How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Chris (aka- Moose) Your Own Question
Chris (aka- Moose)
Chris (aka- Moose), Technician
Category: Ford
Satisfied Customers: 47969
Experience:  16 years experience
2499435
Type Your Ford Question Here...
Chris (aka- Moose) is online now
A new question is answered every 9 seconds

Need to replace a slave cylinder on a 93 ford ranger

Resolved Question:

how
Submitted: 10 years ago.
Category: Ford
Expert:  Chris (aka- Moose) replied 10 years ago.

The slave cylinder is located inside the transmission bell housing. So to replace it the transmission will have to removed. After replacing you may need to bleed the clutch hydraulic system.

Now your vehicle may not be a hydraulic clutch system and it would use a cable instead and have no slave cylinder. If you look on the drivers side of the bellhousing if there is a hose going into the side of the trans its hydraulic. If there is a cable and clutch fork, it has no slave. Most all 93 rangers were hydraulic

PLEASE REPLY IF NEEDED

graphic

Chris (aka- Moose) and other Ford Specialists are ready to help you