Ford

Have Ford questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Ford Questions
I have a 2008 Ford ranger 2.3L...crank with no start..no
I have a 2008 Ford ranger 2.3L...crank with no start..no codes,but show all 4 injectors at fault. Will run on starting fluid... Done everything I know to do...I'll glady pay you for the fix !… read more
David Craig
David Craig
OWNER/MECHANIC
Associates
8,343 satisfied customers
I have an 03 Ford Focus DOHC, that came in with Cyl 1 and 2
I have an 03 Ford Focus DOHC, that came in with Cyl 1 and 2 misfires and barley able to run if at all. Replaced coil and car ran good. Went about 3 miles and it died and would barley start and if it d… read more
Tyler Henry
Tyler Henry
Technician
Automotive service technology
2,285 satisfied customers
I have a Ford Fusion 2007 with a 3.0 V6. I am getting a
I have a Ford Fusion 2007 with a 3.0 V6. I am getting a P0304 Code Cyl 4 misfire. I have replaced the plug, swapped the coil pack and did an injector still mis firing on 4 Not sure what to try next. t… read more
Tim Mohr
Tim Mohr
ASE MASTER TECH
Master's Degree
3,758 satisfied customers
After engine replacement with reman engine it wont start.
after engine replacement with reman engine it wont start. turns over 2 or three times then hits a few times and stops. fuel pressure 40psi, coils firing, injectors firing, compression 150psi on all 8 … read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
30,495 satisfied customers
Have 88 ford bronco 2 2.9 lost ground to pcm fixed that had
have 88 ford bronco 2 2.9 lost ground to pcm fixed that had to replace EEC, pick up, coil, plugs,wires, cap, fuel pump and rotor. Now have bright blue strong spark, fuel is at 45 psi, compression is i… read more
Mike S.
Mike S.
Vocational, Technical or Trade Scho
8,311 satisfied customers
2000 ford ranger 2.5 Truck ran good until fuel pump went
2000 ford ranger 2.5 Truck ran good until fuel pump went out, no fuel pressure. Replaced pump and pressure is good, 60 PSI before crank higher during crank. not getting any spark. only code is P0232.… read more
HDGENE
HDGENE
7,378 satisfied customers
I have a 2005 ford freestar with 3.9. swapped engines due to
i have a 2005 ford freestar with 3.9. swapped engines due to thrown rod, and now no start. it will turn over, but not start. i have 39 psi at the fuel rail, i have spark.… read more
HDGENE
HDGENE
7,378 satisfied customers
2008 f150 5.4 3 valve with p0303 code fuel injector firing
2008 f150 5.4 3 valve with p0303 code fuel injector firing coil is firing has a marginally lower compression reading in #3 cylinder. Put new plugs in and the #3 plug still looks like it did when it ca… read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
24,337 satisfied customers
Ford escape: i have an 06 ford escape will not startran
hi i have an 06 ford escape will not start ran fine she got gas drove 1 mile to work, shut off the vehicle left radio on and killed battery, when the guy jumped it the vehicle ran terrible but ran, sh… read more
A. Penland
A. Penland
Ford Senior Master Technician
Vocational, Technical or Trade School
7,510 satisfied customers
2000 ford f150: 4.2l...after..engine warms up, i get a #3 cyl
I have a 2000 ford f150 with a 4.2l engine.after engine warms up, i get a #3 cyl. miss and a code that refers to bank 1 having a lean condition.I have tried new spark plugs, coil seems to have fire fr… read more
Dieseljunky2
Dieseljunky2
Locomotive Mechanic
Ford Certified Technician
3,589 satisfied customers
2006 ford: v6..wont start..fuel to the injector manifold
2006 ford fusion v6 quit running while driving and will turn over but won't start. Fuel pump checks out and engine is getting fuel to the injector manifold. Dianostic codes all come back clear includi… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
30,495 satisfied customers
1994 ford ranger 4cyl 2.3 timing belt replacement have tried
1994 ford ranger 4cyl 2.3 timing belt replacement have tried both positions for setting timing will crank but not fire. Both crankshaft positions and lined the cam and aux up to their correct position… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
20,388 satisfied customers
I replaced the 4.0 V6 engine in my 92 Ford Explorer, with an
I replaced the 4.0 V6 engine in my 92 Ford Explorer, with an engine that has 59,000 miles. The old engine had lost its oil pump and seized. However the replacement engine will only fire on cylinders 2… read more
John Crouch
John Crouch
lead senior master tech
Vocational, Technical or Trade Scho
1,840 satisfied customers
97 t bird. 3.8 normal crank no start. spark, fuel, compression good.
97 t bird. 3.8 normal crank no start. spark, fuel, compression good. no codes with reader. my scanner aborts test. no history got car not running.… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
30,495 satisfied customers
1993 F-150: fuel pump..6 cyl,4.9..w/efi want start..starting fluid
with the key in the ON position...my fuel pump keeps on running...but my 1993 F-150 ford 6 cyl,4.9..w/EFI want start,although everything else has been checked...a spray of fuel into the port,or starti… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
40,884 satisfied customers
95 Ford Explorer: wont start..leaks..the fuel pump, fuel filter, ECU
95 Ford Explorer won't start. It is a late 95 XLT, 214,000, automatic, no strange sounds or smells, no fluid leaks, well maintained vehicle, lately since I had a no start episode, I changed out the fu… read more
j_ramsey
j_ramsey
High School or GED
480 satisfied customers
2002 ford focus: wont fire..starter fluid....any idea whats up
my 2002 ford focus had ran out of gas about a year ago and ever since it stalled out when hot or underload. 2 days ago it stalled out on my wife and hasnt started since but now it seems it has a hard … read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
20,388 satisfied customers
connectors..no air in injector rail so why does it crank but not start
i have recently rebuilt my 351 and replaced everything with new all vacuum lines are hooked up right all connectors too everything has power no air in injector rail so why does it crank but not start… read more
HDGENE
HDGENE
7,378 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

40,884 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Technician

30,495 satisfied customers

16 years experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

10 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Mike V.

Mike V.

Auto Service Technician

1,795 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,524 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

Tim Mohr

Tim Mohr

ASE MASTER TECH

3,758 satisfied customers

30 YRS EXPERIENCE, FOREIGN AND DOMESTIC, GAS AND DEISEL

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x