Ford

Have Ford questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Ford Questions
I have a 05 fx4 with the 5.4 liter. It has been at local
I have a 05 fx4 with the 5.4 liter. It has been at local dealer now for 3 weeks tracking problems. 1. New timing chains and phasers installed 2. New plugs They found melted harness from top of motor o… read more
A. Penland
A. Penland
Ford Senior Master Technician
Vocational, Technical or Trade School
7,186 satisfied customers
2008: 2008 F250 4WD - 5.4L RECENT ENGINE REBUILD - LS CAM APPERS
2008 F250 4WD - 5.4L RECENT ENGINE REBUILD - LS CAM APPERS TO BE (1) TOOTH ADVANCED - ALTHOUGH CAM TIMMING MARKS APPER TO BE CORRECT? - NEW CAM & PHASER & CHAIN - VVT-APPERS TO SHOW 99% EROR WHILE RS … read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
29,223 satisfied customers
Ford: I have a 1986 ford e350 party bus has 460 motor bus will
I have a 1986 ford e350 party bus has 460 motor bus will not go over 50mph feels like its going to stall and will drop power slows down to 35mph going up a hill if I floor the gas motor revs up but ge… read more
K. Wiggins
K. Wiggins
ASE Certified Technician
Associate Degree
3,679 satisfied customers
2004 f150 5.4l Replaced cam phasers, chain tnsioners and guildes
2004 f150 5.4l Replaced cam phasers, chain tnsioners and guildes and VCT solenoids and cam sensors. truck starts fine but idles rough and wants to die. throwing codes p0345, p0021, p0201. i was 99.9 p… read more
Kenny Z.
Kenny Z.
Ford Senior Master Technician
High School or GED
6,156 satisfied customers
Ford F150: Im trying to replace the timing chains on my 2002
I'm trying to replace the timing chains on my 2002 Ford F150 4.6L Windsor engine and have run into a huge problem. With the chains off the cam holder tool I rented slipped and the cam jumped out of th… read more
Scott W.
Scott W.
Diesel, Automatic trans, full line tech
Associate Degree
3,706 satisfied customers
1976 f-250: 4x4..previous owner..less than 15,000 miles on a rebuild
I bought a 1976 f-250 4x4 with a 429 engine. Obviously not the stock motor. the previous owner told me that the engine had less than 15,000 miles on a rebuild. The fact that it has between 18 to 20 in… read more
ps1067
ps1067
Lead Technician
Master's Degree
68 satisfied customers
Bronco: Auto trans..persistant miss not fuel or compression related
91' Bronco w/5.8L W EFI. Auto trans-4EOD. Problem- Persistant miss not fuel or compression related. Exagerated at 1500 rpm. All emission components scaned. Live stream on snap-On scanner shows 22 deg.… read more
Dodge expert
Dodge expert
ASE MASTER TECH, REPAIR FACILITY OWNER
High School or GED
3,636 satisfied customers
1992 F150: 24-26 degrees and truck runs ok..throttle..hesitation..Worn
1992 F150 slight miss under acceleration, all primary ignition components ok, Watching ignition timing w/scanner while driving, found that timing is bouncing around. At 2500 RPM timing is sometimes at… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
25,022 satisfied customers
2000 ford expedition: timing chain..fuel filter..no vacume leaks..revs
2000 ford expedition 4.6 did the timing chain new tune up ran great for about a week and now when i accelrate it seems like it is missing, but when i put it nuetral it doesnt do it only when it is und… read more
EMRSR
EMRSR
High School or GED
3,002 satisfied customers
1980 ford: even faster if you hold..warmed..30 seconds vacum..backfire
I talked with you Saturday ref 1980 ford back fires through carb, I got a vacum reading on the engine now it holds at 15 when cold very little back fire only once in a while, especially if you apply s… read more
Dieseljunky2
Dieseljunky2
Locomotive Mechanic
Ford Certified Technician
409 satisfied customers
1980 ford F150: new plugs and wires..distributor cap..rotor..timing
1980 ford F150 351 M, back fires through carb and if you hold excelerator the truck will die. replaced carb and put all new plugs and wires and distributor cap and rotor. already tried advanceing timi… read more
Dieseljunky2
Dieseljunky2
Locomotive Mechanic
Ford Certified Technician
409 satisfied customers
1988 ford F150: timing..With 5.0L, automatic and 2 wheel drive
To set the (basic) timing you are suppose to unplugg the single wire to the spark output. Where is this located on a 1988 ford F150 With 5.0L, automatic andXXXXX… read more
Afordable
Afordable
Sales
Associate Degree
172 satisfied customers
2001 F-250: The truck is running rough with a decent miss
I have a 2001 F-250 with the 6.8. The truck is running rough with a decent miss. Tested and replaced one non functioning O2 sensor, coolant temp. sensor on the intake, and one bad coil pack. Truck sti… read more
rick d
rick d
owner
High School or GED
32 satisfied customers
I have a 1986 F-150 302 w/ at 2wd Ive replaced the ...
I have a 1986 F-150 302 w/ at 2wd I''ve replaced the front gas tank fuel pump,high pressure pump,fuse link on the fender wall and put a compleat used distrubeture and new vacume lines and the moter cr… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
25,022 satisfied customers
1985 ford: a intake from a 1968 ford 302 The cab is..engin..highway
I have a 1985 ford that had carberater trouble. I swaped the 2 barel in for a holly 4 barel and but on a intake from a 1968 ford 302 The cab is new. the engin runs well on the highway but will not idl… read more
j_ramsey
j_ramsey
High School or GED
480 satisfied customers
330ci: driving home..100 miles..has 10.7 : 1 compression..ride
I was driving home from the hotrod power tour after about 2300 miles I got really bad spark knock. It was probably 100 miles on this tank of gas, my 390ci has 10.7 : 1 compression If there was any kno… read more
rnss82
rnss82
High School or GED
2 satisfied customers
86 Ford Bronco: a new distributor..module..under load..repair shop
I have a 86 Ford Bronco full size w/ a 5.8 had the engine rebuilt last September have put on a new Holly card and just yesterday a new distributor also a new electronic module. The dog gone thing PING… read more
Virtual Wrench
Virtual Wrench
Owner of LJ Auto Repair 37 years
Associate Degree
14,398 satisfied customers
1968 f100: installed a timing chain and gears..carb..to timing marks
I just installed a timing chain and gears in a 1968 f100, It acts like it is not in time. spitting though the carb. Aren't the to timing marks on the sprockets suppose to be alined together at the cen… read more
Virtual Wrench
Virtual Wrench
Owner of LJ Auto Repair 37 years
Associate Degree
14,398 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

25,022 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Technician

29,223 satisfied customers

16 years experience

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

10 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Mike V.

Mike V.

Auto Service Technician

1,591 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,524 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x