Engineering
Connect one-on-one with an engineer who will answer your question
Expert avatar
Matt, Engineer
78 satisfied customers
Mechanical Engineering Hons degree, been working in automotive industry for the last 18 years - Engine development engineer
Pearl avatar
Pearl Wilson, Assistant
Engineers are Online Now

Engineering questions? Ask an engineer online.

Verified engineers are online around the clock and ready to answer your question online or by phone. 
Related Engineering questions
Does annealing copper change it's density. I am trying to
Does annealing copper change it's density. I am trying to determine if 1cu.ft of copper would be permanently larger than 1cu.ft after annealing.… read more
William Purpura
William Purpura
Managing General Partner
MBA & MSME
52 satisfied customers
I recently purchased a condominium in western NC mountains,
I recently purchased a condominium in western NC mountains, built 2003. It is on ground level ( mid-level) of 3 story building, with extensive 1-2 story foundation. I need to make structural accessibi… read more
PaulP324
PaulP324
consulting engineer
MS
17 satisfied customers
I'm working on some starting rough specs for a torsion
I'm working on some starting rough specs for a torsion engine. So far I've tracked down that I should use a tubular torsion model but I'm stuck on trying to find a modulus of stiffness for paracord. E… read more
William Purpura
William Purpura
Managing General Partner
MBA & MSME
52 satisfied customers
I'm trying to design a torsion engine and I'm full of bad
I'm trying to design a torsion engine and I'm full of bad ideas. I'm wondering if weaving the ropes so that they all have roughly equal paths through the ID and OD of the bundle will allow me to harne… read more
William Purpura
William Purpura
Managing General Partner
MBA & MSME
52 satisfied customers
I was looking for a category under Contractor and this is as
Hello I was looking for a category under Contractor and this is as close as I could find but I had my exterior of my house looked over and it's exposed to the elements since it's coastal and anyhow I … read more
walkereng
walkereng
Bachelor's Degree
Bachelor's Degree
226 satisfied customers
Is phosphoric acid a safe option for eliminating rust from
Is phosphoric acid a safe option for eliminating rust from intricate cooling water jackets of cast iron?… read more
William Purpura
William Purpura
Managing General Partner
MBA & MSME
52 satisfied customers
I'm planning to remove a load bearing wall and have put
Hello! I'm planning to remove a load bearing wall and have put together a basic structural plan. Would you be able take a look at it and let me know if it looks satisfactory for the purposes of reques… read more
walkereng
walkereng
Bachelor's Degree
Bachelor's Degree
226 satisfied customers
Only. Regarding IRC 2015 and exterior stairs, a clause was
This question is forCustomeronly. Good Afternoon. Regarding IRC 2015 and exterior stairs, a clause was brought to my attention. The level of thoroughness required for my issues are incredible, and you… read more
walkereng
walkereng
Bachelor's Degree
Bachelor's Degree
226 satisfied customers
I am about to request assistance from the state for building
Good Afternoon. I am about to request assistance from the state for building code inspection (rural area), and was curious about a potential issue. International Residential Code (2015) is the prevail… read more
walkereng
walkereng
Bachelor's Degree
Bachelor's Degree
226 satisfied customers
Can someone tell me what may have happened in this picture?
second opinion] Can someone tell me what may have happened in this picture? This is a pipe in my storage unit, and now I have white dust on my belongings inside. Could this white dust be harmful to me… read more
Matt
Matt
Engineer
Bachelor's Degree
78 satisfied customers
I am, among other things, a trained and experienced chemist.
I am, among other things, a trained and experienced chemist. but i have not previously used vacuum distillation. Some flasks etc are labeled thick wall and some are not. Is it dangerous to use my regu… read more
Ben
Ben
18 satisfied customers
I believe I'm all set! Here's a question. Can a condominium
I believe I'm all set! Here's a strange follow up question. Can a condominium association refuse access to a building code officer due to private property? This will likely be the strategy of the Condo Association. It's OK to close the question and Thank You! … read more
walkereng
walkereng
Bachelor's Degree
Bachelor's Degree
226 satisfied customers
I have a client that has torn down a deck that is 43 feet
I have a client that has torn down a deck that is 43 feet wide and 7 feet out from the house. I've only seen pictures of what they tore down. My question is can you spin 43 feet with a glue Lam been t… read more
PaulP324
PaulP324
consulting engineer
MS
17 satisfied customers
Civil Engineering. Why do they use concrete blocks to up,
Civil Engineering. Why do they use concrete blocks to Jack up, align and support the foundation of houses with crawl space and why NOT use wood instead?See picture of the foundation of a house that wa… read more
walkereng
walkereng
Bachelor's Degree
Bachelor's Degree
226 satisfied customers
CALIFORNIA - SACRAMENTO COUNTY building code knowledgeable
CALIFORNIA - SACRAMENTO COUNTY building code knowledgeable Uses Chief Architect software.Help needed1) Answer Home Designer software usage questions. 2) Review and update plans and drawings for permit… read more
walkereng
walkereng
Bachelor's Degree
Bachelor's Degree
226 satisfied customers
I am looking to install a 3" ABS waste line thought 2x10"
I am looking to install a 3" ABS waste line thought 2x10" actual size 1-2/4x 9" second story floor joist, I was told an engineer may have a solution. … read more
walkereng
walkereng
Bachelor's Degree
Bachelor's Degree
226 satisfied customers
From Italy. I'm looking for the internal design of a
Customer: hi, I'm Mirco, from Italy. I'm looking for the internal design of a karabiner. I would like to reproduce it in silver, but I do not know how to place the spring inside. It has nothing to do … read more
Expert
Expert
I need a engineer to talk with me. I want to discover what
Hey guys, I need a engineer to talk with me. I want to discover what type of engineering is best for me.… read more
Erwin Garcia
Erwin Garcia
Master of Science
2,546 satisfied customers

Common engineering questions resolved on JustAnswer


These Experts answer a huge variety of engineering questions, such as:


  • I am building a 3m long model submarine and need information on how I can communicate/control the sub in salt water.
  • I’m building a raised concrete deck. I need help sizing the posts and the beams.
  • I am suspending a 100-pound dehumidifier from the joists in the furnace/mechanical room in my house. As the manufacturer recommends flat bar supports, what type of steel should I use (1018, 1144, 4130, or other), and how thick?
  • Does a stud wall that has nothing resting on top have any load bearing attributes?
  • We may need to retrofit our townhome in Los Angeles for earthquake, and the first step is to have an engineering study done. What is the right amount to pay for this study?

When preparing to consult with an Engineering Expert, be sure to have all the relevant weights and measurements on hand. The Expert will also need to know if you’re working on the project yourself or using a contractor. The more information you can provide, the more efficient the engineering consultation will be.