Ford

Have Ford questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Ford Questions
I have a 6.0 2005 f250 4x4 I recently had injecters put into
I have a 6.0 2005 f250 4x4 I recently had injecters put into it and right after I paid the shop that installed them it has a long crank but every now and then it might start up normal … read more
Ray M.
Ray M.
Diesel Technician
Vocational, Technical or Trade School
3,085 satisfied customers
2000 F250 7.3 4wd crew cab. No mods, original equipment
Second opinion] 2000 F250 7.3 4wd crew cab. No mods, original equipment 340,000 mi. Hard/no start cold >60f starts on block heater runs rough, after warm up no power, new air, fuel, and oil filters… read more
Dennis ONeil
Dennis ONeil
masters
4 satisfied customers
Are you a 2000 7.3 expert? Excursion, Yes, all related to
Are you a 2000 7.3 expert? JA: What is the model of your '00 Ford? Customer: Excursion JA: Are you fixing your Excursion yourself? What have you tried so far? Customer: Yes, all related to 7.3 JA: Any… read more
Scott
Scott
Diesel, Automatic trans, full line tech
Associate Degree
3,851 satisfied customers
Replaced lift pump and know when it run 60sec it gets code
replaced lift pump and know when it run 60sec it gets code p1211 and starts running bad and knocking … read more
6Bucs
6Bucs
Senior Master Tech
Associate Degree
1,291 satisfied customers
Got a 1999 7.3 F350 here. Starts reasonable in 70F. Anything
Got a 1999 7.3 F350 here. Starts reasonable in 70F. Anything colder and it needs to be plugged in. 1 GP is bad but rest work. Starts good hot. Has a slight miss in 1 cyl when cold. Has very weak throt… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,014 satisfied customers
Ford F350: 2000 Ford F350 Diesel. I have a problem with an
2000 Ford F350 Diesel. I have a problem with an ICP code P1211. Vehicle will only code under acceleration from 60 to 100 km/hr range. Did notice that IPR reading was 64.8% when code actuated. Also not… read more
James
James
Ford Technician
Bachelors degree automotive technology with minor in diesel
3,642 satisfied customers
Ford F350: I let the truck sit outside over night and my oil
I let the truck sit outside over night and my oil injector pressure this morning was 1097 with the engine oil at 30*F. I plugged it in and finally got it started. With the engine oil at 67*F and at an… read more
James
James
Ford Technician
Bachelors degree automotive technology with minor in diesel
3,642 satisfied customers
FORD F-250: hi a own a 2001 ford -f250 7.3 powerstroke turbo
hi a own a 2001 ford -f250 7.3 powerstroke turbo start fine drive at 50 starts to smoke dark blue and black start to loss power turns off strart right on code p1211 this are the thing I change all rea… read more
Tim Mohr
Tim Mohr
SHOP OWNER
Master's Degree
17,334 satisfied customers
F250: I am working on a 1999 ford F250 7.3 diesel.. it is hard
I am working on a 1999 ford F250 7.3 diesel.. it is hard to start hot or cold....already changed glow plugs, relay, ipr, lift pump, fuel filter, oil and oil filter. still has same symptoms.. no codes … read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
31,374 satisfied customers
Ford: run fine..500 miles..a hard acceleration either but it will die
Ford with low or high oil code think p0112 Truck will run fine the just shut off like the key is turned off Might drive 500 miles or 5 miles can't really say it's under a hard acceleration either but … read more
POWERSTROKE
POWERSTROKE
DIESEL MASTER TECH
Associate Degree
1,062 satisfied customers
i have a 95 ford 7.3L w/tubo missing bad no power have a code
i have a 95 ford 7.3L w/tubo missing bad no power have a code P1211 icp pressure high or low i have 568 to 580 psi at idle and 2,354 wot fuel pressure of 58psi ran a cylinder bal test got got codes P0… read more
Ron W.
Ron W.
Master Certified Technician
Vocational, Technical or Trade Scho
252 satisfied customers
2000 f450: bad miss..cylinder..it comes back with cyl. 1 & 8 fail
My 2000 F450 7.3 is running with a bad miss when i run a cylinder contribution test it comes back with cyl. 1 & 8 fail. All the codes are P1211, P1282, P0263, P0284. The dealer replaced inake and exha… read more
Dennis
Dennis
Senior Master A Technician/Shop Foreman
Vocational, Technical or Trade Scho
758 satisfied customers
2005 f250: cranks..white smoke..fuel pump run until it..restart
2005 f250 cranks runs 15 seconds smokes white smoke shuts off as if running out of fuel let fuel pump run until it builds pressure engine will restart it is a 6.0 diesel help… read more
POWERSTROKE
POWERSTROKE
DIESEL MASTER TECH
Associate Degree
1,062 satisfied customers
warm..had icp sensor code and replaced but still have rough cold start
Cold start is very rough, warm start is good. Had ICP sensor code and replaced but still have rough cold start… read more
Ray M.
Ray M.
Diesel Technician
Vocational, Technical or Trade School
3,085 satisfied customers
2000 fORD F-550: 7.3 DIESEL..START...THE FUEL PRESSURE REGULATOR
2000 fORD F-550 7.3 DIESEL, ENGINE WAS WAVING IDLE TO 2000 RPMS UP AND DOWN. SHUT OFF ENGINE AND NOW IT WILL NOT START. WE THOUGHT IT WAS THE FUEL PRESSURE REGULATOR , BUT THE FORD COMPANY TESTED IT A… read more
Ray M.
Ray M.
Diesel Technician
Vocational, Technical or Trade School
3,085 satisfied customers
Turbo diesel..cranking..3000 plus and engine fires , and runs good
have 2002 7.3 turbo diesel. have excessive cranking time for pressure to built at pump but once the needle moves it getts to 3000 plus and engine fires , and runs good. considering weak pump, bad icp … read more
KEN
KEN
Lead Fleet Mechanic
Associate Degree
22 satisfied customers
2003 F-450: glow plugs..electric fuel pressure..icp volts..cranking
2003 F-450 7.3 with a hard to start problem. No codes, batteries check ok, glow plugs and system all ok, electric fuel pressure @ 65 psi, scanner shows icp volts @ .19 key on icp 15 %. When cranking i… read more
POWERSTROKE
POWERSTROKE
DIESEL MASTER TECH
Associate Degree
1,062 satisfied customers
The injectors and glow plugs, it starts..cranks..pressure sensor
I have a 1996 Power Stroke, it starts hard after you let it set for 1 hour, i just replaced the injectors and glow plugs, it starts easy if you crank it, then stop and crank it again, other wise it cr… read more
HDGENE
HDGENE
7,480 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

26,041 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Technician

31,374 satisfied customers

16 years experience

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

10 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Mike V.

Mike V.

Auto Service Technician

1,937 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,535 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x