Ford

Have Ford questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Ford Questions
2004 ford taurus OHV cam position sensor assembly . how many
2004 ford taurus OHV cam position sensor assembly . how many degrees counterclockwise from engine centerline with alignment tool in place on the drive assembly should it be set at?… read more
Kenny Z.
Kenny Z.
Ford Senior Master Technician
High School or GED
7,005 satisfied customers
I have a 2003 ford tauras 3.0 OHV V-6 I have Diagnostic
Hi I have a 2003 ford tauras 3.0 OHV V-6 I have Diagnostic codes P0316,P0302 found there Definition. Decided to so a tune up and same Problem it shakes comes and go's if your on the hwy it's fine put … read more
6Bucs
6Bucs
Senior Master Tech
Associate Degree
1,545 satisfied customers
Ford freestar: cam shaft..a long rod at the end..enough room..assembly
Can't get cam shaft sync out of my ford freestar. have the replacement part, have the old one partially out, but there is a long rod at the end of the old one that is not on the new one and there is n… read more
Chris (aka- Moose)
Chris (aka- Moose)
Ford Technician
Vocational, Technical or Trade School
34,605 satisfied customers
97 ford f150: V6..diagram..for the rotor under the camshaft sensor
97 ford f150 V6 4.2L need position (diagram or picture) for the rotor under the camshaft sensor… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
27,281 satisfied customers
2000 ford ranger: 3.0L..engine revs..idles..the check engine light is
i have a 2000 ford ranger 3.0L 2wheel drive 5-speed. when i change gears or even sometimes just sitting still the engine revs very high for bout 15 to 20 seconds then idles down, the check engine ligh… read more
Al Smitty
Al Smitty
Associate Degree
660 satisfied customers
2006 FORD: 000 MILES..I HAVE CHANGED THE IDLER PULLEY, AND THE BELT.
I HAVE A 2006 FORD TAURUS...60,000 MILES..I HAVE CHANGED THE IDLER PULLEY, AND THE BELT. IT STILL MAKES THIS HORRIBLE SQUEAKING NOISE WHEN I AM IDLE OR WHEN I COME TO A LIGHT..IT JUST SQUEAKS. WILL RE… read more
rashawn
rashawn
Vocational, Technical or Trade Scho
382 satisfied customers
97 Ford Ranger: replacing the timing belt..cyl..old one..truck is inop
I will be replacing the timing belt in a 97 Ford Ranger (4 cyl). The old one has boken and the truck is inop. Could you provide me with the sequence of timing steps. What all needs to be aligned prior… read more
JOHN aka Eauto
JOHN aka Eauto
self employed
High School or GED
23,073 satisfied customers
2000 ford taurus: cam..tool..changed one..mechanically inclined
ive got to change a cam syncronizer in my 2000 ford taurus,i have the tool,attend auto technology classes.i have never changed one of these before.i am mechanically inclined,so im not completely in th… read more
Tim
Tim
Associate Degree
3,579 satisfied customers
1999 ford windstar: crankshaft..senor..van will try to shut..crank
1999 ford winstar has code 340 crankshaft positrion senor. when driving the van will try to shut off and when at idle will shut down but will crank back up.… read more
Dennis
Dennis
Senior Master A Technician/Shop Foreman
Vocational, Technical or Trade Scho
758 satisfied customers
1996 ford ranger: cyl..the camshaft positioning sensor..shaft..tool
I have a 1996 Ford Rnager 6 cyl. I need to replace the camshaft positioning sensor and the actual shaft. I don't have the special alignmnet tool. Is there anyway I can replace it without the tool?… read more
Tim
Tim
Ford Senior Master Technician
Vocational, Technical or Trade Scho
1,044 satisfied customers
Ford: chain..set the number one cylinder to tdc before removing heads
Need to find location of timing mark on timimg chain cover for Ford 3.0 OHV Engine so I can set the number one cylinder to TDC before removing heads.… read more
lostrider
lostrider
lead technician/working shop foreman
Vocational, Technical or Trade Scho
3,074 satisfied customers
1999 ford explorer: 4.0 engine..metal..noise from rear engine/trans
1999 ford explorer w/4.0 engine experiencing a metal souning type chirpping noise from rear engine/trans. area.noise slighlty increases w/ acceleration.… read more
lostrider
lostrider
lead technician/working shop foreman
Vocational, Technical or Trade Scho
3,074 satisfied customers
2000 ford focus: timing marks..head cam ,,, the belt..tore
a want to no the timing marks on a 2000 ford focus duel over head cam ,,, the belt just tore,, or any info.would help,,… read more
Randall    (Cheeko)
Randall (Cheeko)
Ford Dealer
Vocational, Technical or Trade Scho
2,395 satisfied customers
2002 Ford F-150: Supercrew..the timing chains on..rotate..crankshaft
I have a 2002 Ford F-150 Supercrew 4.6 winsor that I am changing the timing chains on. How ever after installing the new chains and trying to rotate the motor by hand it freezes up after about 3/4 of … read more
Chris (aka- Moose)
Chris (aka- Moose)
Ford Technician
Vocational, Technical or Trade School
34,605 satisfied customers
95 ford ranger: changing timing belt..crank shaft..cant find marks
i got a 95 ford ranger,changing timing belt .i need to know how to get crank shaft in correct position.i cant find marks for it .i got the other two gears in position.its a 2.3lno a/c no power srearin… read more
Don - Mo Lurch
Don - Mo Lurch
Owner
Vocational, Technical or Trade Scho
11,619 satisfied customers
The cams in a 1999 zx2 dohc built 4/99..timing marks
What is the proper way to line up the cams in a 1999 zx2 dohc built 4/99 ? i can find no timing marks.… read more
Marc
Marc
fleet supervisor
Vocational, Technical or Trade Scho
1,140 satisfied customers
ford taurus: ckp..end to the wire loom from the dealer
i have a ford taurus 12 valve ax4n with a p0 340 code ckp sensor i replaced the sensor and repaired with an end to the wire loom from the dealer but on the second ignition the code still comes on no p… read more
HDGENE
HDGENE
10,155 satisfied customers
2002 Ford Taurus: chirping..loose..my serpetine belt is great - its
I have a 2002 Ford Taurus and in the last couple of days it chirps. The kind of chirping one would normally associate with a loose belt. However, my serpetine belt is great - it's not comingfrom the f… read more
LBS Tech
LBS Tech
Ford Technician
Associate Degree
198 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

27,281 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Ford Technician

34,605 satisfied customers

24 years of experience diagnosing & repairing

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

12 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Mike V.

Mike V.

Auto Service Technician

2,651 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,558 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x