Electronic Musical Instruments

Electronic musical instrument questions? Ask a technician ASAP

Connect one-on-one with {0} who will answer your question

Related Electronic Musical Instruments Questions
Hammond Elegante. When the instrument is turned on, the
Hammond Elegante. When the instrument is turned on, the Leslie should spin at full speed. When the CHORALE is selected, the rotating speaker is slowed. My issue is that 'sometimes' the chorale does not release--when that happens, the rotating speaker stops altogether. This seems to happen when either the foot switch or leslie chorale tab is used. I've oiled the chorale brake and cleaned the rubber roller with alcohol. It seems to help and it works correctly MOST of the time. Just when I think it's going to keep working--it fails! I'm reluctant to put the back onto the instrument for fear it will stop working as intended. Is there something that has weakened that should be pulling (dropping) the brake [chorale motor shaft] away from the chorale wheel? I would love to have information to tell a service person if needed. We have very few services listed for our area so any help I can give them would be appreciated. Thanks in advance. The owners guide says 'Model 340100'. … read more
Ron Winston
Ron Winston
2,153 satisfied customers
I have an old Kurzweil Mark 10. There was a broken key which
I have an old Kurzweil Mark 10. There was a broken key which I replaced. Sine then the keyboard doesn't produce any sound. I did a reset but it doesn't help. All the tests worked well. I tried to play… read more
Ron Winston
Ron Winston
2,153 satisfied customers
I have a Yamaha psr 2100 and disassembled the unit trying to
I have a Yamaha psr 2100 and disassembled the unit trying to get at a possible reason for a buzz caused by the mic/line female connection I accidentily pulled the ribbon cables out of their terminatio… read more
Ron Winston
Ron Winston
2,153 satisfied customers
We recently acquired an T12A from a church. It had been
We recently acquired an Allen T12A from a church. It had been sitting for two years and the seller said it worked when they put it up when their new organ arrived. Got it home and it had no sound, but… read more
Ron Winston
Ron Winston
2,153 satisfied customers
I have a lowery M-150 that has nit been touched in several
I have a lowery M-150 that has nit been touched in several years. I tried to turn it on and it will not turn on. Any recommendations? … read more
Ron Winston
Ron Winston
2,153 satisfied customers
It won't play when plugged in. Actually it cut off while the
It won't play when plugged in. Actually it cut off while the pianist was playing Sunday. It's a Yamaha Clavinova … read more
Ron Winston
Ron Winston
2,153 satisfied customers
I have an old Hammond organ, about 50=-60 years old. It has
I have an old Hammond organ, about 50=-60 years old. It has not been played in the past 30 years. It now does not play at all. When I turn it on, the light goes on but no keys give any sound. it has n… read more
Ron Winston
Ron Winston
2,153 satisfied customers
Knox Presbyterian Church has a Soundcraft PCS 275 power
John Knox Presbyterian Church has a Soundcraft PCS 275 power supply in their Sound System, which failed recently. A 10 amp fuse (F2) was blown. I checked the 10,000 mf 35 volt capacitors looked OK and… read more
Ron Winston
Ron Winston
2,153 satisfied customers
I have a B3 & Leslie 122RV with no sound I have a tube
i have a B3 & Leslie 122RV with no sound I have a tube tester and have tested all tubes in both all light up Tone Generator spins up and both top and bottom horns spin fast but not slow the organ has … read more
Ron Winston
Ron Winston
2,153 satisfied customers
I have a pair of behringer b115d's and the power & clip light
I have a pair of behringer b115d's and the power & clip lights on one of them tends to pulse when switched on and hence no sound. Could this be down to a bad semiconductor on the audio output stage as… read more
Rusty
Rusty
Music Professional
Business
1,311 satisfied customers
My Roland Fantom X-7 hums when it is plugged into an amp.
My Roland Fantom X-7 hums when it is plugged into an amp. Outputs 1-2-3-4 but not when jut headphones are used. What can it be /… read more
Rusty
Rusty
Music Professional
Business
1,311 satisfied customers
I have a Roland KC 500 Keyboard amp. The tweeter is making
I have a Roland KC 500 Keyboard amp. The tweeter is making a piercing sizzling sound, which is strongest at a certain frequency but still exists to a lesser degree in the surrounding frequencies. I ca… read more
Rusty
Rusty
Music Professional
Business
1,311 satisfied customers
I have power to my Mackie 1012 mixer and through the on switch
I have power to my Mackie 1012 mixer and through the on switch but mixer does not come on, what could that problem be… read more
Aric
Aric
Electronic Musical Instrument Technician
Run A/V and repair business for over
197 satisfied customers
Hello! Had a great Canada party Monday. I think I may have
Hello! Had a great Canada party Monday. I think I may have clipped the speakers and they went into hiding. Is there a fuse or a safety on them? There is clear crisp sound coming from the horns but not… read more
Rusty
Rusty
Music Professional
Business
1,311 satisfied customers
Im getting a buzz/hum from my amp. It is 100% quiet when
I'm getting a buzz/hum from my amp. It is 100% quiet when the master and the the channels are turned up all the way and nothing plugged into any of the channels. When a line is plugged in it gets a hu… read more
Aric
Aric
Electronic Musical Instrument Technician
Run A/V and repair business for over
197 satisfied customers
I have aTechnics Keyboard AX-7 Synthesizer.Problem is
Hi, I have aTechnics Keyboard AX-7 Synthesizer.Problem is drone.It's look like very low noise sound.All other function on Display it's ok and also all button function on the command.I was change allre… read more
Anthony F.
Anthony F.
Owner
High School or GED
11 satisfied customers
I have model #200/ studio200 audio effect digital delay. It
I have model #200/ studio200 audio effect digital delay. It is about 10 years old but worked fine until last summer. I think a thunder storm did it in because it does not have a power switch, it was a… read more
Rusty
Rusty
Music Professional
Business
1,311 satisfied customers
We have four Alesis 3630 Compressor I was looking for the manual.
We have four Alesis 3630 Compressor I was looking for the manual. Which is the most effective chain link connection that will make the sound sound good with no distortions. This is the way we have it … read more
Rusty
Rusty
Music Professional
Business
1,311 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Steve G.

Steve G.

Engineer

87 satisfied customers

I have played electronic keyboards for 40 years.

Ron Winston

Ron Winston

2,153 satisfied customers

Owner at Winston Electronics

Rusty

Rusty

Music Professional

1,311 satisfied customers

Sound Engineer, Electrical Issues, Tone Consulting

Aric

Aric

Electronic Musical Instrument Technician

197 satisfied customers

15+ years in the field. Owner of AV Installation, OEM and Repair company

Carl L

Carl L

Master Technician

163 satisfied customers

Current Electronics Shop Owner and Master Technician in FL.

Lorenz Vauck

Lorenz Vauck

Mastering Engineer

41 satisfied customers

Audio mastering engineer, experienced with recording, mixing, mastering, instruments and vst plugins. Just ask me:)

momentouswater

momentouswater

Technician

14 satisfied customers

Ready to assist with any and all Electric Instruments

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x