Ford

Have Ford questions? Ask a mechanic for answers ASAP

Ask an Expert,
Get an Answer ASAP!

Related Ford Questions
7.3 2002 f 250 runs good for 20 miles and then loses power
7.3 2002 f 250 runs good for 20 miles and then loses power and the breaks become very stiff almost locking up after a few minutes it will gain power again engine starts good idols good … read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
29,223 satisfied customers
Replaced the hydro booster and have no brake pedal at all.
replaced the hydro booster and have no brake pedal at all. Flushed the system with new transmission ATF, still no pedal, it goes all the way to the floor.… read more
A. Penland
A. Penland
Ford Senior Master Technician
Vocational, Technical or Trade School
7,105 satisfied customers
Crown Victoria Sport: I sent in a request yesterday, but no
I sent in a request yesterday, but no response. Again, I have a 2003 Ford Crown Vic Sport. I replaced the master cylinder 6 months ago, due to a small leak. The brakes worked fine until Thanksgiving D… read more
Jim
Jim
Vocational, Technical or Trade Scho
1,491 satisfied customers
Ford F-350 Super Duty XLT: I have a 1999 ford f-350 with 7.3
I have a 1999 ford f-350 with 7.3 diesel, my brake pedal is hard to press & it sounds kinda like the power sreering pump is binding up when i press the brakes, any ideas on this. I just done some rese… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
29,223 satisfied customers
2005 F350: deisel..parked..Cranked the truck and brake pedal went
2005 F350 Deisel. Brakes worked fine when I parked 2 days ago. Cranked the truck and brake pedal went to floor. Fluid full, no leaks. I can pump up the pedal when not running, hold the pedal and when … read more
John Crouch
John Crouch
lead senior master tech
Vocational, Technical or Trade Scho
1,840 satisfied customers
2001 ford escape: a new master cylinder and it has new front pads
i have a 2001 ford escape with a brake problem. whenever i'am driving and i apply brake the vehicle takes to long to come to a stop. I put in a new master cylinder and it has new front pads and rear s… read more
Brad
Brad
Lead Diagnostic Technician
Vocational, Technical or Trade Scho
2,361 satisfied customers
1994 F350: 7.3L diesel..brake pedal being stiff and sticking..vacuum
I have a 1994 F350 with a 7.3L diesel. I am having a problem with the brake pedal being stiff and sticking down. I was wondering if this could be because of a bad vacuum motor? Thanks for your time.… read more
Tim Mohr
Tim Mohr
SHOP OWNER
Master's Degree
16,167 satisfied customers
1988 Ford: power booster, replaced abs system and master cylinder
1988 Ford 350 7.3D brakes drifting. I replaced the power booster, replaced ABS system and master cylinder. Stiff drifting no brakes.… read more
Dodge expert
Dodge expert
ASE MASTER TECH, REPAIR FACILITY OWNER
High School or GED
3,636 satisfied customers
1997 Ford: brake pedal..hydrolic assisted boost braking system.
1997 Ford F600 - brake pedal is hard and the truck will not stop. What is wrong with it and how do I fix it? It has a hydrolic assisted boost braking system.… read more
Dieseljunky2
Dieseljunky2
Locomotive Mechanic
Ford Certified Technician
409 satisfied customers
2001 F 350: pads..pedal..I turn the steering wheel and apply brakes it
Have a 2001 F 350 that I changed calipers & pads on Cant seem to get air or whatever to get a good pedal back. When I turn the steering wheel and apply brakes it stops me from turning. Ive tried bleed… read more
ASEMaster35yrs
ASEMaster35yrs
Vocational, Technical or Trade Scho
2,061 satisfied customers
I am working on a 1995 Lincoln Town Car for a friend. We have
I am working on a 1995 Lincoln Town Car for a friend. We have replaced worn pads and rotors and bleed the brakes on all 4 corners. The pedal is still spongy and goes to the floor upon start up. Can be… read more
JOHN aka Eauto
JOHN aka Eauto
self employed
High School or GED
10,838 satisfied customers
Ford F450: 7.3 powerstroke turbo..brake pedal..front brakes
I have a 1997 (made 12/1996) Ford F450 7.3 powerstroke turbo Diesel. The truck is rear wheel drive only with duals on back of course and disc brakes at all four corners. The brake pedal has gotten VER… read more
fordman312009
fordman312009
Associate Degree
404 satisfied customers
E350: super duty..brake pedal..All pads and rotors look fine
I have an 02' E350 super duty diesel dually box truck. The brake pedal goes to the floor then slowly stops the truck. All pads and rotors look fine. Where else should I look to resolve the problem?… read more
Bamaman39
Bamaman39
Ford master diesel Tech.Ford certified
High School or GED
2,286 satisfied customers
1995 ford: abs brakes I..master cylinder ,brake booster..bled..spongy
I have a 1995 ford tauras sho . it has abs brakes I just replaced the master cylinder ,brake booster the problem is that i have plenty of peddle and no brakes i also bled the master cylinder and the p… read more
Shawn
Shawn
Self Employed
Vocational, Technical or Trade Scho
360 satisfied customers
1992 ford: adjust..the master cylinder and to what specs
how do i adjust the pushrod for the master cylinder and to what specs? its a 1992 ford e 350 7.3 diesel cube van with dual wheels… read more
Ray M.
Ray M.
Diesel Technician
Vocational, Technical or Trade School
3,070 satisfied customers
I have a ford e350 6.o diesel when i press the brake to slow
I have a ford e350 6.o diesel when i press the brake to slow down they feel normal as i am getting off the freeway but when i stop at the bottom of the off ramp and have to step on the brake again the… read more
john
john
High School or GED
254 satisfied customers
f350: master cylinder..dually..wheel drive..my pedal is so hard
I put a master cylinder on a ''96 F350 duallyXXXXX 5 speed trans. still not good brakes was told to put a brake booster. I did now my pedal is so hard to push. What could be the problem or could it be… read more
ZZDaryl
ZZDaryl
Lead Auto Tech
Some college and advanced training
11,465 satisfied customers
2000 mercury sable: the brakes..pedal goes..same thing..nothing wrong
I have a 2000 mercury sable when I step on the brakes the pedal goes to the floor. I had the brakes replace and it is still doing the same thing. the car is at the dealer now and thy are saying there … read more
RIP
RIP
Lead Technician
Vocational, Technical or Trade School
469 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

AlvinC answered a question about my Ford truck that only someone with an in-depth knowledge of his subject would have known what was going on.

Rich DUSA

Because of your expertise, you armed me with enough ammunition to win the battle with the dealer. They are installing a fuel filter and fuel pump at no charge to me.

MollyUSA

I needed help with my car on Saturday morning....got a response in 5 minutes, and it was the perfect solution. Thanks again to your service.

Jason V.Kirkland, WA

I do know, after going though this with JustAnswer, that I can somewhat trust my mechanic but I will always contact you prior to going there.

BRNew Jersey

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

< Previous | Next >

Meet the Experts:

Ron

Ron

ASE Certified Technician

25,182 satisfied customers

23 years with Ford specializing in drivability and electrical and AC. Ford certs and ASE Certs

Chris (aka- Moose)

Chris (aka- Moose)

Technician

29,223 satisfied customers

16 years experience

John Mc

John Mc

Ford Technician

5,495 satisfied customers

19 years Ford Lincoln Mercury experience

Chuck

Chuck

ASE Certified Technician

1,685 satisfied customers

33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance

Cam

Cam

Journeyman Automotive Technician

10 satisfied customers

GM Grand Master Technician 2007. 14 years Automotive experience.

Mike V.

Mike V.

Auto Service Technician

1,591 satisfied customers

25 years experience on all makes and models, Licensed NYS Inspector.

Richard

Richard

ASE Certified Technician

1,524 satisfied customers

12 years at a Ford Lincoln/Mercury and Jaguar dealer as a technician and shop foreman.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x