Electronics Repair Questions? Ask an Electronics Technician
To clear this error, unplug the unit from AC power for 15 minutes and then upon powering on, press the ENTER + VIDEO2 buttons on the front panel of the unit for 2 seconds. Let me know if this works.
sorry for the late response. I've tried this but its not working. Also there is no VIDEO2 only VIDEO ?
Okay, sorry about that it was for another model Pioneer. Here is the reset method for your receiver via Pioneer:
Resetting the system
Use this procedure to reset all the receiver's settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the front panel TONE button,
press and hold STANDBY/ON for about three seconds.
The display shows
3 Press the front panel ENTER button.
4 Press SYSTEM SETUP to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
If this does not work, then the unit ha s a power supply failure and is in need of service.
If you need further assistance let me know.
It's working YAY!! thanks for your help!