Ford

Have Ford questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Ford Questions
2008 f350 making load clunk noise when turned all the way
2008 f350 making load clunk noise when turned all the way left or right when 4wd is activated. The hubs can be locked or unlocked. When wheel is clocked all the way left or right and you have the whee… read more
Chris (aka- Moose)
Chris (aka- Moose)
Ford Technician
Vocational, Technical or Trade School
34,605 satisfied customers
I have a 1999 f250 superduty 7.3 diesel when i am in 4 wd
i have a 1999 f250 superduty 7.3 diesel when i am in 4 wd there is a heavy vibration i have checked the transfer case it is good no chain strech no bad berings changed front shaft the old on had a bro… read more
Ray M.
Ray M.
Diesel Technician
Vocational, Technical or Trade School
3,099 satisfied customers
F250 Pickup 4x4: I have a 1996 ford f250 XL 4x4, 5.8 liter
I have a 1996 ford f250 XL 4x4, 5.8 liter 5 spd manual transmission, and I have a loud, constant clunking noise coming from Right Front wheel. usually starts after I get above 5 to 10 mph. and at 45-6… read more
Mike V.
Mike V.
Auto Service Technician
Subaru and Nissan factory training.
2,651 satisfied customers
F250 Diesel: I have an F250 with a 5in Fabtech lift, not sure
I have an F250 with a 5in Fabtech lift, not sure if that's necessary to know but, I just had the ball joints replaced about 3 weeks ago, and now when I turn at a signal, into a parking lot, or in some… read more
Chris (aka- Moose)
Chris (aka- Moose)
Ford Technician
Vocational, Technical or Trade School
34,605 satisfied customers
1999 Ford F250 Super Duty: 4WD..vibration..seat..bad pinion bearing
I have a 1999 Ford F250 Super Duty 4WD with about 124K miles on it. It developed a bad vibration that I can feel in the steering, seat and floorboard intermittantly. A bad pinion bearing in the rear d… read more
Ironmike
Ironmike
ASE Master ,Ford Certified Master Tech
Vocational, Technical or Trade Scho
3,563 satisfied customers
2000 f250: 4x4..wheels..the highway ,,,,but when i step on the brakes
i have a 2000 f250 superduty 4x4 ,,my question is at a high speed 55 and up when you hit a bump a sudden fine vibration/noise from the frontend starts and doesnt go away till about 20 mph and down,,(b… read more
SuperBob
SuperBob
Ford dealer senior master technician
Vocational, Technical or Trade Scho
2,603 satisfied customers
faster the thumping goes away but the truck is a louder ride..actuator
When starting off I feel a thumping like a bad tirebut wheels and tires are good. It seamed to start after I used myXXXXXa little the other day. I jacked up the front and when I spin my front tires th… read more
Chris (aka- Moose)
Chris (aka- Moose)
Ford Technician
Vocational, Technical or Trade School
34,605 satisfied customers
2000 Ford F250: engaged..noise coming..frontend..clunking noise
I have a 2000 Ford F250 7.3 it is a plow truck and the only time I use the 4x4. I had 4x4 engaged and noticed a sqeaking noise coming from the driverside frontend. After a few hours of that heard and … read more
Chris (aka- Moose)
Chris (aka- Moose)
Ford Technician
Vocational, Technical or Trade School
34,605 satisfied customers
2003 F250: Superduty..mph..circle and is the same in 2wd or 4wd
I have a vibration in 2003 F250 Superduty between 5 and 7 mph. Vibration is the same under acceleration or deceleration, the same if engine is running or not and is the same in a straight line or a ci… read more
J EARL
J EARL
Ford tech
Associate Degree
292 satisfied customers
2002 f250: a clunking and its not inXXXXX.joints..axle
I have a 2002 f250 and when I turn hard i get a bucking sensation and I hear a clunking and its not inXXXXX I change the the front u-joints on both side less then a year ago. I I have one axle out now… read more
Mat
Mat
Ford Senior Master Technician
Associate Degree
959 satisfied customers
2008 F350: COMES ON SUDDENLY AND COMPLETELY DISAPPEARS IN 5 OR 10
MY 2008 F350 4WD (GAS) HAS AN INTERMITTANT LOUD BANGING NOISE FROM THE FRONT AXLE IN 2WD. SEQUENCE INCREASES AND DECREASES BASED ON SPEED. COMES ON SUDDENLY AND COMPLETELY DISAPPEARS IN 5 OR 10 MILES.… read more
Chris (aka- Moose)
Chris (aka- Moose)
Ford Technician
Vocational, Technical or Trade School
34,605 satisfied customers
2001 ford f-350: powerstroke..I have a buzzing noise coming..front end
I have a 2001 ford f-350 4x4 powerstroke. I have a buzzing noise coming from the front end. I have narrowed it down to somewhere in the front axle. It generally happens when I hit a bump. It never hap… read more
Chris (aka- Moose)
Chris (aka- Moose)
Ford Technician
Vocational, Technical or Trade School
34,605 satisfied customers
1997 Ford F150: sound coming..front end..bearings..upper control arms
I have a 1997 Ford F150 4X4 that has developed a humming sound coming from the front end while under normal driving. I have changed out both front hub bearings, upper control arms and lower ball joint… read more
connor75
connor75
Technician
Vocational, Technical or Trade Scho
360 satisfied customers
2001 F250: strangest noise coming from the front end..weather i..slow
I have a 2001 F250 4x4 super duty pickup. For the last few weeks i had the strangest noise coming from the front end. It would come and go weather i was going fast or slow. Drove me nuts , until today… read more
Brian
Brian
Automotive Service Consultant/Technician
Bachelor Degree
780 satisfied customers
1999 f250 super duty: locking..bathroom exhaust fan bearing gone..4wd
1999 f250 super duty v10. changed out to warner manual locking hubs years ago. started out at higher speeds ,hit a bump and it sounds like a bathroom exhaust fan bearing gone bad. brought to a garage … read more
Chris (aka- Moose)
Chris (aka- Moose)
Ford Technician
Vocational, Technical or Trade School
34,605 satisfied customers
96 Ford Ranger: the steering wheel and floor gear shift..speeds..tires
My 96 Ford Ranger is creating a loud humming noise and the steering wheel and floor gear shift are vibrating noticeably between the speeds of 40 to 50 mph. I have had new tires placed on the rear whee… read more
Kenny Z.
Kenny Z.
Ford Senior Master Technician
High School or GED
7,023 satisfied customers
1997 f250: xlt..wheel drive..my hub seized in the lock position
i have a 1997 f250 xlt with cv joints up front.XXXXXworks but the cv joints spin when i am inXXXXX are my hub seized in the lock position or are the cv joints suppose to always spin?… read more
CTFordTech
CTFordTech
Auto Technician
Vocational, Technical or Trade Scho
4,894 satisfied customers
1997 Ford F250: Four wheel drive..right front wheel..slow speed
1997 Ford F250 Four wheel drive. Sometimes the right front wheel will catch and hop when turning a sharp corner at a slow speed. Seems as though theXXXXXis catching on the right side. However, the fro… read more
Chris (aka- Moose)
Chris (aka- Moose)
Ford Technician
Vocational, Technical or Trade School
34,605 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

27,281 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Ford Technician

34,605 satisfied customers

24 years of experience diagnosing & repairing

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

12 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Mike V.

Mike V.

Auto Service Technician

2,651 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,558 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x