How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask sprinkles08 Your Own Question
sprinkles08, Chrysler/Dodge/Jeep master tech
Category: Dodge
Satisfied Customers: 22985
Experience:  ASE Master and Advanced Certified, Chrysler/Dodge/Jeep Master Certified, Trans and Hybrid Specialist
Type Your Dodge Question Here...
sprinkles08 is online now
A new question is answered every 9 seconds

Rats ate some wire now I repaired the ones I found fault

Customer Question

Rats ate some wire now I repaired the ones I found fault comes on say service electronic throttle control and looses power
JA: What is the model/year of your Dodge?
Customer: 2015 3500 with Cummings
JA: Are you fixing your 3500 yourself? What have you tried so far?
Customer: Yes I repaired 4 wire on passenger side fender by battery and resources hose
JA: Have you tested the battery with a voltmeter? And can you see if it's leaking or not?
Customer: Resovoir
JA: Anything else you want the mechanic to know before I connect you?
Customer: Got two batteries 12.4 volts
Submitted: 1 year ago.
Category: Dodge
Expert:  Wayne Crawford replied 1 year ago.

Hello. My name is ***** ***** I will be helping you today.

Have you checked the codes yet? It may point you towards the wire or wires in question.

Customer: replied 1 year ago.
Po6d3 3 of these and 4 PO935
Customer: replied 1 year ago.
The wire that I repaired were by passenger battery where radiator hose comes through
Customer: replied 1 year ago.
Customer: replied 1 year ago.
My name is Mike
Expert:  Wayne Crawford replied 1 year ago.

Alright. Nice to meet you Mike. Give me a moment while I pull your truck up and look over some diagrams.

Customer: replied 1 year ago.
Expert:  Wayne Crawford replied 1 year ago.

Where are you getting those codes? Im not showing either one of them as valid codes on this particular truck.

Customer: replied 1 year ago.
From the under dash from Bosch live data plus
Customer: replied 1 year ago.
Expert:  Wayne Crawford replied 1 year ago.

I guess I am going to opt out. It could be something in my software. Possibly someone else can help with it.

Customer: replied 1 year ago.
what do I do they just took 38.00
Expert:  Wayne Crawford replied 1 year ago.

Yeah its coming up blank on that one too. Those should all be valid codes so Im guessing maybe an issue with the database... sometimes they do updates on weekends. Hopefully someone else will have something on it.

Expert:  Wayne Crawford replied 1 year ago.

Just hang tight. Another expert will pick it up.

Expert:  sprinkles08 replied 1 year ago.

Hello and welcome to JustAnswer!

P06D3 sets when the reference voltage circuit gets pulled low by a short to ground. P0934 sets when the transmission line pressure sensor signal is low. These codes are both setting because of a short to ground in the wiring or an internally shorted sensor.

Were the codes cleared after the wiring was repaired and these came back?