any dips in it where water could collect and freeze.

Ask Your Own Ford Question
Ford Mechanic: AZTechBrian, ASE Certified Technician replied 1 year ago

If you have any other question please feel free to ask. Please remember to rate my service. Follow ups are free even after rating.

Thank you.

Ask Your Own Ford Question
Ford Mechanic: Chris (aka- Moose), Technician replied 1 year ago
Chris (aka- Moose)
Chris (aka- Moose), Technician
Category: Ford
Satisfied Customers: 49,406
Experience: 16 years experience
Verified

Welcome, I'm Chris (aka Moose) I'm an independent contractor here at Just Answer.

The expert that was helping opted out. Would you like me to help you?

Thanks for asking your question and letting me try to help you.

Ask Your Own Ford Question
Ask Chris (aka- Moose) Your Own Question
Chris (aka- Moose)
Chris (aka- Moose)
Chris (aka- Moose), Technician
Category: Ford
Satisfied Customers: 49,406
49,406 Satisfied Customers
Experience: 16 years experience

Chris (aka- Moose) is online now

A new question is answered every 9 seconds

How JustAnswer works:

  • Ask an ExpertExperts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional AnswerVia email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction GuaranteeRate the answer you receive.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

24,252 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Technician

49,406 satisfied customers

16 years experience

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

10 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Richard

Richard

ASE Certified Technician

1,524 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

Mike V.

Mike V.

Auto Service Technician

1,365 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

< Previous | Next >

Related Ford Questions
2017 f350 engine starts but nothing comes on on the panel.
2017 f350 engine starts but nothing comes on on the panel … read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
49,406 satisfied customers
Cranks but will not start 1996explorer 4.0. No i've done non
yes, it has a key pad on the driver door, possable that it has stopped it from starting, anynway i can get the keympad numbers… read more
Roy
Roy
shop foreman
Associate Degree
3,844 satisfied customers
Driver door ajar won't go off, so my lights are staying on i
Second opinion] driver door ajar won't go off , so my lights are staying on i used wd40 no success… read more
Curtis
Curtis
Vocational, Technical or Trade Scho
1,689 satisfied customers
Initial error code was P0171 01/01 check engine light on.
Initial error code was P0171 01/01 check engine light on. Replaced 02 sensor. Now code is P2195 ck engine light back on. Any suggestions. All was good before the code. 2003 Ford Focus ZX3 2.0L FI DOHC… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
18,417 satisfied customers
2002 Ford F150 after being driven for a while will turn over
2002 Ford F150 after being driven for a while will turn over and not start … read more
HDGENE
HDGENE
5,726 satisfied customers
Have a pssting noise from the right side manifold or gasket
have a pssting noise from the right side manifold or gasket how do I find out for sure if it is leaking? … read more
Jaybird61
Jaybird61
Master Automotive Mechanic
2,076 satisfied customers
04 f350 dually. 6.0 diesel auto trans. I have a bad
04 f350 dually. 6.0 diesel auto trans. I have a bad vibration that starts at about 65 mph and seams to smooth out about 85mph. New trans mount, new joints, new ford center support bearing had all tire… read more
HDGENE
HDGENE
5,726 satisfied customers
Ford Egetting blinking AT OD light and check engine light w
Ford E(###) ###-####getting blinking AT OD light and check engine light w code po500 and no speedometer reading. No indication of an abs problem Changed the speed sensor on top of the differential and… read more
JOHN aka Eauto
JOHN aka Eauto
self employed
High School or GED
10,295 satisfied customers
I changed brake distubutor block for the control module and
I changed brake distubutor block for the control module and Together then I bled the brakes every caliber and now my brakes are very weak don't work till the second or third push… read more
HDGENE
HDGENE
5,726 satisfied customers
My service engine soon light just came on today.
I haven't tried anything yet because it just came on this morning as I was driving home from work. … read more
Ron Z.
Ron Z.
Vocational, Technical or Trade Scho
18,908 satisfied customers
1988 ford F150 6cly 5spd will not start of key hot wired
1988 ford F150 6cly 5spd will not start of key hot wired fuse for fuel pump and hot wired fuse for ignition and that made it run no lights in dash when you turn the key on checked all the fusable link… read more
Jaybird61
Jaybird61
Master Automotive Mechanic
2,076 satisfied customers
I had to replace one key fob on my 2015 Explorer Sport. Now
I had to replace one key fob on my 2015 Explorer Sport. Now I have two fobs with MyKey settings that I cannot access or change. I don't seem to have an Admin. key anymore. How can I remove the MyKey s… read more
Jeremy
Jeremy
Technician
Vocational, Technical or Trade Scho
104 satisfied customers
I have a 2001 F150, tilt column, 4.6 V8, 171k miles. Problem
I have a 2001 F150, tilt column, 4.6 V8, 171k miles. Problem is that sometimes the engine will turn over but not start. Noticed that fuel pump does not always turn on when turning key. Turning key bac… read more
Jaybird61
Jaybird61
Master Automotive Mechanic
2,076 satisfied customers
Checked wht/violet wire no voltage with blower on, manual
David checked wht/violet wire no voltage with blower on, manual fan speed works and then stops, after 2 or 3 tries stays on , auto control wasn't working at all but last time I tried was working but n… read more
David Craig
David Craig
OWNER/MECHANIC
Associates
4,095 satisfied customers
The fuel gauge doesn't seem to consistently reporting the
The fuel gauge doesn't seem to consistently reporting the right fuel level … read more
rpmdiag
rpmdiag
High school
7,177 satisfied customers
Ron have a 2004 Mazda three occasionally it's hard to start
Hi Ron have a 2004 Mazda three occasionally it's hard to start when warm I clean the butterfly out it wasn't that dirty what would a a short term and long term lean condition read at idle… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
24,252 satisfied customers
My 5.4 will not get hot flushed eaverything blend doors are
my 5.4 will not get hot flushed eaverything blend doors are working heater hoses do not get hot 137 top 125 bottom egr tube you can hold with your hand i put cardboard in front of rad.it will get hott… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
49,406 satisfied customers
WHAT IS THE COST FOR REPLACING THE REAR ASSEMBLY ON A 2K
WHAT IS THE COST FOR REPLACING THE REAR ASSEMBLY ON A 2K FORD CONTOUR , MINUS THE SHOCK/STRUTS … read more
JOHN aka Eauto
JOHN aka Eauto
self employed
High School or GED
10,295 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x