Ore or 9.3x. Precor 9.3x after variable time -12 to 18

Here is what Precor says about error code 27.Error 27 - Too Much Drive Motor Current
Description
Some treadmill motor controllers monitor the amount of current being delivered to the drive
motor. The software sets a maximum amount of allowable drive motor current. This error
indicates that maximum drive motor current has been reached.
Possible Causes
1. The running belt and/or running bed is badly worn.
2. A shorted or de-magnetized drive motor is causing the high power demand.
Possible Remedies
1. A clamp-on A.C. ammeter must be used to determine the amount of A.C input current being
drawn by the treadmill under no load and loaded conditions. The current readings can be
used to determine the condition of the running belt and/or running bed. These same readings
should be taken on a similar unit with a known good running belt and running bed. Those
readings can then be used as a benchmark for future use. Replace the running belt and/or
running bed as required. Remember, many running beds are double sided and the bed can
be flipped over rather than being replaced.
2. A known good drive motor must be substituted for the existing drive motorHere is what I do.
A treadmill will shut down/slow down from friction which is due to high motor current because the walkbelt and deck are not properly lubricated. Take an amperage reading from the motor and if it is above 10-12 amps steadily I would recommend lubricating the deck, with treadmill lube, first and retest if it still cuts out replace the walking deck and controller because the deck is worn out and it has weakened the controller beyond repair. Apply .5 oz of lubricant on the deck every 3-6 months or 100 hours of use. This will extend your treadmill's life many years.