How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Chuck Your Own Question
Chuck
Chuck, ASE Certified Technician
Category: Ford
Satisfied Customers: 2100
Experience:  33 Years Experience,Ford Senior Master,ASE Master,L1 Advanced Engine Performance
17659378
Type Your Ford Question Here...
Chuck is online now
A new question is answered every 9 seconds

how do i access the fan switch on a 2006 ford e 250

Resolved Question:

how do i access the fan switch on a 2006 ford e 250
Submitted: 7 years ago.
Category: Ford
Expert:  Chuck replied 7 years ago.
Are you talking about the blower motor switch?
Customer: replied 7 years ago.
yes
Expert:  Chuck replied 7 years ago.

You have to first remove the instrument cluster finish panel.

 

  1. If equipped with tilt column, position the steering wheel in the full DOWN position.
  2. Pull the headlamp knob to the ON position.
  3. Insert a small screwdriver onto the clip and pull the knob outward

graphic

 

 

 

4. Remove the headlamp switch bezel by turning it counterclockwise

 

graphic

 

5. Remove the audio unit

 

6. Remove the 2 instrument cluster finish panel screws

 

graphic

7. CAUTION: To avoid damage to the instrument cluster finish panel, pull the panel forward just enough to access electrical connectors before completely removing the panel.Remove the instrument cluster finish panel.

  • Disconnect the electrical connectors

graphic

 

 

 

 

 

graphic

 

ItemPart NumberDescription
1-Climate control assembly screw (3 required)
214401Climate control assembly electrical connectors (5 required)
319980Climate control assembly

 

 

 

Removal and Installation

  1. Remove the instrument cluster finish panel.
  2. Remove the 3 climate control assembly screws.
  3. Disconnect the climate control assembly vacuum connector.
  4. Disconnect the 5 climate control assembly electrical connectors.
  5. Remove the climate control assembly.
  6. To install, reverse the removal procedure.

Blower Motor Switch Printable View (85 KB)

 

Removal and Installation

  1. Remove the climate control assembly.
  2. Remove the blower motor switch knob.
  3. Remove the blower motor switch.
    1. Remove the screw.
    2. Remove the blower motor switch

graphic

 

Audio unit removal You will need these tools to remove the audio unit.

Remover, Audio Unit
415-001 (T87P-19061-A)

graphic

 

  • Using the special tool, remove the audio unit.
    • Disconnect the antenna lead-in cable and the electrical connector(s).
  • graphic

     

     

    Chuck and 5 other Ford Specialists are ready to help you