How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Thomas Your Own Question
Thomas, Auto Service Technician
Category: Ford
Satisfied Customers: 364
Experience:  Ford engine , airconditioning, drivabillity and electrical specialist
Type Your Ford Question Here...
Thomas is online now
A new question is answered every 9 seconds

Ford freestar: fuel pump..module..a diagram to follow the wiring

This answer was rated:

i have a ford freestar 2004 fuel pump driver module fuse keeps blowing changed the fuel pump still the same any suggestions or where can i get a diagram to follow the wiring
hello vip, what fuse number is XXXXX and wich fuse box?
Customer: replied 9 years ago.
fuse number 47 15Amps
does it pop as soon as you put one in or while you are driving?
Customer: replied 9 years ago.
as soon as i put it in even if i disconect the fuel pump it still blows
In the right rear of your van access the fuel inertia switch and disconect it and then install a you have a test light or a dvom?
Thomas and 5 other Ford Specialists are ready to help you
Customer: replied 9 years ago.
yes have both i can try that where is the exact location of the inertia switch

Remove the jack access cover on the RH side interior rear quarter trim panel


unplugg it first and then install a fuse .this way we can shorten down the suspected harness short.

Customer: replied 9 years ago.
i will try that thx for the fast response
No problem if it still blows the fuse than pull the fuel pump relay and try another fuse.
Customer: replied 9 years ago.
did disconect inertia switch and did not blow the fuse should i change the switch itself or continu diagnostic
Customer: replied 9 years ago.
did plug inertia switch back and unpluged the driver module of the fuel pump located on the pilar on the driver side fuse did not blow
Customer: replied 9 years ago.
changed the fuel pump module and problem solved thx for your helo
I'm glad i could help. if you need any more assistance let me know.