Firearms Repair

Have Firearms Repair Questions? Ask an Expert

Connect one-on-one with {0} who will answer your question

Related Firearms Repair Questions
I have had and carried a S&W 4516-1 for about 20 years, the
Hello, I have had and carried a S&W 4516-1 for about 20 years, the aberrations on one side became marred up so I found a used replacement slide, they weigh exactly the same but the difference I notice… read more
Tom
Tom
Gunsmith
Law Enforcement Armorer
4,662 satisfied customers
What does it cost? Iam using a bore sight in my ak 47 .When
Iam using a bore sight in my ak 47 .When I look through my iron sights,the red dot is under the front sight.What to do? … read more
Tom
Tom
Gunsmith
Law Enforcement Armorer
4,662 satisfied customers
Have a stevens 311R that I purchased in mint condition. I
Have a stevens 311R that I purchased in mint condition. I fired 12 rounds and action is tight. I fired two rounds from hip, now guns action is locked up tight and I cannot get action to open … read more
Tom
Tom
Gunsmith
Law Enforcement Armorer
4,662 satisfied customers
my crossman guns are 357 caliber 177 co2 air guns, where the
my crossman guns are 357 caliber 177 co2 air guns, where the barrel breaks the unit that holds them together doesnt hold when you close the barrel.… read more
Big River Guns
Big River Guns
Federal Firearms Licensed
18 satisfied customers
my muzzelloader thompson center 50 cal will not shot level
my muzzelloader thompson center 50 cal will not shot level with iron sights. it always shoots high. i cant figure out how it shoots high. and don' t know how to adjust the back sight. It is driving me… read more
Tom
Tom
Gunsmith
Law Enforcement Armorer
4,662 satisfied customers
This is follow up information on my previous question on my
This is follow up information on my previous question on my Mossberg 715T 22LR rifle. I removed all the plastic stuff and checked the levelness of the part over the barrel. It was fine. I carefully re… read more
Big River Guns
Big River Guns
Federal Firearms Licensed
18 satisfied customers
This is for a firearms expert. I have a Mossberg 715T 22LR
This is for a firearms expert. I have a Mossberg 715T 22LR and I have taken the plastic parts off twice for cleaning and have been very careful replacing them. I have been trying to sight the rifle in… read more
Big River Guns
Big River Guns
Federal Firearms Licensed
18 satisfied customers
I very recently purchased a S&W SW9VE for my wife. I fired
I very recently purchased a S&W SW9VE for my wife. I fired it at about 28 to 30ft. and kept a good pattern. She carried in in her glove box for a week and I took her to get firing time in and get fami… read more
Big River Guns
Big River Guns
Federal Firearms Licensed
18 satisfied customers
S&W 9mm model 5904 sem-auto---can the trigger assembly be replaced
S&W 9mm model 5904 sem-auto---can the trigger assembly be replaced or worn parts be replaced due to over travel of trigger to close to frame housing---chubby trigger finger pad prevents firing in S/A … read more
Tom
Tom
Gunsmith
Law Enforcement Armorer
4,662 satisfied customers
I have a Browning BDM 9mm pistol. I cant fire a full magazine
I have a Browning BDM 9mm pistol. I can't fire a full magazine without the trigger failing to reset every time. I have to nudge it forward to fire it again. It does this on every magazine I have. I ha… read more
ProShooter
ProShooter
Firearms Appraiser, Firearms Instructor
Various law enforcement academies
3,013 satisfied customers
i have a 187 N 22 rifle thats jamming , bolt doesnt always
i have a 187 N 22 rifle thats jamming , bolt doesn't always close all the way due to a second round under the bolt is what it looks like to me , once a round is chambered it fires without fail , i hav… read more
Tom
Tom
Gunsmith
Law Enforcement Armorer
4,662 satisfied customers
More of a model question - and probably one that is simple
More of a model question - and probably one that is simple for all of you. Is a Smith & Wesson Model #3 Single action "44 S&W" serial #23710 - also possibly referred to as a 1911-45???… read more
Tom
Tom
Gunsmith
Law Enforcement Armorer
4,662 satisfied customers
I have a Colt Model 1911 "Combat Commander" and the front sight
I have a Colt Model 1911 "Combat Commander" and the front sight has come off. How do I go about getting this repaired? How can I find a reputable gunsmith in my area that can do this work correctly? O… read more
ProShooter
ProShooter
Firearms Appraiser, Firearms Instructor
Various law enforcement academies
3,013 satisfied customers
The slide is locked (but moves about 1/16 inch) about 1/2 way
The slide is locked (but moves about 1/16 inch) about 1/2 way back on the glock # XXXXX and the empty brass is loose and still in the barrel. I think it fired 2 rounds in rapid fire when it stopped. I… read more
ProShooter
ProShooter
Firearms Appraiser, Firearms Instructor
Various law enforcement academies
3,013 satisfied customers
Hi, my kid has an airsoft gun, and he has a few questions,
Hi, my kid has an airsoft gun, and he has a few questions, even though it isn;t exactly a firearm, someone could help me with this-These are his questions- 1. My son owns a JG m16a3 basic airsoft gun … read more
Jon
Jon
Consultant
Vocational, Technical or Trade Scho
34 satisfied customers
I have a Daisey BB gun from the 30s. Its all there except
I have a Daisey BB gun from the '30s. It's all there except the rear sight, which was a tubular affair. Where Can I purchase a replacement or get information I can use to make a replacement?… read more
ProShooter
ProShooter
Firearms Appraiser, Firearms Instructor
Various law enforcement academies
3,013 satisfied customers
I have a 1938 Belgium Browning 9mm (removed from a German in
I have a 1938 Belgium Browning 9mm (removed from a German in WWII). It doesn't want to consistently extract the case. I have loaded 6 different loads (light to medium heavy as per Sierra) and frequent… read more
alfordap
alfordap
CEO/Owner/Head Gunsmith/Film Consultant
Vocational, Technical or Trade School
48 satisfied customers
I just bought a used springfield 1911 night. Someone painted
I just bought a used springfield 1911 night. Someone painted over the night sights. Is there any way to clean this off without ruining them worse than they are?… read more
ProShooter
ProShooter
Firearms Appraiser, Firearms Instructor
Various law enforcement academies
3,013 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

bullsleyer

bullsleyer

Gunsmith, master machinist, tool & die maker, mold maker

15 satisfied customers

I have over 46 years experience in the tool & die/machinist/mold making/gunsmithing field.

Tom

Tom

Gunsmith

4,662 satisfied customers

20 years as a gunsmith, certified Armorer

Jon

Jon

Consultant

34 satisfied customers

Professional Gunsmith, Certified Police Firearms Instructor, Concealed Carry Instructor, Journeyman Machinist and Firearms Enthusiast.

Big River Guns

Big River Guns

Federal Firearms Licensed

18 satisfied customers

Many years in firearm repair, troubleshooting, and upgrades. I am federally licensed and am ready for your questions.

Ellen

Ellen

Consultant

109 satisfied customers

attorney and legal researcher

P. Simmons

P. Simmons

Attorney

156 satisfied customers

45 years old, retired Marine Officer, current attorney

Kim D.

Kim D.

Consultant

34 satisfied customers

Researcher 25 yrs in small and large institutions

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x