How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Pete Your Own Question
Pete, Electronic Engineer
Category: Consumer Electronics
Satisfied Customers: 17681
Experience:  Over 16 years of experience installing and repairing electronics.
Type Your Consumer Electronics Question Here...
Pete is online now
A new question is answered every 9 seconds

I am having teething troubles with a newly installed

Customer Question

I am having teething troubles with a newly installed monombloc syste, caused by iarlocks. I want to check that the water pressure is high enough and if necessary increase it
JA: What's the make/model of your device? How old is it?
Customer: WH-MDC09G3ES OR WH-MDC06G3E5
JA: How long has this been going on? What troubleshooting have you tried?
Customer: About a week. The floor heating pipes are set out in two concentric coils, and in normal operation (the system was supplied by another now defunct heat pump) the supply and return were very similar in temperature. This is not now the case. I think a check on water pressure would help (the smaller the bubbles in the airlock the easier they will be to clear.
JA: Anything else you want the electronics expert to know before I connect you?
Customer: Don't think so.
Submitted: 10 months ago.
Category: Consumer Electronics
Expert:  Pete replied 10 months ago.

Hi, I'm Pete. Welcome to JustAnswer! I'm reviewing your question now, and will post back with your reply ASAP.

Expert:  Pete replied 10 months ago.

The maximum water pressure through the monoblock system is around 300kPa.

You can check the pressure on the built-in gauge.

If it is below 300kPa try increasing it and check if the air bubbles get smaller.

Your satisfaction is my priority;
Kindly take a moment to rate my service 5 stars at the top of your question page so I am rewarded for my time; tips appreciated :)
You can always reply back at any time if you need any further assistance at all.

Related Consumer Electronics Questions