Exercise Equipment

Exercise equipment repair questions? Ask a technician

Connect one-on-one with {0} who will answer your question

Related Exercise Equipment Questions
I have a Pro Form 755 cs. It's been working fine until
Hello. I have a Pro Form 755 cs. It's been working fine until recently. The choke got hot a started smoking (minimal) but could see smoke. At that same time the treadmill would slow way down while wal… read more
J.T.
J.T.
Technician
2,179 satisfied customers
My nordictrack c200 (older version with Durasoft deck) seems
HI there, My nordictrack c200 (older version with Durasoft deck) seems to work fine at lower speeds, but whenever I push it over 12km/h it goes for a minute or so, and then slows the belt to a stop. I… read more
treadmilltech
treadmilltech
Technician
High School or GED
10,297 satisfied customers
I have a Proform GP5 that I have owned since the early 90's.
Hi - I have a Proform GP5 that I have owned since the early 90's. Last night and this morning I noticed the movement of the belt does not feel smooth. There is a lot of squeaking when I am walking on it, My speed is at 4.3mph and elevation at 2.0-2.5 when I noticed it. Last night, I kept the speed the same, bu gradually increased the elevation to 3.5-4.0 and did a light workout up to 25 minutes. This morning it had the same feeling like I would slip so I discontinued after 11 minutes. My usual workout every other day is 4.3-4.4mph and up to 4.5 on the elevation … read more
treadmilltech
treadmilltech
Technician
High School or GED
10,297 satisfied customers
My Treadmill Xterra 2.25 CHP Power is giving the error code
Hello my Treadmill Xterra 2.25 CHP Power is giving the error code 22 when I either walk or run on it. It can be a speed over 3.0, 3.5 and 4.0 it just stops the belt going and all. I had a motor replac… read more
Russell H.
Russell H.
Computer/Electronics Consultant
Vocational, Technical or Trade Scho
12,924 satisfied customers
My Pro-Form 6.0 GSX started skipping a bit last week and today
My Pro-Form 6.0 GSX started skipping a bit last week and today when you step on the belt it slips considerably and set on 1.0 you literally stop the movement by stepping on it. At 3.0 it's a jerky 1.5… read more
J.T.
J.T.
Technician
2,179 satisfied customers
I am replacing the motor control board in a 995 sel with an
I am replacing the motor control board in a 995 sel with an upgraded MC-2000. Within a short time of turning on the power, the board becomes very hot. I installed one and the treadmill operating norma… read more
treadmilltech
treadmilltech
Technician
High School or GED
10,297 satisfied customers
I have a Proform Model 840, about 4 years old...When I turn
I have a Proform Model 840, about 4 years old...When I turn it on at say 3.0, it starts up just fine but in about 60 seconds the belt slips and the will no longer turn if there is a person standing on… read more
treadmilltech
treadmilltech
Technician
High School or GED
10,297 satisfied customers
We have a Horizon Fitness T-40 approx 10 years old. The belt
We have a Horizon Fitness T-40 approx 10 years old. The belt suddenly stopped moving while my wife was walking. The unit's display still operates ( lights up and accepts input etc.) . The elevation mo… read more
treadmilltech
treadmilltech
Technician
High School or GED
10,297 satisfied customers
My proform 730 cs was made in 2000. It is in great condition
My proform 730 cs was made in 2000. It is in great condition except when I am doing my work-out it will suddenly stop. First all the lights on the console light up, then it stops and all the lights go… read more
treadmilltech
treadmilltech
Technician
High School or GED
10,297 satisfied customers
My Reebok Body Trec II works fine for about 30 seconds and
My Reebok Body Trec II works fine for about 30 seconds and then shuts down from the program. How do you recalibrate?… read more
treadmilltech
treadmilltech
Technician
High School or GED
10,297 satisfied customers
my treadmill is acting like it has a mind of its own. the belt
my treadmill is acting like it has a mind of its own. the belt will move but the speed keeps adjusting on its own from fast to slow to completely stopping also the the speed diagram keeps changing whe… read more
treadmilltech
treadmilltech
Technician
High School or GED
10,297 satisfied customers
I have a Gold Gym 450 treadmill that was purchased in November,
I have a Gold Gym 450 treadmill that was purchased in November, 2008, with an intermittent problem. The treadmill will operate normally when I am walking on it. Then it abruptly stops. If I stand on t… read more
treadmilltech
treadmilltech
Technician
High School or GED
10,297 satisfied customers
I have a Healthstream Gold GS102T Treadmill, Everything works
I have a Healthstream Gold GS102T Treadmill, Everything works fine except the speed pulses. I can be running on 9klms and suddenly the belt will slow down and then speed up again however the screen sp… read more
treadmilltech
treadmilltech
Technician
High School or GED
10,297 satisfied customers
Hi, Ive got a Landice L7 thats 10 years old but used very
Hi, I've got a Landice L7 that's 10 years old but used very little. Whenever used lately, at some point, a vibration will start, the red LED1 on the controller comes on and the belt slows, then it imm… read more
treadmilltech
treadmilltech
Technician
High School or GED
10,297 satisfied customers
Pro Form 12.5 QM. Starts up for 2-3 minutes and then stops,
Pro Form 12.5 QM. Starts up for 2-3 minutes and then stops, console continues to operate. When switched off and restarted exactly the same thing happens. Machine does not seem to respond to speed cont… read more
treadmilltech
treadmilltech
Technician
High School or GED
10,297 satisfied customers
I have a Tunturi T60F which I have not used for about 4 years
I have a Tunturi T60F which I have not used for about 4 years untik recently. I dusted it off and ran it for about 5 mins and it semmed fine. Just after turning it on and upping the speed it has stopp… read more
treadmilltech
treadmilltech
Technician
High School or GED
10,297 satisfied customers
I have a Pro Form Treadmill, 5 series 575XT. It has the slide
I have a Pro Form Treadmill, 5 series 575XT. It has the slide bar to adjust the speed. It also has several preprogrammed training cycles. It has a manual cycle which allows you to select your own spee… read more
treadmilltech
treadmilltech
Technician
High School or GED
10,297 satisfied customers
I have a pro-form XP 800 VF. Over the last 6 months it has
I have a pro-form XP 800 VF. Over the last 6 months it has been acting erratically. At one point while I was walking and I choose to decrease the speed, the whole keyboard would lite up with gobbledee… read more
Craig
Craig
Electrical Director
Electrical Automation Technician
749 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

treadmilltech

treadmilltech

Technician

10,297 satisfied customers

20+ years experience repairing exercise equipment with emphasis on Nordictrack/Proform and Horizon

J.T.

J.T.

Technician

2,179 satisfied customers

I have over 10 years experience in all fields of fitness equipment repair and service.

Neil

Neil

Technician

213 satisfied customers

NZCE Electronics and Computing

Matthew

Matthew

Technician

147 satisfied customers

20+ years in Electronics, Mechanical, Service, Repair, Customer Service, Quality Control, Document Control, and Maintenance w/ 10+ in fitness equipment. All brands/models

Dan

Dan

Master Tech and Repair Facility Trainer

115 satisfied customers

USAF trained; A.A.S Electronics; A.A.S. Education; Currently teaching basic and advanced electronic theory for the DoD.

Carl L

Carl L

Master Technician

88 satisfied customers

20+ Years of Professional Computer / Electronic Repair Experience.

Louie

Louie

Technician

58 satisfied customers

25+ yrs. experience in the field and 5+ yrs. online, down to component level.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x