How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask sprinkles08 Your Own Question
sprinkles08
sprinkles08, Chrysler/Dodge/Jeep master tech
Category: Dodge
Satisfied Customers: 22805
Experience:  ASE Master and Advanced Certified, Chrysler/Dodge/Jeep Master Certified, Trans and Hybrid Specialist
9825021
Type Your Dodge Question Here...
sprinkles08 is online now
A new question is answered every 9 seconds

I have 2004 dodge sprinter 250000 miles it has two codes gh

Customer Question

I have 2004 dodge sprinter 250000 miles it has two codes high and low fuel rail. Changed fuel filter and checked for water none. It started trouble like a miss in agas job
JA: How many miles are on the car? How has your mileage been lately?
Customer: It van and its been good on fuel ....250000 miles
JA: Are you hoping to fix this yourself? What have you tried so far?
Customer: Tired nothing. Where should I start
JA: Anything else you think the mechanic should know?
Customer: If it started or when , when you rev_ur motor has nouse
JA: OK. Got it. I'm sending you to a secure page on JustAnswer so you can place the $5 fully-refundable deposit now. While you're filling out that form, I'll tell the Mercedes Mechanic about your situation and then connect you two.
Submitted: 1 year ago.
Category: Dodge
Expert:  sprinkles08 replied 1 year ago.

Hello and welcome to JustAnswer!

It sounds as if you're setting high and low signal voltage codes for the fuel rail pressure sensor, which would either be the sensor itself or a wiring issue. This would cause the engine to go into limp in but wouldn't cause a misfire. You may have more than one issue going on, especially if you're hearing abnormal engine noise. The noise could be combustion noise from high rail pressure though.

Do you have the P code numbers?